Publisher : The Korean Society of Mechanical Engineers
DOI : 10.3795/KSME-A.2016.40.2.237
Title & Authors
Study on the Linear Static Structural Analysis Error of Helical Compression Springs Jang, Sang Chan; Kang, Jung Ho;
Helical compression springs have been widely used in industries. The springs should be verified through experiment whether the inherent characteristics of the spring can be maintained during the manufacturing process. Considerable time and expense is spent in the manufacturing process. Therefore, in this study, the structural integrity evaluation of a spring was conducted using linear static structural analysis. Verification and comparison of the experimental data were carried out using a variety of international industrial standards with the intent to prove the validity of this study. The spring model did not consider coil ends. As a result of conducting the structural analysis, the quality of the mesh was improved and the time needed to create an analytical model was reduced. The study indicated that Poisson`s ratio had little influence on the result of the structural analysis. Additionally, the possibility of verifying the structural integrity evaluation by structural analysis was confirmed.
Chu, S.-I., Kim, J.-H. and Moon, S.-W., 2006, "Analysis And Experiment for Mechanical Characterization of Micro-spring with Small Area," Proceeding of KSME Spring Symposium, pp. 11-16.
Kim, K.-H., Lee, Y.-S. and Han, J.-D., 2014, " Stress Analysis of Plate-Spring-Type Landing Gear Materials," Trans. Korean Soc. Mech. Eng. A, Vol. 38, No. 3, pp. 303-308.
Oh, S.H. and Choi, B.L., 2014, "Prediction of Spring Rate and Initial Failure Load due to Material Properties of Composite Leaf Spring," Trans. Korean Soc. Mech. Eng. A, Vol. 38, No. 12, pp. 1345-1350.
Oh, S.H. and Choi, B.L., 2014, "Analytical and Experimental Study for Development of Composite Coil Springs," Trans. Korean Soc. Mech. Eng. A, Vol. 38, No. 1, pp. 31-36.
Choi, W.Y., Suh, Y.K. and Kang, S.M., 2015, "Numerical Model of Propulsive Behavior of a Rotating Spring in Viscous Fluid," Trans. Korean Soc. Mech. Eng. B, Vol. 39, No. 6, pp. 497-504.
Kim, Y.S., Kim, S.-S., Cha, K.-U. and Noh, M.G., 2011, "Study on Designing Recoil System with Friction Springs," Trans. Korean Soc. Mech. Eng. A, Vol. 35, No. 4, pp. 367-374.
Kwon, T.H., Suh, C.H., Lee, R.G., Oh, S.K., Jung, Y.-C. and Lim, H.B., 2013, "Optimization of Design Parameters for Lock-Claws of Pneumatic Fitting Using Taguchi Method," Trans. Korean Soc. Mech. Eng. A, Vol. 37, No. 12, pp. 1541-1546.
Yang, Y.-G., Han, G.-B. and Kim, C.-W., 2011, "Relationship Between Restoring Force and Typical Stroke with SMA Coil Spring in Electrosurgical Knee Wand," Trans. Korean Soc. Mech. Eng. B, Vol. 35, No. 12, pp. 1301-1307.
Japanese Industrial Standard, 2010, JIS B 2704-1 : 2009 Coil springs-Part 1: Basic calculation methods on helical compression and extension springs, First English Edition.
Japanese Automobile Standard, 1997, JASO C 605- 97 Coil springs for automobile suspension, Third Edition.