Imposed Weighting Factor Optimization Method for Torque Ripple Reduction of IM Fed by Indirect Matrix Converter with Predictive Control Algorithm

- Journal title : Journal of Electrical Engineering and Technology
- Volume 10, Issue 1, 2015, pp.227-242
- Publisher : The Korean Institute of Electrical Engineers
- DOI : 10.5370/JEET.2015.10.1.227

Title & Authors

Imposed Weighting Factor Optimization Method for Torque Ripple Reduction of IM Fed by Indirect Matrix Converter with Predictive Control Algorithm

Uddin, Muslem; Mekhilef, Saad; Rivera, Marco; Rodriguez, Jose;

Uddin, Muslem; Mekhilef, Saad; Rivera, Marco; Rodriguez, Jose;

Abstract

This paper proposes a weighting factor optimization method in predictive control algorithm for torque ripple reduction in an induction motor fed by an indirect matrix converter (IMC). In this paper, the torque ripple behavior is analyzed to validate the proposed weighting factor optimization method in the predictive control platform and shows the effectiveness of the system. Therefore, an optimization method is adopted here to calculate the optimum weighting factor corresponds to minimum torque ripple and is compared with the results of conventional weighting factor based predictive control algorithm. The predictive control algorithm selects the optimum switching state that minimizes a cost function based on optimized weighting factor to actuate the indirect matrix converter. The conventional and introduced weighting factor optimization method in predictive control algorithm are validated through simulations and experimental validation in DS1104 R&D controller platform and show the potential control, tracking of variables with their respective references and consequently reduces the torque ripple.

Keywords

AC-AC power conversion;Induction motor;Matrix converter;Predictive control;Weighting factor;

Language

English

Cited by

1.

2.

3.

4.

5.

6.

7.

References

1.

G. S. Buja and M. P. Kazmierkowski, “Direct torque control of PWM inverter-fed AC motors-a survey,” IEEE Transactions Industrial Electronics, vol. 51, pp.744-757, 2004.

2.

M. Rivera, “Predictive control in an Indirect Matrix converter,” Universidad Técnica Federico Santa María, Valparaiso, Chile, 2011.

3.

J. Beerten, J. Verveckken, and J. Driesen, “Predictive direct torque control for flux and torque ripple reduction,” IEEE Transactions on Industrial Electronics, vol. 57, pp. 404-412, 2010.

4.

P. W. Wheeler, J. Rodriguez, J. C. Clare, L. Empringham, and A. Weinstein, “Matrix converters: a technology review,” IEEE Trans. Ind. Elec., vol. 49, pp. 276-288, 2002.

5.

J. W. Kolar, F. Schafmeister, S. D. Round, and H. Ertl, “Novel three-phase AC-AC sparse matrix converters,” IEEE Transactions on Power Electronics, vol. 22, pp. 1649-1661, 2007.

6.

P. W. Wheeler, J. C. Clare, L. Empringharn, M. Bland, and M. Apap, “Gate drive level intelligence and current sensing for matrix converter current commutation,” IEEE Transactions on Industrial Electronics, vol. 49, pp. 382-389, 2002.

7.

K.-B. Lee and F. Blaabjerg, “Sensorless DTC-SVM for induction motor driven by a matrix converter using a parameter estimation strategy,” IEEE Trans. Ind. Elec., vol. 55, pp. 512-521, 2008.

8.

S. Mekhilef and M. A. Kadir, “Novel vector control method for three-stage hybrid cascaded multilevel inverter,” IEEE Transactions on Industrial Electronics, vol. 58, pp. 1339-1349, 2011.

9.

S. Mekhilef and A. Kadir, “Voltage control of threestage hybrid multilevel inverter using vector transformation,” IEEE Trans. Power Elec., vol. 25, pp. 2599-2606, 2010.

10.

K. Menshawi, M. Abdulkader, and S. Mekhilef, “Voltage vector approximation control of multistage multilevel inverter using simplified logic implementation,” in Proc. IEEE Ninth International Conf. on Power Elec. and Drive Systems (PEDS), 2011, pp. 57-65.

11.

S. Mekhilef, M. AbdulKadir, and Z. Salam, “Digital Control of Three Phase Three-Stage Hybrid Multilevel Inverter,” IEEE Transactions on Industrial Informatics, vol. 9, pp. 719-727, 2013.

12.

A. Ajami, M. R. J. Oskuee, A. Mokhberdoran, and M. T. Khosroshahi, “Advanced Cascade Multilevel Converter with Reduction in Number of Components,” Journal of Electrical Engineering & Technology, vol. 9, pp. 127-135, 2014.

13.

A. M. Omar, N. A. Rahim, and S. Mekhilef, “Three phasesynchronous PWM for flyback converter with power-factor correction using FPGA ASIC design,” IEEE Trans. Ind. Elec., vol. 51, pp. 96-106, 2004.

14.

S. Mekhilef, N. Rahim, and A. Omar, “Modelling of three-phase uniform symmetrical sampling digital PWM for power converter,” in Proc. IEEE 35th Annual Power Electronics Specialists Conf., 2004, pp. 3499-3503.

15.

S. Muslem Uddin, P. Akter, S. Mekhilef, M. Mubin, M. Rivera, and J. Rodriguez, “Model predictive control of an active front end rectifier with unity displacement factor,” in Proc. IEEE International Conference on Circuits and Systems (ICCAS) Kuala Lumpur, Malaysia, 2013, pp. 81-85.

16.

M. Parvez, S. Mekhilef, N. M. Tan, and H. Akagi, “Model predictive control of a bidirectional AC-DC converter for V2G and G2V applications in electric vehicle battery charger,” in IEEE Transportation Electrification Conference and Expo (ITEC), 2014, pp. 1-6.

17.

J.Rodriguez, J.Pontt, C.A. Silva, P.Correa, P.Lezana, P. Cortés, and U. Ammann, “Predictive current control of a voltage source inverter,” IEEE Transactions on Industrial Electronics, vol. 54, pp. 495-503, 2007.

18.

M. Rivera, J. Rodriguez, B. Wu, J. R. Espinoza, and C. A. Rojas, “ Current control for an indirect matrix converter with filter resonance mitigation,” IEEE Transactions on Industrial Electronics, vol. 59, pp. 71-79, 2012.

19.

V. Yaramasu and B. Wu, “Predictive control of three level boost converter and NPC inverter for high power PMSG-based medium voltage wind energy conversion systems,” IEEE Transactions on Power Electronics, vol. 29, pp. 5308 - 5322, 2014.

20.

H.-W. Sim, J.-S. Lee, and K.-B. Lee, “On-line Parameter Estimation of Interior Permanent Magnet Synchronous Motor using an Extended Kalman Filter,” Journal of Electrical Engineering & Technology, vol. 9, pp. 600-608, 2014.

21.

P. Correa, J. Rodríguez, M. Rivera, J. R. Espinoza, and J. W. Kolar, “Predictive control of an indirect matrix converter,” IEEE Transactions on Industrial Electronics, vol. 56, pp. 1847-1853, 2009.

22.

J. Rodriguez, J. Kolar, J. Espinoza, M. Rivera, and C. Rojas, “Predictive current control with reactive power minimization in an indirect matrix converter,” in Proc. IEEE International Conf. on Ind. Tech (ICIT), 2010, pp. 1839-1844.

23.

S. Muslem Uddin, S. Mekhilef, M. Rivera, and J. Rodriguez, “A FCS-MPC of an induction motor fed by indirect matrix converter with unity power factor control,” in Proc. 8th IEEE Conference on Industrial Electronics and Applications (ICIEA) Melbourne, Australia, 2013, pp. 1769-1774.

24.

M. Rivera, J. Rodriguez, J. R. Espinoza, T. Friedli, J. W. Kolar, A. Wilson, and C. A. Rojas, “Imposed sinusoidal source and load currents for an indirect matrix converter,” IEEE Transactions on Industrial Electronics, vol. 59, pp. 3427-3435, 2012.

25.

V. Yaramasu and B. Wu, “A Model Predictive Decoupled Active and Reactive Power Control for High Power Grid-Connected Four-Level Diode-Clamped Inverters,” IEEE Transactions on Industrial Electronics, vol. 61, pp. 3407-3416, 2014.

26.

J. Rodriguez, J. Pontt, P. Correa, P. Lezana, and P. Cortes, “Predictive power control of an AC/DC/AC converter,” in Proc. Fourtieth IAS Annual Meeting Conference Record of Industry Applications 2005, pp. 934-939.

27.

P.Cortés and J.Rodríguez, “Three-phase inverter with output LC filter using predictive control for UPS applications,” in Proc. European Conference on Power Electronics and Applications 2007, pp. 1-7.

28.

P. Cortés, J. Rodríguez, D. E. Quevedo, and C. Silva, “Predictive current control strategy with imposed load current spectrum,” IEEE Transactions on Power Electronics, vol. 23, pp. 612-618, 2008.

29.

R. Vargas, P. Cortes, U. Ammann, J. Rodríguez, and J. Pontt, “Predictive control of a three-phase neutral point-clamped inverter,” IEEE Transactions on Industrial Electronics, vol. 54, pp. 2697-2705, 2007.

30.

R. Vargas, U. Ammann, J. Rodríguez, and J. Pontt, “Predictive strategy to reduce common-mode voltages on power converters,” in Proc. IEEE Power Electronics Specialists Conference, 2008, pp. 3401-3406.

31.

P. Cortes, S. Kouro, B. La Rocca, R. Vargas, J. Rodriguez, J.I. Leon, S. Vazquez, and L.G. Franquelo, “Guidelines for weighting factors design in model predictive control of power converters and drives,” in Proc. IEEE International Conference on Industrial Technology, ICIT, Gippsland, VIC, 2009, pp. 1-7.

32.

S. A. Davari, D. A. Khaburi, and R. Kennel, “An Improved FCS – MPC Algorithm for an Induction Motor With an Imposed Optimized Weighting Factor,” IEEE Transactions on Power Electronics, vol. 27, pp. 1540-1551, 2012.

33.

M. Uddin, S. Mekhilef, M. Rivera, and J. Rodriguez, “ Predictive indirect matrix converter fed torque rippl eminimization with weighting factor optimization,” in International Power Electronics Conference (IPEC-Hiroshima2014-ECCE-ASIA), 2014, pp. 3574-3581.

34.

M. Uddin, S. Mekhilef, M. Mubin, M. Rivera, and J. Rodriguez, “Model Predictive Torque Ripple Reduction with Weighting Factor Optimization Fed by an Indirect Matrix Converter,” Electric Power Components and Systems, vol. 42, pp. 1-11, 2014.

35.

S. A. Davari, D. A. Khaburi, and R. Kennel, “Using a weighting factor table for FCS-MPC of induction motors with extended prediction horizon,” in Proc. IEEE 38th Annual Conference on Industrial Electronics Society, 2012, pp. 2086-2091.

36.

C. Rojas, J. Rodriguez, F. Villarroel, J. Espinoza, C. Silva, and M. Trincado, “Predictive Torque and Flux Control Without Weighting Factors,” IEEE Transactions on Industrial Electronics, vol. 60, pp. 681-690, 2013.

37.

Z. Boulghasoul, L. El Bahir, A. Elbacha, and E. Elwarraki, “Adaptive-Predictive Controller based on Continuous-Time Poisson-Laguerre Models for Induction Motor Speed Control Improvement,” Journal of Electrical Engineering & Technology, vol. 9, pp. 908-925, 2014.

38.

P.-W. Han, “The Study of the Stray Load Loss and Mechanical Loss of Three Phase Induction Motor considering Experimental Results,” Journal of Electrical Engineering & Technology, vol. 9, pp. 121-126, 2014.

39.

J. Rodriguez, J. Kolar, J. Espinoza, M. Rivera, and C. Rojas, “Predictive torque and flux control of an induction machine fed by an indirect matrix converter,” in Proc. IEEE International Conf. on Ind. Tech., 2010, pp. 1857-1863.

40.

J. Rodriguez, J. Kolar, J. Espinoza, M. Rivera, and C. Rojas, “Predictive torque and flux control of an induction machine fed by an indirect matrix converter with reactive power minimization,” in Proc. IEEE International Symposium on Industrial Electronics, 2010, pp. 3177-3183.