Publisher : The Korean Institute of Electrical Engineers
DOI : 10.5370/JEET.2015.10.3.1093
Title & Authors
Partial Discharge Localization Based on Detailed Models of Transformer and Wavelet Transform Techniques Hassan Hosseini, Seyed Mohammad; Rezaei Baravati, Peyman;
Partial Discharge (PD) is a physical phenomenon, which causes defects and damages to the insulation. This phenomenon is regarded as the most important source of fault and defect in power transformers. Therefore, methods of high speed and precision are considered of special importance for the maintenance of transformers in localization of the origin of partial discharge. In this paper, the transformer winding is first modeled in a transient state by using RLC ladder network and multiconductor transmission line (MTL) models. The parameters of the two models were calculated by Ansoft Maxwell software, and the simulations were performed by Matlab software. Then, the PD pulses were applied to the models with different widths of pulses. With regard to the fact that the signals received after the application of PD had a variable frequency nature over time, and based on the wavelet transform and signal energy, a new method was presented for the localization of PD. Ultimately; the mentioned method was implemented on a 20 kV winding distribution transformer. Then, the performances of the models used in this paper, including RLC and MTL models, were compared in different frequency bands for the correct distinction of partial discharge location.
Wavelet transform;Power transformer;RLC model;Multi-conductor transmission line (MTL);Partial discharge;PD localization.;
Junfeng Gui, Wensheng Gao, Kexiong Tan and Shengyou Gao “Locating Partial Discharge in Power Transformer by Electrical Method,” Proc. Int. Conf. on Properties and Applications of Dielectric Materials, Vol. 1, pp. 459-462, 2003.
S.M.H. Hosseini, M. Vakilian and G.B. Gharepetian, “Comparision of Transformer Detailed models for fast and veryfast transient Studies” IEEE Trans. on Power Delivery, Vol. 23, No. 2, pp. 733-741, 2008.
Z.D. Wang, P.A.Crossley, K.J. Cornik, and D.H. Zho, “An Algorithm for Partial Discharge Location in Distribution Power Transformer”, IEEE Power Engineering Society Winter Meeting, Vol. 3, pp. 2217-2222, 2000.
M. Jafari and A. Akbari, “Partial discharge localization in transformer windings using multiconductor transmission line model,” Elsevier Elecr. Power Syst. Res., Vol. 78, No. 6, pp. 1028-1037, 2008.
A. M. Jafari, A. Akbari and M. Kharezi, “Partial Discharge Localization in Transformers Using Detailed Modeling of Winding and Calibration Pulses” Proc. Int. Conf. on Solid Dielectrics, pp. 536-539, 2007.
Akbari, P. Werle, H. Borsi and E. Gockenbach, “Transfer Function-Based Partial Discharge Localization in Power Transformers A Feasibility Study”, IEEE Electrical Insulation Magazine, Vol. 18, No. 5, pp. 22-33.2002.
S. N. Hettiwatte, Z. D. Wang and P. A. Crossley, “Investigation of propagation of partial discharges in power transformers and techniques for locating the discharge”, IEE Proc. Sci., Meas. Techn., Vol. 152, pp. 25-30, 2005.
M. Homaei, A. M. Jafari and A. Akbari “Investigating Suitable Features for Partial Discharge Localization in Power Transformer” Proc. Int. Conf. on Condition Monitoring and Diagnosis, pp. 923-926, 2008.
M. Popov, L. van der Sluis, R.P.P. Smeets, J.L. Roldan, “Analysis of Very Fast Transients in Layer-Type Transformer Windings” IEEE Trans.on Power Delivery, Vol.22, pp. 238-247, 2007.
S. M. H. Hosseini, M. vakilian, “Using finite element method in calculation of parameters of transformer winding detailed model for partial discharge research” Turkish Journal of Electrical Engineering & Computer Sciences .2013.
S. M. H. Hosseini, Peyman Rezaei Baravati, “Transformer Winding Modeling Based On Multi-Conductor Transmission Line Model For Partial Discharge Study” journal of electrical Engineering & Technology (JEET), Vol. 9, No. 1, pp. 154-161, 2014.