Publisher : Korean Society of Environmental Engineering
DOI : 10.4491/eer.2012.17.3.157
Title & Authors
Thermal Destruction of Waste Insulating Oil Containing PCBs under High Temperature and Pressurized Conditions Seok, Min-Gwang; Lee, Gang-Woo; Lee, Jae-Jeong; Kim, Min-Choul; Kim, Yang-Do; Jung, Jong-Hyeon; Shon, Byung-Hyun;
This experimental study was performed to obtain thermal energy from the combustion of synthetic gas, produced by the pyrolysis of insulating oil containing polychlorinated biphenyls (PCBs) in a high temperature and high pressure reactor. The average synthetic gas generated was via the steady state gasification of insulating oil waste (20 kg/hr) with average concentrations (standard deviation) of , CO, and in the synthetic gas of , , and , respectively. The concentrations of the PCBs in the transformer insulating oil and synthetic gas after its gasification, and the concentrations of the dioxins that could be produced from the incomplete degradation of PCBs were measured. It was revealed that the PCBs in the insulating oil were composed of the series from tetrachlorobiphenyl to octachlorobiphenyl. However, only the #49, #44, #52, and #47/75/48 congeners were detected from the synthetic gas after gasification of the insulating oil and in the flue gas from the combustor. In conclusion, the experimental conditions suggested in this study were very useful for the appropriate treatment of insulating oil containing PCBs. Also, fuel gas containing CO and can be obtained from the pyrolysis of insulating oil containing PCBs.
Dioxins;Gasification;High temperature and pressure;Insulating oil;PCBs;
Environmental Engineering Research in September 2012, Environmental Engineering Research, 2012, 17, 3, 123
Ultra high temperature gasification of municipal wastewater primary biosolids in a rotary kiln reactor for the production of synthesis gas, Journal of Environmental Management, 2016
US Environmental Protection Agency. Polychlorinated biphenyls (PCBs) [Internet]. Cincinnati: US Environmental Protection Agency; c2012 [cited 2012 Aug 30]. Available from: http://www.epa.gov/epawaste/hazard/tsd/pcbs/index.htm.
Jensen S, Johnels AG, Olsson M, Otterlind G. DDT and PCB in marine animals from Swedish waters. Nature 1969;224:247- 250.
Breivik K, Sweetman A, Pacyna JM, Jones KC. Towards a global historical emission inventory for selected PCB congeners: a mass balance approach. 1. Global production and consumption. Sci. Total Environ. 2002;290:181-198.
United Nations Environment Programme (UNEP) Chemicals. Guidelines for the identification of PCBs and materials containing PCBs. Geneva: UNEP Chemicals; 1999.
Hawari J, Demeter A, Samson R. Sensitized photolysis of polychlorobiphenyls in alkaline 2-propanol: dechlorination of Aroclor 1254 in soil samples by solar radiation. Environ. Sci. Technol. 1992;26:2022-2027.
Erickson MD, Swanson SE, Flora JD Jr, Hinshaw GD. Polychlorinated dibenzofurans and other thermal combustion products from dielectric fluids containing polychlorinated biphenyls. Environ. Sci. Technol. 1989;23:462-470.
Consonni S, Vigano F. Waste gasification vs. conventional waste-to-energy: a comparative evaluation of two commercial technologies. Waste Manag. 2012;32:653-666.
Okumura Y, Sugiyama Y, Ikazaki K. Evolution prediction of coal-nitrogen in high pressure pyrolysis processes. Fuel 2002;81:2317-2324.
National Institute of Environmental Research. Standard operating procedure of PCBs in transformer oil. Seoul: National Institute of Environmental Research; 2004.
Ministry of Environment (Korea). Korean waste official method. Gwacheon: Ministry of Environment; 2004.
Van den Berg M, Birnbaum L, Bosveld AT, et al. Toxic equivalency factors (TEFs) for PCBs, PCDDs, PCDFs for humans and wildlife. Environ. Health Perspect. 1998;106:775-792.
Smoot LD, Smith PJ. Coal combustion and gasification. New York: Plenum Press; 1985.
Institute for Advanced Engineering. Gasification/melting process development for treating combustible wastes. Gwacheon: Ministry of Commerce, Industry and Energy; 2005.
Institute for Advanced Engineering. Gasification/melting process development for treating combustible wastes (5 ton/ day-class). Gwacheon: Ministry of Education, Science and Technology; 2002.
Schobel A, Class AG, Krebs L, Braun-Unkhoff M, Wahl C, Frank P. Thermal destruction of benzene. Chemosphere 2001;42:591-9.
Aracil I, Font R, Conesa JA. Semivolatile and volatile compounds from the pyrolysis and combustion of polyvinyl chloride. J. Anal. Appl. Pyrolysis. 2005;74:465-489.