A Study on Automated Multi-Channel Combination System for the Closest Target Weight

Title & Authors
A Study on Automated Multi-Channel Combination System for the Closest Target Weight
Ahn, Yong-Woo; Ban, Kap-Soo;

Abstract
This paper is a study of the functions required for the system to quantify the closest target weight by combining several random weights such as chips, snacks, fruits, and vegetables. The multi-head weigher is designed for high-performance applications requiring increased production rates and tight accuracy tolerances. This combination system has 12 heads considered in the form of a rectangular array of $\small{2{\times}6}$ or $\small{3{\times}4}$. Channel combination can usually occur between 1 and n, and the frequency was the highest with two or three combinations. Experimental result of a combination system for a total target weight was measured at the range from 100g to 500g by increments of 50g, and the average success rate was about 70%. The average elapsed time was about 1.7 seconds, which means it can be used for the packaging of agricultural products with a variety of items.
Keywords
Multi-head;Weighing Machine;Computerized Combination System;Total Target Weight;Unit Weighing Scale;
Language
Korean
Cited by
References
1.
Keraita, J. N. and Kim K. H., "A Study on the Optimum Scheme for Determination of Operation Time of Line Feeders in Automatic Combination Weighers," J. Mech. Sci. Technol., Vol. 20, No. 10, pp. 1567-1575, 2006.

2.
Hoffmann, K. (2001), "Applying the Wheatstone Bridge Circuit," Retrieved 1. Oct., 2015, from http://www.hbm.com/fileadmin/mediapool/hbmdoc/technical/s1569.pdf.

3.
Hoffmann, K. (2012), "An Introduction to Stress Analysis and Transducer Design using Strain Gauges," Retrieved 1. Oct., 2015, from http://www.kk-group.ru/help/Strain_Gauge_Measurements_Book_2012_01.pdf.

4.
Lee J. H. and Lee W. R., "A Study on the Manufacturing of a High-Efficiency Load Cell Using a Single Surface Design" J. Korean Soc. Manuf. Technol. Eng., Vol. 19, No. 6, pp. 724-730, 2010.

5.
Kim J. O., Ko, J. B. and Park, H. S., "A Study on the Measurement of Bending Constraint Force of STS304 Thin Plate Using the Load Cell," Trans. Korean Soc. Mach. Tool Eng., Vol. 16, No. 6, pp. 86-93, 2007.

6.
Han D. S., Ha J. M., Han G. J., "Creative Design of Large-Angle Pin Type Load-cell for Overload Limited of a Movable Crane," J. Korean Soc. Manuf. Process Eng., Vol. 9, No. 1, pp. 35-41, 2010.

7.
Lee D. W., Park M. H., Lee G. G., Kin I. H., Lee S. S., "Development of the Pin Type Load-cell Using Strain Gauge," J. Korean Soc. Manuf. Process Eng., Vol. 13, No. 4, pp. 75-82, 2014.

8.
Lim M. R., "A Study on Development of Combination Weigher," A Thesis for a Master, Yeungnam University, Republic of Korea, 2002.

9.
Rhee, H. W., "Experimental Evaluation of Fatigue Threshold for SA-508 Reactor Vessel Steel," J. Korean Soc. Manuf. Process Eng., Vol. 11, No. 4, pp. 160-167, 2012.