Behavior of Wide Beam-Column Interior Joint with Slab

Title & Authors
Behavior of Wide Beam-Column Interior Joint with Slab
Lee, Bum-Sik; Park, Seong-Sik; Park, Ji-Young;

Abstract
An experimental investigation was conducted to study the behavior of RC wide beam-column joints with slab subjected to reversed cyclic loads under constant axial load. Six half scale interior wide beam-column assemblies representing a portion of a frame subjected to simulated seismic loading were tested, including three specimens without slab and three specimens with slab. The primary variables were the ratio of column-to-beam flexural capacity ($\small{M_r={\Sigma}M_c/{\Sigma}M_b}$ ; 0.77~2.26), ratio of the column-to-beam width (b/H ; 1.54, 1.67). Test results are shown that (1) the current design code and practice for interior joints(type 2) are apply to the wide beam-high strength concrete column. (2) the presence of a slab have an effect on the performance of the wide beam-high strength concrete column interior joints(type 2). therefore in the design of the wide beam-high strength concrete column interior joints(type 2), the width of slab effective as a T beam flange should be considered. It was show that the case of the ratio of column-to-beam flexural capacity is more than 2.0, the effective width of slab are 2 times of an effective depth of wide beam, however if the ratio of column-to-beam flexural capacity is 1.4~2.0, the effective width of slab are not able to be considered.
Keywords
Wide-Beam Column Joint;Slab Effect;Inelastic Analysis;Load-Displacement;Ductility;Stiffness;
Language
Korean
Cited by
References
1.
(구)대한주택공사(2002), 고강도콘크리트의 적용에 관한 연구-구조성능 평가.

2.
ACI-ASCE Committee 352 (1995), Recommendations for Design of Slab-Column Connections in Monolithic Reinforced Concrete Structures, American Concrete Institute, Farmington Hills, Michigan.

3.
Kunnath, S. K., and A. M. Reinghorn (1989), Inelastic Three-Dimensional Response Analysis of Reinforced Concrete Building Structures (IDARC-3D), Part I- Modeling, Technical Report NCEER-89-0011, State University of New York at Buffalo.

4.
Kunnath, S. K., and A. M. Reinghorn (1992), DARC Version 3.0 : A Program for the Inelastic Damage Analysis of Reinforced Concrete Structures, Technical Report NCEER-92-0022, State University of New York at Buffalo.

5.
Paulay, T., and M. J. N. Priestley (1992), Seismic Design of Reinforced Concrete and Masonry Buildings, John Wiley & Sons.

6.
Quintero-Febres, C. G., and J. K. Wight (2001), "Experimental Study of Reinforced Concrete Interior Wide Beam-Column Connections Subjected to Lateral Loading", Journal of ACI, 98(4): 572-582.

7.
Reinhorn, A. M., and S. K. Kunnath (1987), IDARC: Inelastic Damage Analysis of Reinforced Concrete Frame-Shear-Wall Structures, Technical Report NCEER-87-0008, State University of New York at Buffalo.

8.
Stehle, J. S., H. Goldsworthy, P. Mendis (2001), "Reinforced Concrete Interior Wide-Band Beam-Column Connections Subjected to Lateral Earthquake Loading", Journal of ACI, 98(3): 270-279.