DOI QR코드

DOI QR Code

단일 유로를 갖는 와류발생기의 에너지분리 특성

유갑종;장준영;최인수
Yu, Gap-Jong;Jang, Jun-Yeong;Choe, In-Su

  • 발행 : 2001.08.01

초록

When vortex tubes are applied to enhance the coefficient of performance of refrigeration system, the smaller one is preferable. However, the existing vortex generator with a nozzle hole diameter of 0.5mm was not suitable due to chocking of the nozzle hole. Therefore, experimental investigation was made to find an appropriate geometry of vortex generator, which could give a comparable effect of energy separation to commercial ones without chocking problem. The tested vortex generators were tangential and spiral types, which had single inducing channel with larger cross-sectional area than that of conventional multi-hole ones. The experimental result showed that the performance of the spiral type was better than that of the tangential one. As a small size of spiral one, the diameter of cold-end orifice is proposed to an half of tube diameter for the application to refrigeration system, while cold mass fraction ratio is 0.5∼0.6 for a desirable operation.

키워드

보텍스튜브;에너지분리;접선형;나선형;와류발생기

참고문헌

  1. Kim, S. J., 1998, 'The Characteristics of Energy Separation of Refrigerant and other Gases in Vortex Tube,' M. Sc. Thesis, Kyungpook, National University, Taegu. Korea
  2. Park, K. D., 1998, 'The Study of Energy Separation as types of refrigerants in Vortex Tube,' M. Sc. Thesis, Kyungpook, National University, Taegu, Korea
  3. Takahama, H, andKawashima, K. I., 1966, 'An Experimental Study of Vortex Tube,' Bulletin of JSME, Vol. 9, No. 33, pp. 227-245
  4. Balmer, R. T., 1988, 'Pressure-Driven Ranque-Hilsch Temperature Separation in Liquids,' J. of Fluids Engineering, Vol. 110, pp. 161-164
  5. Choi, B. C., 1997, 'Energy Separation and Solid Separation of Incompressible Fluid Using Vortex Tube,' Ph. D. Thesis, Kyungpook, National University, Taegu, Korea
  6. Chizhikov, Yu. V., 'Dependence of the Ranque effect on the physical nature of the working medium,' Russian Journal of Fuel, Vol. 35, No. 2, pp. 105-108
  7. Kim, C. S., 1998, 'The Effect of Geometric Form of Generator of a Vortex Tube on the Energy Separation,' M. Sc. Thesis, Kyungpook, National University, Taegu, Korea
  8. Parulekar, B. B., 1961, 'The Short Vortex Tube,' The Journal of Refrigeration, pp. 74-78
  9. Riu, K. J., 1996, 'An Experimental Study for Cold End Orifice of Vortex Tube,' Trans. KSME (B) Vol. 20, No 3
  10. Martynovskii, V. S. and Alekseev, V. P., 1957, 'Investigation of the Vortex Thermal Separation Effect for Gases and Vapors,' Soviet Phys.- Technical Phys., Vol. 1, pp. 2233-2243
  11. Kassner, R. and Knoernschild, E., 1948, 'Friction Laws and Energy Transfer in Circular Flow,' U. S. A. F. Air Material Command, Wright-Patterson AFB, Proj. No. LP-259;Tech.Rept. No. F-TR-2198-ND;GS-USAF,AF Base No. 78, March
  12. Hartnett, J. P. and Eckert, E. R. G., 1957, 'Experimental Study of the Velocity and Temperature Distribution in a High Velocity Vortex-type Flow,' Trans. ASME, J. of Heat Transfer, Vol. 79, pp. 751-758
  13. Stephan, K., Lin, S., Durst, M., Huang, F., and Seher, D., 1983, 'An Investigation of Energy Separation in a Vortex Tube,' Int. J. Heat Mass Transfer, Vol. 15, No. 3, pp. 341-348 https://doi.org/10.1016/0017-9310(83)90038-8
  14. Deissler, R. G. and Perlmutter, M., 1960, 'Analysis of the Flow and Energy Separation in a Turbulent Vortex,' J. of Heat Mass Transfer, Vol. 1, pp. 173-191 https://doi.org/10.1016/0017-9310(60)90021-1
  15. Hilsch, R., 1947, 'The Use of Expansion of Gases in a Centrifugal Field as a Cooling Process,' Review of Scientific Instruments, Vol. 8, No. 2, pp. 108-113
  16. Fulton, C. D., 1950, 'Ranque's Tube,' Refrigeration Engineering, Vol. 5, pp. 473-479
  17. Ranque, G. J., 1932, United State Patent, Applied December 6. Serial No 646.020