DOI QR코드

DOI QR Code

Load Transfer Mechanism of the Hybrid Beam-Column Connection System with Structural Tees

T 형강을 사용한 합성골조 보-기둥 접합부의 하중전달 메카니즘

  • Published : 2002.12.01

Abstract

The composite frame system with reinforced concrete column and steel beam has some advantages in the structural efficiency by complementing the shortcomings between the two systems. The system, however has also a lot of problems in practical design and construction process due to the material dissimilarities. Considering these circumstances, this research is aimed at the development of the composite structural system which enables the steel beams to be connected to the R/C columns with higher structural safety and economy. Basically the proposed connection system is composed of four split tees, structural angles reinforced by stiffener, high strength steel rods, connecting plates and shear plates. The structural tests have been carried out to verify the moment transfer mechanism from beam flange to steel rods or connecting plates through the angle reinforced by siffener. The four prototype specimens have been tested until the flange of beam reached the plastic states. From the tests, no distinct material dissimilarities between concrete and steel have been detected and the stress transfer through wide flange beam - structural angle - high strength steel rod or connecting plate is very favorable.

References

  1. Sheikh, T. M., Deierlein, G. G., Yura, J. A., and Jirsa, J. O., "Beam - Column Moment Connections for Composite Frames : Part q," J. Struct. Engrg. ASCE, Vol. 115, No. 11, 1989, pp.2858-2876. https://doi.org/10.1061/(ASCE)0733-9445(1989)115:11(2858)
  2. ASCE Task Committee on Design Criteria for Composite Structures in Steel and Concrete,"Guidelines for Design of Joints Between Steel Beams and Reinforced Concrete Columns," J. Struct. Engrg., ASCE, 1994, pp.2330-2357. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:8(2330)
  3. Deierlein, G. G., Sheikh, T. M., Yura, J. A., and Jirsa, J. O., "Beam - Column Moment Connections for Composite Frames : Part 2" J. Struct. Engrg. ASCE, Vol. 115, No. 11, 1989, pp.2877-2896. https://doi.org/10.1061/(ASCE)0733-9445(1989)115:11(2877)
  4. 김광연, "柱RC.梁S 混合構造 接合部の 剪斷耐力に 關する 硏究," 千葉大 大學院, 1997.3.
  5. 김상식, "T형강을 사용한 합성골조 보-기둥 접합부의 거동에 관한 연구," 한양대학교 초대형 구조시스템 연구센터 보고서, STRESS-98-12, 1999. 2
  6. 日本建築學會, "柱RC.梁Sとする 混合構造の 柱梁裝合部の 力學的擧動に 關する シンポジゥム," 1994.12.