Ormocer-Based-Resin의 상아질에 대한 전단결합강도 및 파절 양상에 대한 연구

• Ahn, Shi-Hyun (Department of Prosthodontics College of Dentistry, Dankook University) ;
• Cho, In-Ho (Department of Prosthodontics College of Dentistry, Dankook University) ;
• Lim, Ju-Hwan (Department of Prosthodontics College of Dentistry, Dankook University) ;
• Lim, Heon-Song (Department of Prosthodontics College of Dentistry, Dankook University)
• 안시현 (단국대학교 치과대학 보철학교실) ;
• 조인호 (단국대학교 치과대학 보철학교실) ;
• 임주환 (단국대학교 치과대학 보철학교실) ;
• 임헌송 (단국대학교 치과대학 보철학교실)
• Published : 2002.12.30

Abstract

The bond strength is one of the most important factor in establishing long-term success of esthetic restorative dentistry. So, various restorative materials have been introduced to improve the esthetic and physical properties. Ormocer (organically modified ceramic) was developed as a result of such efforts. This study was performed to compare the shear bond strength of ormocer based adhesive with that of existing dentin adhesive. In this study $Admira^{(R)}$ and $Admira^{(R)}$ bond of the ormocer system are grouped together for ADM, Single $Bond^{(R)}$ which is an one-bottle adhesive and Z-250TM which is hybrid composite resin of BIS-GMA system for SIN, and $Definite^{(R)}$ of ormocer and Etch & $Prime^{(R)}$ 3.0 which is a self etching priming/ bonding agent for ETC. The results of this study were as follows. : (1) In the comparison of shear bond strength according to different adhesive system, shear bond strength was increased in the order of ETC group, SIN group, ADM group. There was no significant difference between ADM group and SIN group. However, there was a significant level of difference between ADM and ETC groups as well as SIN and ETC groups( p<0.05). (2) Examination by a scanning electron microscope showed a well established hybrid layer and resin tag in both ADM group and SIN group, while ETC group showed a minimal formation of the hybrid layer when compared with ADM and SIN groups. From the above results, it may be reasonable to start the clinical application of ormocer system, and it is recommended that ormocer system should be used along with an ormocer based adhesive because ormocer system showed the lower shear bond strength when it used with other existing self etching priming/bonding agent. The self etching priming/bonding agent showed relatively low shear bond strength, and it is considered that the further study should be needed.