Adhesive Strength in Tension of SBR-Modified Cement Mortar with Self-Flowability Material for Floor-Finishing

자기 평활성 바닥 마감용 SBR 시멘트 모르타르의 인장부착강도

  • Published : 2003.08.01


Various researches on the application of polymer dispersions to the cement mortar and concrete have been practised in many countries like America, Japan and Germany and so on because of high performance and good modification effect of these. In this study, SBR, Polymer dispersion that widely used in situ is employed that the self-flowability may be induced in the cemen mortar. In order to comprehend and investigate the modification of cement mortar with self-flowability by SBR and properties and fracture mode of adhesive strength in tension of that, experimental parameter was set as SBR solid-Cement ratio(S/C) and Cement:Fine aggregate(C:F) and the experiments such as Unit weight, Flow, Consistency change, Crack resistance and Segregation that inform on the general properties have been done. In addition of that, Adhesion in tension is measured with a view to comprehending the properties and fracture mode in tensile load. Consistency change of cement mortar modified by SBR did grow better as the ratio of SBR solid-Cement increased and was much superior to that of resin based flooring such as polyurethane and epoxy which recorded the loss of consistency in 90min. after mixing. Adhesive strength in tension increased with continuity in the curing age and showed the maximum in case of C:F=1:1 and S/C=20%. As the increase of curing age, the fracture mainly happened in the concrete substrate and the interface between the specimen and concrete substrate.


SBR;cement mortar;flooring;self-flowability;consistency change


  1. 소양섭, 김완기, '폴리머 모르터 바닥마감재의 바탕조정용 폴리머 시멘트 모르터의 강도 및 접착성', 대한건축학회, 18권 2호, 1998.10, pp.606-609
  2. 도정윤, 소양섭, '박막형 폴리머 시멘트계 셀프레벨링재의 개발에 관한 연구', 대한건축학회 춘계 학술발표논문집,21권 1호, 2001, pp.313-316
  3. 도정윤, 소양섭, '바닥마감용 폴리머 시멘트계 Selfleveling재의 기초성능평가', 한국콘크리트학회 봄 학술발표 논문집, 13권 1호, 2001, pp.1005-1010
  4. 한국콘트리트학회, 콘크리트 혼화재료, 기문당, 1997.pp.49-75
  5. Yoshihiko Ohama, 'Handbook of Potymer-ModifiedConcrete and Mortars, Noyes Publications,' ParkRidge, New Jersy, 1995, pp.11-20, 111-120
  6. Chandra, S. and Ohama, Y., 'Potymer in Concrete,'CRC, Boca Ration, Florida, 1994, pp.147-152
  7. J.Y.Do and Y.S.Soh, 'A Study on the Devdopmentof Polymer-Modified Cemendtious Self-LevelingMaterials with Thin Coat,' International journal of KCI, June 2001, pp.66-74
  8. V.POLLET, W.VAN LAECKE and J.VYNCKE,'The Use of Polymers for Industrial Floors,'Proceedings of the 8th International Congress onPotymers in Concrete, Antwerp, 1995, pp.387-392
  9. Alexanderson J., 'Polymer Cement Concrete forIndustrial Floors,' Proceedings of the International Congress on Polymers in Concrete, College of Engineering, Nihon University, Koriyama, Japan(1982), pp.360-373
  10. Ohama, Y., 'Principle of Latex Modificadon andSome Typical Properties of Latex-ModiSed Mortarsand Concretes,' ACI Materials Joumal, Vol.84,No.6, Nov.-Dec. 1987, pp.511-518
  11. Paree k, S.N., Ohama, Y., and Demura, K,'Adhesion of Bonded Mortars to Polymer-CementPaste Coated Mortar Substrates,' Proceedings ofthe International Conference on Interfaces inCementitious Cornposites, E&FN Spon, Oct. 1992,pp.89-98
  12. J. Schulze, F.Jodlbauer, K. Adler, 'Polymsr Modified Mortars for the Renovation and Rehabilitation of Concrete Structures,' International Congress on Polymers in Concrete, 1993
  13. Sebastien R, Jean A, Jean R, 'Effects of differentviscosity agents on the properties of self-levelingconcrete,' Cement and Concrete research, 9 Feb.,1998, pp.261-266
  14. M Gunter, 'Stresses due to PhysicaI and ChemicalActions in Potymer coatings on A ConcreteSubstrate,' Adhesion between Polymer and Concrete, RILEM, 1986, pp.8-21
  15. Ohama, Y. and Demura, K, 'Adhesion of Polymer-Modified Mortars to Ordinary Cement Mortar by Different,' Test Method, Adhesion between Polymer and Concrete, RILEM, 1986,pp.719-727
  16. W.H. Peier, 'Adhesion Testing of Polyrner ModifiedCement Mortars,' Adhesion between Polymer andConcrete, RILEM, 1986, pp.730-740
  17. ACI Committee 548, 'Stcite-of-the-Art Report onPolymer-Modified Concrete,' ACI report 548.3R-2,ACI Manual of Concrete Practice Part 5, 1994

Cited by

  1. Adhesive Properties of High Flowable SBR-modified Mortar for Concrete Patching Material Dependent on Surface Water Ratio of Concrete Substrate vol.17, pp.2, 2013,