Analytical method of PCBs-containing solid wastes

PCBs 함유 고상폐기물의 분석방법 고찰

  • Park, Jin Soo (National Institute of Environmental Reserch of Environmental Research) ;
  • Kang, Young Yeul (National Institute of Environmental Reserch of Environmental Research) ;
  • Song, Ki Bong (National Institute of Environmental Reserch of Environmental Research) ;
  • Jeon, Tea Wan (National Institute of Environmental Reserch of Environmental Research) ;
  • Chun, Jin Won (National Institute of Environmental Reserch of Environmental Research) ;
  • Shin, Sun Kyoung (National Institute of Environmental Reserch of Environmental Research) ;
  • Jung, Kwang Yong (National Academy of Agriculture Science)
  • 박진수 (국립환경과학원 화학물질거동연구과) ;
  • 강영렬 (국립환경과학원 화학물질거동연구과) ;
  • 송기봉 (국립환경과학원 화학물질거동연구과) ;
  • 전태완 (자원순환연구센터) ;
  • 전진원 (국립환경과학원 화학물질거동연구과) ;
  • 신선경 (국립환경과학원 화학물질거동연구과) ;
  • 정광용 (국립농업과학원)
  • Received : 2009.09.02
  • Accepted : 2009.10.21
  • Published : 2009.12.25

Abstract

This study was performed to improve the analytical methods and re-establish the regulatory standard of PCBs-containing solid wastes for sufficient management in which has been concerned internationally. To do this, the sampling, pre-treatment and quantification methods which were used in USA and Japan were discussed. It was thought properly that new standard of PCBs-containing solid wastes was established through correlation with PCBs concentration of transformer oil. The surface wipe sampling was selected in the nonporous materials and cutting sampling in the porous materials. In the absence of transformer oils, electrical equipment is PCB-contaminated if it has PCBs at ${\geq}0.4{\mu}g/100cm^2$ as measured by a wipe test of a nonporous surface and if it has at 0.04 mg/L as measured by cutting test of a porous material. Also, new analytical methods for PCBs containing solid waste were proposed.

Keywords

PCBs;Solid waste;GC/ECD

References

  1. T. Takasuga, K. Senthilkumar, K. Shiozaki and S.I. Sakai, Chemosphere, 62, 469-484(2006) https://doi.org/10.1016/j.chemosphere.2005.04.034
  2. R. J. Fensterheim, Regul. Toxicol. Pharmacol., 18, 181-201(1993) https://doi.org/10.1006/rtph.1993.1052
  3. F. Wania and D. Mackay, Environ Sci Technol., 30(9), 390A-396A(1996) https://doi.org/10.1021/es962399q
  4. 환경부, '폐기물공정시험방법', 2007
  5. US EPA, 'Code of Federal Regulations. 40 CFR 707.60.', Washington, DC, US Environmental Protection Agency, 1980
  6. T. W. Duke, J. I. Lowe and A. J. Wilson, Bull Environ Contam Toxicol, 5, 3171-3180(1970)
  7. K. Breivik, R. Alcock, Y. F. Li, R. E. Bailey, H. Fiedler and J. M. Pacyna, Environ Pollut, 128, 3-16(2004) https://doi.org/10.1016/j.envpol.2003.08.031
  8. 국립환경과학원, '폴리염화비페닐류(PCBs)함유 폐기물의 적정관리방안에 관한 연구', 2003
  9. 'PCB 處理技術 ガイドプツク', 産業廢棄物處理事業振興財團, 日本, 2005
  10. 환경부, '잔류성유기오염물질관리법', 2008
  11. 환경부, '유해화학물질관리법', 2008
  12. UNEP, 'Regionally based assessment of persistent toxic substances', Global Report 2003, 220, UNEP-Chemicals Geneve Switzerland, 2003
  13. M. Weintraub and L. S. Birnbaum, Environmental Research, 107, 412-417(2008) https://doi.org/10.1016/j.envres.2008.03.001
  14. T. J. Belton, P. Huage, D. Lockwod and B. E. Ruppel, Rev Aquat Sci, 6, 275-293(1992)
  15. Y. Masuda, The Yusho rice oil poisoning incident. In: A. Schecter, Editor, Dioxins and health, Plenum Press, New York, USA, pp. 633-659(1994)
  16. Y. Yao, T. Takasuga, S. Masunaga and J. Nakanishi, Chemosphere, 46, 1461-1469(2002) https://doi.org/10.1016/S0045-6535(01)00254-5
  17. H. Crine and J. Jean Pierre, Hazard, Environmental science research, 37, 1-12(1986)
  18. R. P. Pohanish. 'Rapid guide to hazardous chemicals in the environment', Van Nostrand-Reinhold, New York, (1997)
  19. United Nations Environment Programme, Stockholm Convention on Persistent Organic Pollutants (POPs) (http://www.pops.int)
  20. 환경부, '폐기물관리법', 2008
  21. Agency for Toxic Substances and Disease Registry, 'Toxicological profile for polychlorinated biphenyls (PCBs)'. Department of Health and Human Services, Public Health Service, U.S., 2000
  22. 환경부, '폐변압기 및 콘덴서 안전관리 체계 연구', 2007
  23. 환경부, '변압기 절연유 중 PCBs 오염원 추적 연구', 2007