공조용 회전식 압축기 소음원 규명을 위한 실험적 연구

Son, Young-boo;Ha, Jong-hun;Lee, Jang-woo

  • 투고 : 2015.07.09
  • 심사 : 2015.10.15
  • 발행 : 2015.11.20


This paper investigated the noise generation mechanism of a rotary compressor using experimental method. The measurement was carried out for primary parameters which influence noise characteristics. By using STFT(short time Fourier transform), noise sources of a rotary compressor were identified and vibrating modes that increase the noise are verified. Also, it was studied that the correlation between operating speed and noise. Main factors that affect the variation of noise level were considered by the comparison of the experimental results. In addition, a dynamic characteristic of crank shaft was studied and the critical speed was analyzed.


소음원 규명;회전식 압축기


  1. Adachi, Y., Onoda, I. and Takashima, K., 1996, Development of a Low Noise Rotary Compressor, International Compressor Engineering Conference, pp. 709-714.
  2. Nonaka, R., Suda, A. and Matsumoto, K., 1992, Noise Reduction Analysis On Inverter Driven Two-cylinder Rotary Compressor, International Compressor Engineering Conference, pp. 341-350.
  3. Ahn, S. J., Jeong, W. B., Park, J. H. and Hwang, S. W., 2002, The Visualization of Vibration and Noise of the Rotary Compressor During One Cycle of Crank Shaft by Use of Short Time Fourier Transform, Proceedings of the KSNVE Annual Autumn Conference, pp. 428-433.
  4. Dreiman, N. and Herrick, K., 1998, Vibration and Noise Control of a Rotary Compressor, International Compressor Engineering Conference, pp. 685-690.
  5. Kumar, K., Lu, J., Leyderman, A., Marler, M. and Nieter, J., 1994, Reduced Noise Valve Design for a Rotary Compressor, International Compressor Engineering Conference, pp. 19-23.
  6. Kim, H. J. and Cho, Y. M., 2000, Noise Source Identification in Rotary Compressor: A Multidisciplinary Synergetic Approach, Joural of Acoustics Soc. Am., Vol. 110, No. 2, pp. 887-893.
  7. Jeong, W. B. and Kim, T. H., 1999, Dynamic Behavior Analysis of Rotor-bearing System for Rotary Compressor, Journal of Korean Society of Marine Engineering, Vol. 23, No. 2, pp. 244-251.
  8. Cho, I. S., Chang, W. S., Kim, J. M., Kim, D. W., Oh, S. H. and Jung, J. Y., 1996, The Analysis of Shaft Center Locus in the Refrigeration & Air Conditioning Rotary Compressor, Journal of KSTLE, Vol. 12, No. 2, pp. 65-73.
  9. Wang, Z., Yu, X., Liu, F., Feng, Q. and Tan, Q., 2013, Dynamic Analyses for the Rotor-joutnal Bearing System of a Variable Speed Rotary Compressor, International Journal of Refrigeration, Vol. 36, No. 7, pp. 1938-1950.
  10. Kim, J. S., Lim, K. N., Ku, S. J., Lee, J. W. and Jeon, S. M., 2008, Study on the Noise Reduction in the Rotary Compressor Using BLDC Motor, Transactions of the Korean Society for Noise and Vibration Engineering, Vol. 18, No. 9, pp. 920-929.