Injection Molding Analysis of Battery case considering the Insert Deformation

인서트 변형을 고려한 배터리 케이스 사출 성형 해석

  • 안동규 (조선대학교 공과대학 기계공학과) ;
  • 김대원 (조선대학교 일반대학원 기계공학과)
  • Published : 2008.11.05

Abstract

The objective of this paper is to investigate into the influence of the injection conditions on the insert deformation and the wall thickness of the injection part using the three-dimensional injection molding analysis. Full three-dimensional insert model was added to the injection molding analysis model to consider the effects of insert deformation during the injection molding process. In order to obtain the optimum injection molding condition with a minimum insert deformation, degree of experiments were utilized. From the results of the analyses, it was shown that the optimum injection condition is injection time of 1.6 sec, injection pressure of 30 MPa and packing time of 15 sec. In addition it was shown that the wall thickness is approached to target thickness when the core deformation is considered in the injection molding analysis.