A Study on the Shear Characteristics of the Decomposed Granite Soils Using Direct Shear Test

직접전단시험(直接剪斷試驗)에 의한 화강토(花崗土)의 전단특성(剪斷特性)에 관(關)한 연구(硏究)

  • Lee, Dal Won (Graduate School, Chungnam Nat'l Univ.) ;
  • Kang, Yea Mook (Dept. of Agricultural Engineering, Call. of Agriculture, Chungnam Natl. Univ.) ;
  • Cho, Seong Seup (Dept. of Agricultural Engineering, Call. of Agriculture, Chungnam Natl. Univ.)
  • 이달원 (충남대학교 대학원) ;
  • 강예묵 (충남대학교 농과대학 농공학과) ;
  • 조성섭 (충남대학교 농과대학 농공학과)
  • Published : 1986.12.31

Abstract

This paper describes the observed behavior in the direct shear test on decomposed granite soil having the complicate engineering properties at various different levels of factors. The objectives of this study were to investigate the characteristics of the decomposed granite soil under controlled various moisture content, dry density, strain rate and soaking which give influence to the shear strength. The results were summarized as follows; 1. The shear strength was decreased remarkably with the increasing of moisture contents of A and B soil were 5-10% and 15-20% respectively. 2. Cohesion and angle of internal friction were decreased with the increasing of moisture content and increased with the increasing of dry density. 3. The shear strength was increased with the increasing of normal stress and volume change was decreased on the whole. The shear strength was generally increased with the increasing of the strain rate. 4. As dry density increases, A-soil shows the progressive failure and the decrease of volume change while B-soil shows the initial failure and the increase of volume change. 5. The relationships between the soaked and unsoaked specimens were as follows ; ${\tau}_f=0.1009+1.026{{\tau}_f}^*$ (A-soil), ${\tau}_f=0.1586+0.8005{{\tau}_f}^*$ (B-soil) 6. Angle of internal friction of the direct shear test shows larger value than that of the triaxial compression test. All effective stress path was nearly similar.

공학적(工學的) 성질(性質)이 복잡(複雜)한 화강암질풍화토(花崗岩質風化土)를 함수비(含水比) 및 밀도(密度)와 변형속도(變形速度) 등(等)을 달리하여 수침시(水浸時)와 비수침시(非水浸時)에 대한 전단시험(剪斷試驗)을 하고, 이들간의 상호관계(相互關係)가 전단강도(剪斷强度)에 미치는 영향(影響)을 비교(比較) 분석(分析)하여 다음과 같은 결론(結論)을 얻었다. 1. 함수비(含水比)가 증가(增加)하면 전단강도(剪斷强度)는 감소(減少)하여, A 시료(試料)는 함수비(含水比) 5~10%에서, B 시료(試料)는 함수비(含水比) 15~20%에서, 강도(强度)의 감소율(減少率)이 크게 나타났다. 2. 점착력(粘着力)과 내부마찰각(內部摩擦角)은 함수비(含水比)가 증가(增加)함에 따라서 감소(減少)하고 건조밀도(乾燥密度)가 증가(增加)함에 따라 증가(增加)하였다. 3. 수직응력(垂直應力)이 증가(增加)함에 따라 전단강도(剪斷强度)는 증가(增加)하였고, 체적변화(體積變化)는 대체(大體)로 감소(減少)(압축(壓縮))하는 경향(傾向)을 나타내었다. 또 변형속도(變形速度)가 증가(增加)할수록 전단강도(剪斷强度)는 대체(大體)로 증가(增加)하는 경향(傾向)을 나타내었다. 4. A시료(試料)는 밀도(密度)가 증가(增加)할수록 진행성파괴형태(進行性破壞形態)를 보이고 체적(體積)은 감소(減少)(압축(壓縮))하였으며, B시료(試料)는 초기(初期)에 파괴(破壞)되고 체적(體積)은 증가(增加)(팽창(膨脹))하는 경향(傾向)을 나타내었다. 5. 수침시(水浸時)의 전단강도(剪斷强度)는 비수침시(非水浸時)에 비(比)해서 감소(減少)하였고, 관계식(關係式)은 A시료(試料)에서는 ${\tau}_f=0.1009+1.026{{\tau}_f}^*$이고, B시료(試料)에서는 ${\tau}_f=0.1586+0.8005{{\tau}_f}^*$로 나타낼 수 있었다. 6. 내부마찰각(內部摩擦角)은 직접전단시험(直接剪斷試驗)에서 더 크게 나타났고, 유효응력경로(有效應力經路)는 거의 유사(類似)하게 나타났다.

Keywords