Dielectric Breakdown and Electric Stress Distribution in Ferroelectrics

강유전체에서의 전계분포 및 절연파괴

  • 신병철 (한국과학기술원 재료공학과) ;
  • 김호기 (한국과학기술원 재료공학과)
  • Published : 1987.04.01

Abstract

Pure barium titanate was sintered at $1340^{\circ}C$ for 2, 4, 8, 16 hr to control their grain size. The measurements of breakdown strength and partial discharge characteristics were performed under rising AC voltage(60Hz). With increase of sintering time, the average grain size was increased and breakdown strength was slightly decreased. Partial discharge in pores was observed under high voltage, and a model of dielectric break down in barium titanate ceramics is proposed.

Keywords

References

  1. J. Appl. Phys v.6 Electric Breakdown of BariumTitanate: A Model K.D. Schomann
  2. IEEE Trans. Aero. Electr. Sys. v.AES-18 no.1 Partial Discharge Testing Under Direct Voltage Conditions R. Bever;J.L. Westro
  3. 한국전기통신연구소 보고서 3SS030 고전압 측정기술의 체계화 연구 심문식(외)
  4. IEEE Conf. on Conduction and Breakdown in Solid Dielectrics Effect of Microstructure on the Dielectric Breakdown of Polycrystalline BaTiO₃ B.C. Shin;H.G. Kim
  5. J. Appl. Phys. v.30 no.11 Dielectric Breakdown of Porous Ceramics R. Gerson;T.C. Marshall
  6. IEEE Trans. Electr. Insul. v.E1-21 no.2 Analysis of Electric Stress Distribution in Cavities Embedded within Dielectric Structures D.D. Chang;T.S. Sudarshan;J.E. Thompson