Stress-Strain Behavior of Clays under Repeated Loading

반복재하(反復載荷)에 의한 점성토(粘性土)의 응력변형특성(應力變形特性)

  • Cho, Jae Hong (Graduate School, Chungnam Nat'l Univ.) ;
  • Kang, Yea Mook (Dept. of Agricultural Engineering Coll. of Agriculture, Chungnam Nat'l Univ.) ;
  • Ryu, Neung Hwan (Dept. of Agricultural Engineering Coll. of Agriculture, Kangwon Nat'l Univ.)
  • 조재홍 (충남대학교 대학원) ;
  • 강예묵 (충남대학교 농과대학 농공학과) ;
  • 유능환 (강원대학교 농과대학)
  • Published : 1987.12.31

Abstract

This paper described the behavior under repeated loading in triaxial compression test on clay. The experiment was conducted to investigate the influence of controlled various over-consolidation ratio and compaction energy, on the stress-strain behavior of clays. 1. The difference of deviator stress during repeated loading was greatly appeared at large strain. And pore water pressure was decreased at initial of unloading, but it was increased again before long. 2. The recoverable elastic strain (${{\Delta}{\varepsilon}e}$) and the slope of un-reloading were decreased with the increment of over-consolidation ratio (OCR). 3. The recoverable elastic strain (${{\Delta}{\varepsilon}e}$) was increased with the increment of strain rate but it was decreased with the increment of strain in strain rate tests. The slope of un-reloading (Eur) tends to increase with the increment of strain rate and it was decreased with the increment of strain. 4. The recoverable elastic strain was greatly increased with the increment of compaction energy and it slightly tends to decrease with the increment of strain on various compaction energy. The slope of un-reloading was not appeared markedly with increment of compaction energy but it tends to decrease with the increment of strain generally.

과압밀비(過壓密比)와 전단속도(剪斷速度) 및 다짐율(率)이 점성토(粘性土)의 응력변형특성(應力變形特性)에 미치는 영향(影響)을 검토(檢討)하기 위해서 반부극하(反復戟荷)에 의(依)한 삼축압축시험(三軸壓縮試驗)을 한 결과(結果)를 요약(要約)하면 다음과 같다. 1. 반부재하(反復載荷)를 했을 때 같은 변형(變形)에서 축차응력의 차(差)는 큰 변형(變形)에서 반부재하(反復載荷)했을 때 더욱 크게 나타났고 공극수압(空隙水壓)은 제하시(除荷時)에는 감소(減少)하다가 다시 증가(增加)하며 재재하(再載荷)되면서 급격히 증가하는 현상(現象)을 나타냈다. 2. 과압밀비(過壓密比)가 클수록 변형(變形)의 증가(增加)에 따라 회복되는 탄성변형률은 감소(減少)하였으며 제일재하계수(除一載荷係數)는 과압밀비가 증가(增加)할수록 감소(減少)하였다. 3. 전단속도(剪斷速度)가 증가(增加)함에 따라 탄성변형율(彈性變形率)은 증가(增加)하였고 변형(變形)의 증가(增加)에 따라 탄성변형율(彈性變形率)은 감소(減少)하였다. 제일재하계수(除一載荷係數)는 변형(變形)이 증가(增加)함에 따라 감소(減少)하였고 전단속도(剪斷速度)가 빠른 경우에 큰 값을 나타냈다. 4. 회복되는 탄성변형율(彈性變形率)은 다짐율이 증가(增加)함에 따라 크게 나타났고 또 변형(變形)이 증가(增加)함에 따라 탄성변형율(彈性變形率)은 약간 감소(減少)하는 경향(傾向)을 나타냈다. 제일재하계수(除一載荷係數)는 다짐율(率)의 증가(增加)에 따라 뚜렷한 경향(傾向)은 보이지 않았으나 일반적(一般的)으로 변형(變形)이 증가(增加)함에 따라 감소(減少)하는 경향(傾向)을 나타냈다.

Keywords