Journal of the Korean Ceramic Society (한국세라믹학회지)

The Korean Ceramic Society (한국세라믹학회)
권호 표지

Preparation of $ZrO_2/Al_2O_3-Mullite$ Composites Using the Silica Sol Infiltration Method

실리카 졸 침투법을 이용한 $ZrO_2/Al_2O_3-Mullite$ 복합체의 제조

  • 현상훈 (연세대학교 세라믹공학과) ;
  • 최지영 (연세대학교 세라믹공학과)
  • Published : 1992.09.01
Download PDF
⟨ Previous Next ⟩

Abstract

ZrO2/Al2O3-Mullite composites were prepared by infiltration of the silica sol to the porous ZrO2/Al2O3 bodies. The porous ZrO2/Al2O3 bodies for infiltration were fabricated using ZrO2 (20wt%)/Al2O3 composite powders synthesized by the emulsion-hot kerosene drying method. The preparation of silica sols was conducted by the hydrolysis-peptization of an alcoholic TEOS solution. When ZrO2/Al2O3-Mullite and ZrO2/Al2O3 composites were sintered at 1$650^{\circ}C$ for 4 hrs, both of them showed an excellent sinterability. As the amount of mullite added in the composites increased, the ratio of the tetragonal phase of zirconia to the monoclinic phase at the room temperature became higher. It was known that values of the fracture toughness of the ZrO2/Al2O3-Mullite composites were about 5.48 MPa.m1/2 much larger than that of the ZrO2/Al2O3 system.

Keywords

References

  1. J. Am. Ceram. Soc. v.59 no.1-2 Fracture Toughness of $Al_2O_3$ with Unstabilized Dispersed Phase N. Claussen
  2. J. Am. Ceram. Soc. v.61 no.1-2 Stress-Induced Transformation of Tetragonal ZrO₂Particles in Ceramic Materices N. Claussen
  3. J. Am. Ceram. Soc. v.64 no.1 Transient Thermal Stress Behavior in $ZrO_2-Toughened\;Al_2O_3$ P.F. Becher
  4. J. Mat. Sci. v.17 no.1 Transformation Toughening F.F. Lange
  5. Adv. Ceram. Mater. v.3 no.6 Influence of TiO₂on the Mechanical Properties at High Temperature of Zirconia-Toughened Alumina M.I. Osendi;B.A. Bender;D. Lewis
  6. Int. J. High Technol Ceram. v.1 no.1 High Purity Mullite Ceramics by Reaction Sintering P.D.D. Rodrigo;P.Boch
  7. J. Am. Cream. Soc. v.55 no.11 Synthesis and Mechanical Properties of Stoichometric Aluminum Silicate (Mullite) K.S. Mazdiyasni;L.M. Brown
  8. J. Am. Ceram. Soc. v.66 no.10 Effect of Drop Height on Critical Temperature Difference (△Tс) for Brittle Ceramics Subjected to Thermal Shock by Quenching into Water J.P. Singh
  9. J. Am. Ceram. Soc. v.58 no.3-4 Creep of Polycrystalline Mullite P.A. Lessing
  10. J. Am. Ceram. Soc. v.60 no.3-4 High-Temperature Mechanical Properties of Mullite Under Compression P.C. Dokko
  11. J. Am. Ceram. Soc. v.66 no.10 Mechanical Properties of Mullite T. Mah;K.S. Mazdiyesni
  12. J. Am. Ceram. Soc. v.73 no.7 Chemical-Vapor-Infiltrated Silicon Nitride, Boron Nitride, and Silicon Carbide Matrix Composites R.D. Veltri;F.S. Galasso
  13. Am. Ceram. Soc. Bull. v.65 no.2 Synthesis of Fiber-Reinforced-SiC Composites by Chemical Vapor Infiltration D.P. Stinton;A.J. Caputo;R.A. Lowden
  14. J. Am. Ceram. Soc. v.73 no.1 Ceramic-Metal Composite Produced by Melt Infiltration C. Toy;W.D. Scott
  15. Advance in ceramics;Science and Technology of Zrconia Ⅲ v.24 A Novel Technique for the Surface Modification of Y-TZP S.J. Glass;D.J. Green;S. Somya(Ed.);N. Yamamoto(Ed.);H. Hanagida(Ed.)
  16. Ceramic Transactions;Ceramic Powder ScienceⅡ v.1B Fabrication of Multiphase Pariculate Ceramics by Infiltration into Powder Compacts S.J. Glass;D.J. Green;G.L. Messing(ed.);E.R. Fuller Jr.(ed.);H. Hausner(ed.)
  17. Adv. Ceram. Mater. v.2 no.2 Surface Modification of Ceramics by Partial Intiltration SJ. Glass;PJ. Green
  18. J. Am. Ceram. Soc. v.73 no.7 Pressureless Sintering of SiC-Whisker-Reinforced $Al_2O_3$ Composites: II, Effects of Sintering Additives and Green Body Infiltration H.W. Lee;M.D. Sacks
  19. J. Am. Ceram. Soc. v.71 no.4 Preparation of SiO₂Glass from Model Powder Compacts: Ⅲ, Enhanced Densification by Sol Infiltration M.D. Sacks;S.D. Vora
  20. J. Am. Ceram. Soc. v.72 no.11 Mullite/Alumina Particulate Composites by Infiltration Processing B.R. Marple;DJ. Green
  21. J. Am. Ceram. Soc. v.43 no.12 Mullite/Alumina Particulate Composite by Infiltration Processing: Ⅱ, Infiltration and Characterization B.R. Marple;D.J. Green
  22. J. Korean Ceramic. Soc. v.25 no.3 Preperation of $Al_2O_3-ZrO_2$ Composite Powders by the Use of Emulsion: II, Emulsion-Hot Kerosene Drying Method S.H. Hyun;J.G. Paik
  23. M.E. Thesis, Yonsei University Preparation and Characteristics of $Al_2O_3-ZrO_2$ Composite Powders by the Emulsion-Kerosene Drying Method J.G. Paik
  24. J. Am. Ceram. Soc. v.55 no.6 Phase Analysis in Zirconia Systems R.C. Garvie;P.S. Nicholson
  25. J. Am. Ceram. Soc. v.59 no.7-8 Fracture Toughness Determination by Indentation A.G. Evans;E.A. Charles
  26. Ceramurgia Int. v.1 Kinetics of Pressure Sintering and Growth of Ultra Fine Mullite Powder B.B. Ghate;D.P.H. Hasselman;R.M. Springgs
  27. J. Am. Ceram. Soc. v.63 no.1-2 Plastic Deformation of Fine Grained Alumina; Ⅰ, Interface Controlled Diffusional Creep R.M. Cannon;W.H. Rhodes;A.H. Heuer
  28. Acta Metall. v.35 no.5 Microstructure of Mullite/$ZrO_2\;and\;Mullite/Al_2O_3/ZrO_2$ Ceramic Composites J.M. Rincon;T.R. Dinger;G.Thomas;J.S. Moya;M.I. Osendi