한국자동차공학회논문집 (Transactions of the Korean Society of Automotive Engineers)

  • 제4권4호
  • /
  • Pages.58-71
  • /
  • 1996
  • /
  • 1225-6382(pISSN)
  • /
  • 2234-0149(eISSN)
한국자동차공학회 (The Korean Society of Automotive Engineers)
권호 표지

스파크 점화기관의 탄화수소 배출 모델링

Modeling of Hydrocarbon Emissions from Spark Ignition Engines

  • 고용서 (수원대학교 기계공학과)
  • 발행 : 1996.08.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

A model which calculates the hydrocarbon emissions from spark ignition engines is presented The model contains the formation of HC emissions due to both crevices around piston ring top land and oil films on the cylinder wall. The model also considers in-cylinder oxidation and exhaust port oxidation of desorbed HC from crevices and oil films after combustion process. The HC emissions model utilizes the results of SI engine cycle simulation. The model predicts well the trends of HC emissions from the engines when varying engine parameters.

키워드

참고문헌

  1. Combustion and Flame v.40 A numerical study of laminar flame quenching C. K. Westbrook;A. A. Adamczyk;G. A. Lovoie
  2. General Motors Research Publication No. GMR-3925 Hydrocarbon combustion near a cooled wall R. J. Blint;J. H. Bechtel
  3. M.I.T. Fluid Mechanics Laboratory Publications No. 71-10 Time-rosolved measurements of hydrocarbon mass flow rate in the exhaust of a SI engine R. J. Tabaczynski;J. B. Heywood;J. C. Keck
  4. Motortechnische Zeitschrift v.41 Einfluss der Spaltgeometrie and Feuersteg des Kolbens auf die Kohlen-wasserstoff emission bei einem Ottomotor M. Yoshida
  5. SAE Paper No. 830652 A model for adsorption and desorption of fuel vapor by cylinder lubrication oil films and its contribution to hyro-carbon emissions J. C. Dent;P. A. Lakashminarayanan
  6. SAE Paper No. 902169 A Model for Hydrocarbon Emissions form SI Engines J. Schramm;S. C Sorenson
  7. MS Thesis, MIT The Effect of Combustion Chamber Geometry on S. I. Engine Combustion Rates-A Modeling Study S. G. Poulous
  8. Conduction of Heat in Solids H. S. Carslaw;J. C. Jaeger
  9. SAE Paper No. 820088 Flow in the Piston-Cylinder-Ring Crevices of a Spark-Ignition Engine : Effect on Hydrocarbon Emissions, Efficiency and Power M. Namazian;J. B. Heywood
  10. SAE Paper No. 890838 Calculation of Flow in the Piston-Cylinder-Ring Cervices of a Homogeneous-Charge Engine and Comparison with Experiment T-W. Kuo;M. C. Sellnau;M. A. Theobald;J. D. Jones
  11. SAE Paper No. 892085 Modeling of HC emissions Due to Crevice Flows in Premixed-Charge Emgines R. D. Reitz;T-W. Kuo
  12. SAE Paper 740191 Experimental and Theoretical Investigation of Turbulent Burning Model for Internal Combustion Engines N. C. Blizard;J. C. Keck
  13. Combustion and Flame v.39 Further Refinement and Validation of a Turbulent Entrainment Model for Spark-Ignition Engines R. J. Tabaczynski;F. H. Trinker;B. A. S. Shannon
  14. Combustion Science and Technology v.15 Approximate Relationships for the Thermodynamic Properties of Hydrocarbon-Air Combustion Products M. K. Martin;J. B. Hyewood
  15. SAE Paper 670931 A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine G. Woschni
  16. Tables of Thermodynamic and Transport Properties J. Hilsenrath;H. J. Hoge;C. W. Beckett;J. F. Masi;W. S. Benedict;R. L. Nuttall;L. Fano;Y. S. Toulloukian;H. W. Wooley
  17. Combustion Science and Technology v.23 Correlations for the Viscosity and Prandtl Number of Hydrocarbon-Air Combustion Products S. H. Mansouri;J. B. Heywood
  18. Combustion and Flame v.38 Laminar Burning Velocity of Propane-Air Mixtures at High Temperature and Pressure M. Metahalchi;J. C. Keck
  19. MIT Dept. of Mechanical Engineering, SM Thesis Laminar Burning Speed Measurements of Indolene-Air-Diluent Mixtures at High Pressures and Temperature D. B. Rhodes
  20. Computer Solution of Ordinary Differential Equations : The Initial Value Problem L. F. Shampine;M. K. Gordon