대한기계학회논문집A (Transactions of the Korean Society of Mechanical Engineers A)

  • 제21권1호
  • /
  • Pages.83-92
  • /
  • 1997
  • /
  • 1226-4873(pISSN)
  • /
  • 2288-5226(eISSN)
대한기계학회 (The Korean Society of Mechanical Engineers)
권호 표지
DOI QR코드

DOI QR Code

동계 소결마찰재 개발에 관한 연구

A Study on the Development of Cu-based Sintered Friction Materials

  • 이종형 (금오공과대학교 생산기계공학과) ;
  • 최병호 (금오공과대학교 재료공학과) ;
  • 김정 (금오공과대학교 재료공학과)
  • Lee, Jong-Hyung ;
  • Choi, Byung-Ho (Department of Materials Science and Engineering, Kumoh National University of Technology) ;
  • Kim, Jeong (Department of Materials Science and Engineering, Kumoh National University of Technology)
  • 발행 : 1997.01.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

In a study on the development of Cu-based sintered friction materials, the specimens pressed with various compacting pressures $(3-6 ton/cm^2/)$ have been evaluated to find the optimum condition of compacting pressure. As compacting pressure increased up to $(5 ton/cm^2/)$, mechanical properties such as density, hardness, bending strength, wear and coefficient of friction, etc. improved remarkably, but up to 6 ton/cm$^{2}$, decreased slightly because of traps of gases and water vapors in specimen. Disk assembly composed of 12 pieces of Cu-based friction materials has been compared with one of asbestos-and nonasbestos-based friction materials. In dynamic and driving tests to find burst spin strength, corrosion area rate and friction properties, etc., Cu-based sintered friction materials showed better properties than the others, especially in severe conditions because oxides such as $Cu_2O; and; SnO_2$ in the friction surface of friction materials were formed.

키워드