한국생산제조학회지 (Journal of the Korean Society of Manufacturing Technology Engineers)

  • 제8권4호
  • /
  • Pages.45-51
  • /
  • 1999
  • /
  • 2508-5093(pISSN)
  • /
  • 2508-5107(eISSN)
한국생산제조학회 (The Korean Society of Manufacturing Technology Engineers)
권호 표지

냉간 인발된 쾌삭강의 칩절단특성

Chip Breaking Characteristics of Cold-Drawn Free Machining Steel

  • 발행 : 1999.08.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

In this study to assess chip breaking characteristics of cold-drawn free machining steels a newly developed non-dimensional parameter chip breaking index CB has been adopted. And for comparison with free machining steels chip breaking characteristics of conventional carbon steels were investigated. Properly controlled chips were produced with the CB value of 0.05-0.2 regardless of steel types. In case of cold-drawn free machining steels however cycle times of chip breaking are relatively shorter than those of conventional steels. And properly controlled chips were obtained from wider range of feed rate.

키워드

참고문헌

  1. Metal Cutting Machining Tools. v.1 A Comprehensive Literature Survey of Chip in Turning Process Worthington, B.
  2. Annals of the CIRP v.28 no.2 Present Knowledge of Chip Control Kluft, W.;Konig, W.;Luttervelt, C.A.;Nakawama, K;Pkelharing, A. J.
  3. Annals of the CIRP v.40 no.1 Chip control in cut-off tools Rotberg.J.;Ber. A.;Wertheim, R.
  4. 대한기계학회논문집 v.16 no.6 신형 칩절단구에 관한 실험적 연구(Ⅰ) 손명환;이호철
  5. Chip Breaking-a Stufy of Three Dimensional Chip Flow Henriksen, E. K.
  6. Trans. of JSME v.5;34 no.7 A Study of the Chip Breaker Nakayama, K.
  7. Annals of the CIRP v.39 no.1 On the Controllability of Chip Breaking Cycles and Modes of Chip Breaking in Metal machining Jawahir, I. S.
  8. 대한기계학회논문집 A권 v.22 no.11 칩절단지수에 의한 칩절단특성 평가 이영문;최원식;장승일;허인호
  9. 5th Draft Proposal, ISO /TC29/WG 22 (Secretatiat 37) Tool Life Testing with Single-Point Turning Tools ISO
  10. Cutting Tool Engineering Power Reduction through Efficient Chip Control Bator, J. S.
  11. 대한금속학회지 v.34 no.7 Bi-S계 쾌삭강의 고온연성에 대한 열간압연 및 Bi의 영향 조삼규