감압용 배수탱크내의 분기형 증기분사기의 유동특성에 관한 연구

A Study on Flow Characteristics of Branch Type Sparger in Drain Tank for Depressurization

  • 발행 : 2001.05.01

초록

A numerical analysis on branch type sparger in drain tank for depressurization is performed to investigate the flow characteristics due to the change of design factor. As the result of this study, sparger\\`s flow resistance coefficient(K) is 3.53 at the present design condition when engineering margin for surface roughness is considered as 20%, and flow ratio into branch pipe ($Q_s/Q_i$) is 0.41. The correlation for calculating flow resistance coefficients as design factor is presented. Flow resistance coefficient is increased as section area ratio of branch pipe for main pipe and outlet nozzle diameter of main pipe decreasing, but the effects of branch angle and inlet flow rate of main pipe are small. As the change rate of ($Q_s/Q_i$)becomes larger, the change rate of flow resistance coefficient increases. The rate of pressure loss has the largest change as section area ratio changing. The condition of maximum flow resistance in sparger is when the outlet nozzle diameter ratio of main pipe ($D_e/D_i$) is 0.167, the section area ratio ($A_s/A_i$) is 0.1 and the branch angle ($\alpha$) is 55^{\circ}$.

키워드

참고문헌

  1. KAERI, TR-962/98 A study on the behavior of bubble in quenching tank and optimal sparger design Kim,H.Y.(et al.)
  2. KOPEC, POSRV-CV-CA410 Flow resistance coefficient for reactor drain tank KOPEC
  3. Proceedings of the KSME 1999 spring annual meeting B The flow characteristic and optimal design for RDT sparger Kim,K.C.;Park,M.H.;Ahn,J.S.
  4. Trans. of the KSME v.11 no.23 Flow characteristics and optimal design for RDT sparger Kim, K. C.;Park, M. H.(et al.)
  5. KOPEC, 98-TR-806 A study on the optimal design and flow characteristic of RDT sparger Kim,K.C.;Park,M.H.;Ahn,J.S.
  6. TR/200, CHAM The PHOENICS reference manual Ludwig,J.C.;Qin,H.Q.;Spalding,D.B.
  7. Handbook of hydraulic resistance Idelchik,I.E.
  8. Prog. in Heat and Mass Transfer v.1 The influence of prandtl number and surface roughness on the resistance of the laminar sublayer to momentum and heat transfer Jayatilleke, C. L. V.
  9. VDI-Forschungsheft 361, Series B v.4 Laws for flow in rough pipes Nikuradse,J.
  10. BHRA Fluid Eng. Internal flow systems Miller, D. S.