DOI QR코드

DOI QR Code

중질유-물 유화연료의 연소특성 평가

An Evaluation on the Combustion Characteristics of Heavy Oil-Water Emulsions

  • 발행 : 2002.12.01

초록

Most researches regarding emulsified fuel were in the areas of emulsifier, emulsified fuel manufacturing and emulsified fuel droplet combustion, but there were little papers published regarding emulsified fuel combustion and boiler efficiency in an industrial boiler. The main purpose of this study is to clarify whether improvements in the boiler efficiency and the reduction of pollutants such as CO, NOx, SOx and smoke exist or not when emulsified fuels are combusted in the commercial boiler. Main experimental parameters were water content in heavy oil , excess $O_2$, and boiler load. The fuels used in this experiment were 0.5 B-C, and 5 kinds of 0.5 B-C/water emulsified fuels. The combustion characteristics of heavy oil and its emulsions with water were investigated in an industrial boiler. The combustion stability was monitored and exhaust gases such as CO, NOx, SOx and smoke were measured with excess $O_2$ and combustion load. In case of emulsified fuel combustion, flame stability was poor and boiler efficiency was lowered by 1.6~5.7%, but emission levels of CO and smoke were improved.

키워드

참고문헌

  1. Jacques, M.T., 1977, 'Transient Heating of an Emulsified Water-in-Oil Droplet,' Combustion and Flame, Vol.292, pp. 77-85 https://doi.org/10.1016/0010-2180(77)90095-5
  2. Cook, D.H. and Law, C.K., 1978, 'A Preliminary Study on the Utilization of Water-in-Oil Emulsions in Diesel Engines,' Combustion Science and Technology, Vol. 18, pp. 217-221 https://doi.org/10.1080/00102207808946854
  3. Law, C.K., 1977, 'A Model for the Combustion of Oil/Water Emulsion Droplets,' Combustion Science and Technology, Vol. 17, pp. 29-38 https://doi.org/10.1080/00102209708946810
  4. Nicholas, J.M., Kennedy, I.M. and Frederick, L.R., 1983, 'Internal Phase Size Effects on Combustion of Emulsions,' Combustion Science and Technology, Vol. 33, pp. 299-307 https://doi.org/10.1080/00102208308923682
  5. Pyon, D. Y., Cho, J. Y., Baek, S. W., Ahn, K. Y., 1997, 'Combustion and Microexplosion of Al/Liquid Fuel Slurry Droplets(I),' Transactions of KSME (Part B), Vol. 21, No. 12, pp. 1576-1585
  6. Gollahalli, S.R., Rasmussen, M.L. and Moussavi, S.J., 1981, 'Combustion of Drops and Sprays of No. 2 Diesel Oil and Its Emulsion with Water,' Eighteenth Symposium (International) on Combustion, pp. 349-360
  7. Ballester, J.M., Fueyo, N. and Dopazo, C., 1995, 'Detailed Measurements in Heavy Oil and Oil/Water Emulsion Flames,' Combustion Science and Technology, Vol. 106, pp. 383-391 https://doi.org/10.1080/00102209508907788
  8. Gollahalli, S.R., Nasrullah, M.K. and Bhashi, J.H., 1984, 'Combustion and Emission Characteristics of Burning Sprays Residual Oil and Its Emulsions with Water,' Combustion and Flame, Vol. 55, pp. 93-103 https://doi.org/10.1016/0010-2180(84)90152-4
  9. SK Corporation, 1995, An Introduction to Heavy Fuel Oil, pp. 61-90
  10. Korea Petroleum Institute, 'The Specification and Quality of Petroleum Products,' 1999, pp. 76-82
  11. Lee, Y. I., Han. J. S., 2001, 'A Study on the Spray Characteristics of Hydrocarbon-fuels with Viscosity Variations,' ILASS-Korea, Vol. 6/No 3, pp. 23-32
  12. Kojima, Sakai, Yokugawa, 1994, 'Fuel Oil of Large-scale Marine Diesel Engine-Usage of Low Quality Fuel Oil and Air Pollution,' Sanhaedang, pp. 208-232
  13. Lee, Y. I., 1996, 'The Countermeasures to Reduce Nitric Oxides,' SK Corporation, pp. 26-48
  14. Ballester, J.M., Fueyo, N. and Dopazo, C., 1996, 'Combustion Characteristics of Heavy Oil-Water Emulsions,' Fuel, Vol. 75, No. 6, pp. 695-705 https://doi.org/10.1016/0016-2361(95)00309-6
  15. Gulyurthu, I., Lopes, H. and Cabrita, I., 1996, 'The Determination of Emissions of Pollutants from Burning Waste Oils,' Fuel Vol. 75 No. 8, pp. 940-944 https://doi.org/10.1016/0016-2361(96)00051-8
  16. Barreiros, I. and Cavalho, M.G., 1993, 'Combustion of the Near Burner Region and Measurements of NOx and Particulates Emissions in Heavy Fuel Oil Spray Flames,' Combustion and Flame, Vol. 92, pp. 231-240 https://doi.org/10.1016/0010-2180(93)90035-2
  17. Stephen, C. Wood, 1994, 'Select the Right NOx Control Technology,' Chemical Engineering Progress Vol. 90/No. 1, pp. 32-38
  18. Ashutosh Garg, 1994, 'Air Staging, Fuel Staging, and Internal Flue Gas Recirculation are among the Design Features that Help Reduce Nox Emissions,' Chemical Engineering Progress Vol. 90/No. 1, pp. 46-49