링형 초음파모터의 모드선정에 따른 진동특성 해석

The Vibration Characteristic Analysis by Mode Variation of Ring Type Ultrasonic Motor

  • 발행 : 2004.05.01

초록

This paper suggested the vibration characteristic improvement by variation mode of ring type ultrasonic motor. Design for the piezoelectric ceramic and elastic body of stator were calculated by the finite element method(FEM) that consider the resonance frequency, vibration mode and coupling efficiency etc. Through the result of vibration analysis from 6 order mode to 8 mode, the 7 order mode was gained very an excellent results that it was the coupling efficient, minimum power loss and bending vibration value. Here over 7 order mode, this paper was acquired that an output current for input voltage was very a large increased results. The result of vibration calculation, from thickness 0.5[mm] to 2[mm], knew the fact that the vibration displacement at 0.5[mm] is an high value too. From such result, this paper was manufactured the ultrasonic motor of outer diameter 5O[mm] , inter 22[mm] having the about 43.86[KHz] resonance frequency. We have gated that a simulation result is 42.2[KHz] and an experiment result is 43.86[KHzl The propriety of this paper was established though comparison. investigation of simulation and experiment result.

키워드

참고문헌

  1. Toshiku Sahida and Takashi Kenjo, 'An Introduction to Ultrasonic Motor', Oxford Science Publications, pp.117-124, 1993
  2. Hiroshi Hirata and Sadayuki Ueha, 'Design of a Traveling Wave Type Ultrasonic Motor', IEEE Trans. Utrason. Ferro-elect. Freq. Cont., vol. 42, no. 2, pp.225-231, 1995 https://doi.org/10.1109/58.365236
  3. S.Ueha, Y.Tomikawa, M.Kurosawa and N.Nakamura, 'Ultrasonic Motors Theory and Application', Clarendon Press, Oxford, 1993
  4. Nesbitt,W.Hagood,IV and Andrew J.McFarland, 'Modeling of a Piezoelectric Rotary Ultrasonic Motor', IEEE Trans. Utrason. Ferroelect. Freq. Cont., vol. 42, no. 2, pp. 210-224, 1995 https://doi.org/10.1109/58.365235
  5. Reinhard Lerch, 'Simulation of Piezoelectric Devicds by Two-and Three-Dimensional Finite Elements', IEEE Trans. Utrason. Ferroelect. Freq. Cont., vol. 37, no. 2, pp. 233-247. 1990 https://doi.org/10.1109/58.55314
  6. Oleg Yu. Zharii, 'Modeling of a Mode Conversion Ultrasonic Motor in the Regime of Slip', IEEE Trans. Utrason. Ferroelect. Freq. Cont., Vol. 40, No. 4, pp. 411-417, 1993 https://doi.org/10.1109/58.251291
  7. William T.Thomson, 'Theory of Vibration with Applications', Prentice-Hall Inc., 1996
  8. Kenji Nishibori, Shigeru Okuma, Hirohisa Obata and Setsuya Kondo, 'Robot Hand with Fingers using Vibration-Type Ultrasonic Motors ( Driving Characteristics)', IEEE Trans. AMC'96-MIE, pp.97-102, 1996 https://doi.org/10.1109/AMC.1996.509387
  9. N.Lamberti, A.Iula and M.Pappalardo, 'A Piezoelectric Motor using Flexural Vibration of a Thin Piezoelectric Membrane', IEEE Transaction on Ultrasonics, Ferroelectrics, and Frequency control, vol. 45, no. 1, pp. 23-28, January 1998 https://doi.org/10.1109/58.646901
  10. M.Brissaud, 'Characterization of Piezoceramics', IEEE Transaction on Ultrasonics, Ferroelectrics, and Frequency Control, vol. 38, no. 6, pp. 603-617, November 1991 https://doi.org/10.1109/58.108859
  11. Under Revision, 'An American National Standard IEEE Standard on Piezoelectricity', ANSI/IEEE Std 176, pp.9-54, 1987
  12. 백수현, 박기준, 김승호, 정현규, '로봇 손 구동용 초음파 모터의 설계', 대한전기학회, 대한전기학회 하계학술대회 논문집, pp. 121-123, 1999
  13. 백수현, 김용, 윤신용, 박기준, '링형 초음파 모터의 고정자해석 및 구동', 동국대학교 산업기술연구원 제14 논문집, pp.46-58, 2002