An Experimental Study on the Characters of Bullet Proof for Al and Ti Alloy

Al합금과 Ti합금의 방탄특성에 관한 실험적 연구

  • Sohn Se Won (Department of Mechanical and Aerospace Engineering, Kon-Kuk University)
  • 손세원 (건국대학교 기계항공공학부)
  • Published : 2005.07.01

Abstract

In order to investigate the characteristics of penatration and the effect of surface treatment in A15052-H34, Al5082-Hl31 and titanium alloy laminates which were treated by anodizing and PVD(Physical Vapor Desposition) method, ballistic tests were conducted. Thickness of surface membrane in A15052-H34, Al5082-Hl31, were $25{\mu}m$ and that of titanium $0.9{\mu}m$ respectively. Surface hardness test was conducted using micro Vicker's hardness tester. Resistance to penetration is determined by the protection ballistic limit(V50), a statistical velocity with $50\%$ probability for complete penetration. Fracture behaviors and ballistic tolerance, described by penetration modes, are observed from the results of V50 test and Projectile Through Plate(PTP) test at velocities greater than protection ballistic limit, respectively. Present experimental results derived from this research help to optimize laminate impact behavior by varing the laminate thickness and surface treated materials.

Keywords

References

  1. S. W. Sohn and S. H. Hong, 'Research Trends on the Ballistic Protection Materials and Development of Bullet-proof Helmet,' Journal of the Korean Society of Precision Engineering, Vol.19, No.7, pp.7-19, 2003
  2. B. J. Kim and S. J. Ha, 'Crashworthiness Design Concepts for the Improved Energy Absorbing Performance of an Aluminum Lightweight Vehicle Body,' Transactions of KSAE, Vol.11, No.3, pp.155-162, 2003
  3. M. E. Backman and W. Goldsmith, 'The Mechanics of Penetration of Projectiles into Target,' International Journals of Engineering Science, Vol.16, pp.1-99, 1978 https://doi.org/10.1016/0020-7225(78)90002-2
  4. J. A. Zukas, T. A. T. Nicolas, H. F. Swift, L. B. Greszczuk and DR. Curran, Penetration and Perforation of Solid, Impact Dynamics, John Wiley and Sons, New York, pp.155-183, 1982
  5. S. W. Sohn, H. T. Kim, D. S. Lee, S. H. Hong and M. J. Yoo, 'An Effect of Surface Treatment on a Protection Ballistic Limits in Armor Material,' Journal of the Korean Society of Precision Engineering, Vol.20, N 0.12, 2003
  6. U.S Army Research Laboratory, 'Military Specification MIL-A-12560G, Armor Plate, Steal Wrought, Homogeneous,' Dept. of the Navy, Defence Printing Service, Philadelphia, PA. 1984
  7. U.S Army Research Laboratory, 'Military Standard, V50 Ballistic Test for Armor, MIL-STD-662E,' Dept. of the Navy, Defence Printing Service, Philadelphia, PA. 1984