An Experimental Study on the Seismic Performance of Shear Connections and Rib Plate H Beam to Column Connections

전단접합 및 리브 플레이트로 보강한 H형 보-기둥 접합부의 내진성능에 관한 실험적 연구

  • 오경현 (조선대학교 대학원 건축공학과) ;
  • 서성연 (한라대학교 건축공학과) ;
  • 김성용 (ES건축구조엔지니어링) ;
  • 양영성 (조선대학교 건축학부) ;
  • 김규석 (동국대학교 건축공학과)
  • Received : 2005.06.15
  • Accepted : 2005.09.28
  • Published : 2005.10.27

Abstract

The postbeam joint connection of the existing steel structure moment flexible frame system did not produce sufficient seismic resistance during the earthquakes in Northridge and Kobe, and it sustained brittle fracturing on the joint connection. This study was performed to execute the high-tensile bolt share connection of H-beams web and the full-scale experiment as a parameter of the existing reinforcement of H-flange rib, by making the shape of the existing joint connection. This experiment was performed to determine the extent of the decrease of the number of high-tensile bolts and how to improve workability of the two-phase shear connection of web beam. In addition, this study was performed to enhance the seismic resistant capacity through the enforcement of rib plates. As a result of the experiment of two-phase shear connection of H-beam web and of joint connection to be reinforced by rib plates, the results of this study showed that the initial stiffness, energy-dissipation capacity, and rotational capacity of plasticity was higher than the existing joint connection. As to the rate of increasing the strength and deformation capacity, there were differences between the tension side and compression side because of the position of shear tap. However, as a whole, they have shown excellent seismic resistant capacity. Also, all the test subjects exceeded 4% (rate of delamination), about 0.029 rad (total plastic capacity), and about 130% (maximum strength of joint connection) of fully plastic moment for the original section. Accordingly, this study was considered as it would be available in the design more than the intermediate-level of moment flexible frame.

기존 강구조 모멘트연성골조시스템의 기둥-보 접합부는 노스리지 지진과 고베 지진시 충분한 내진성능을 발휘하지 못하고 접합부에서 취성파괴가 발생하였다. 본 논문은 기존 접합부의 형상을 변화하여 H형강보 웨브의 고장력볼트 전단접합과 H형 플랜지의 리브보강 유무를 변수로 한 실대형 실험을 실시하였다. 실험목적은 보웨브의 2면전단접합으로 고장력 볼트수 감소와 시공성 향상을 기대하며, 리브플레이트 보강을 통해 내진성능을 향상시키고자 한다. H형강 보웨브의 2면전단접합과 리브플레이트로 보강한 접합부 실험결과, 기존 접합부보다 초기강성, 에너지 소산능력 및 소성회전능력이 높게 나타났으며, 내력상승률 및 변형능력은 전단탭의 위치로 인해 인장측과 압축측이 다소 차이를 보이고 있으나 전체적으로 우수한 내진성능을 나타냈다. 그리고 모든 시험체가 층간변위비 4%, 총소성회능력 약 0.029rad이상 및 접합부 최대내력이 원단면보 전소성모멘트의 약 130% 이상을 상회하여 중급모멘트연성골조이상의 설계가 가능하리라 사료된다.

Keywords

References

  1. 권건업, 한상환(2004) WUF-B 접합부를 가진 모멘트골조의 내진성능 평가, 대한건축학회 논문집 구조계, 대한건축학 회, 제20권 6호(통권 188호), PP.27-34
  2. 김선민, 오명호, 김명한, 김상대(2005), 철골 모멘트저항골조 보-기둥 접합부 해석 모델링 개발과 비선형 해석, 대한건축학회 논문집 구조계, 대한건축학회, 제21권 4호(통 권 198호), PP.73-81
  3. 오명호, 이창환, 김명한, 김대중, 김상대(2005), SC 합성 기 둥-철골 보 접합부의 내진성능에 관한 실험적 연구, 대한건축학회 논문집 구조계, 대한건축학회, 제21권 3호 (통권 197호), PP.85-94
  4. 오명호, 정종현, 전상우, 김진호, 박순규(2002) 실물실험을 통한 관통형 볼트를 이용한 콘크리트 충전각형 강관 접 합부의 내진 성능 분석 연구, 대한건축학회 논문집 구조계, 대한건축학회, 18권 9호(통권 167호), PP.55-60
  5. 이대용(2004), WUF-B 모멘트 접합부에서의 패널존 거동고 AISC 설계기준, 한국강구조학회지, 한국강구조학회, 제 16권 4호, PP.64-76
  6. 이철호(2002) 용접 철골모멘트접합부 내진성능 향상 방법에 관한 소고, 한국강구조학회 학회지, 제14권 2호, PP.50-61
  7. 이철호, 윤태호(1999) 용접 철골모멘트 접합부의 전단력 전 달경로의 해석적 검토 대한건축학회 논문집 구조계, 대 한건축학회, 15권 12호(통권134호), PP.31-40
  8. 이철호, 이재광, 정종현, 오명호, 구은숙(2002) 리브로 보강 된 철골모멘트 접합부 제진거동에 관한 실험적 연구, 한국강구조학회 논문집, 한국강구조학회, 제14권 4호, PP.499-508
  9. 이철호, 전상우, 김진호(2002) RBS 철골모멘트접합부의 내 진거동평가를 위한 반복재하 실물대 실험, 한국강구조학회 논문집, 한국강구조학회, 제14권 4호, PP.557-566
  10. 최성모, 윤여상, 김요숙, 김진호(2003) 이형 하부다이아프램 으로 보강된 각형 CFT 기둥-보 접합부의 내진성능에 관 한 연구, 한국강구조학회 논문집, 한국강구조학회, 제15 권 5호 PP.579-589
  11. 한상환, 권건업(2003), WUF-B 접합부의 내진성능평가 (2) WUF-B 접합부의 반복가력 실험, 대한건축학회 논문집 구조계, 제19권 11호(통권 181호), PP.41-47
  12. 한상환, 권건업(2003), WUF-B 접합부의 내진성능평가 (1) WUF-B 접합부의 반복가력 실험, 대한건축학회 논문집 구조계, 제19권 11호(통권 181호), PP.33-40
  13. American Institutenof Steel Construction(AISC) (1997), Semic Provisions for S tructural Steel Building, AISC, Chicago Illions
  14. EUROCODE NO.3(1992), Design of Steel Structures, Commision dif the European Communities
  15. Japanese Society of steel construction (1997), Kobe Earthquake Damage to steel moment connection ands suggested improvement., JSSC technical report, No.39
  16. The SAC Joint Venture Partnership of Structural Engineers Association California(1996), Technical Report: Expermental Investigations of Beam- Column Subassemblages part 1-2, SAC Joint Venture
  17. SAC(2000), Seismic Design Crtienia for New Moment -Resistring Steel Frame Construction, Roport No. FEMA 350, SAC Joint Venture, Sacramento, CA