DOI QR코드

DOI QR Code

Vibration isolation with smart fluid dampers: a benchmarking study

  • Batterbee, D.C. (Department of Mechanical Engineering, The University of Sheffield) ;
  • Sims, N.D. (Department of Mechanical Engineering, The University of Sheffield)
  • Received : 2004.06.19
  • Accepted : 2005.04.27
  • Published : 2005.09.25

Abstract

The non-linear behaviour of electrorheological (ER) and magnetorheological (MR) dampers makes it difficult to design effective control strategies, and as a consequence a wide range of control systems have been proposed in the literature. These previous studies have not always compared the performance to equivalent passive systems, alternative control designs, or idealised active systems. As a result it is often impossible to compare the performance of different smart damper control strategies. This article provides some insight into the relative performance of two MR damper control strategies: on/off control and feedback linearisation. The performance of both strategies is benchmarked against ideal passive, semi-active and fully active damping. The study relies upon a previously developed model of an MR damper, which in this work is validated experimentally under closed-loop conditions with a broadband mechanical excitation. Two vibration isolation case studies are investigated: a single-degree-of-freedom mass-isolator, and a two-degree-of-freedom system that represents a vehicle suspension system. In both cases, a variety of broadband mechanical excitations are used and the results analysed in the frequency domain. It is shown that although on/off control is more straightforward to implement, its performance is worse than the feedback linearisation strategy, and can be extremely sensitive to the excitation conditions.

Keywords

References

  1. Atray, V. S. and Roschke, P. N. (2004), "Neuro-fuzzy control of railcar vibrations using semiactive dampers", Computer-Aided Civil and Infrastructure Engineering, 19(2), 81-92. https://doi.org/10.1111/j.1467-8667.2004.00339.x
  2. Cebon, D. and Newland, D. E. (1984), "The artifical generation of road surface topography by the inverse FFT method", Proceedings of the 8th IAVSD Symposium on the Dynamics of Vehicles on Roads and Railway Tracks, Cambridge, Massachussets, Swets and Zeitlinger, 29-42.
  3. Cebon, D., Besinger, F. H. and Cole, D. J. (1996), "Control strategies for semi-active lorry suspensions", Proceedings of the Institution of Mechanical Engineers, Part D: J. Automobile Eng., 210, 161-178. https://doi.org/10.1243/PIME_PROC_1996_210_256_02
  4. Choi, Y. T. and Wereley, N. M. (2003), "Vibration control of a landing gear system featuring electrorheological/magnetorheological fluids", J. Aircraft, 40(3), 432-439. https://doi.org/10.2514/2.3138
  5. Crolla, D. A. (1996), "Vehicle dynamics: theory into practice", Proceedings of the Institution of Mechanical Engineers, Part D: J. Automobile Eng., 210, 83-94.
  6. Dyke, S. J., Spencer, B. F. J., Sain, M. K. and Carlson, J. D. (1998), "Experimental study of MR dampers for seismic protection", Smart Mater. and Struct., 7(5), 693-703. https://doi.org/10.1088/0964-1726/7/5/012
  7. Guo, D. L., Hu, H. Y. and Yi, J. Q. (2004), "Neural network control for a semi-active vehicle suspension with a magnetorheological damper", JVC/J. Vib. and Cont., 10(3), 461-471. https://doi.org/10.1177/1077546304038968
  8. Jansen, L. M. and Dyke, S. J. (2000), "Semiactive control strategies for MR dampers: Comparative study", J. Eng. Mech., 126(8), 795-803. https://doi.org/10.1061/(ASCE)0733-9399(2000)126:8(795)
  9. Jolly, M., Bender, J. W. and Carlson, J. D. (1998), "Properties and applications of commercial magnetorheological fluids", SPIE 5th International Symposium on Smart Structures and Materials, San Diego, 3327, 262-275.
  10. Karnopp, D., Crosby, M. J. and Harwood, R. A. (1974), "Vibration control using semi-active force generators", J. Eng. for Industry, 96, 619-626. https://doi.org/10.1115/1.3438373
  11. Lam, A. H. F. and Liao, W. H. (2003), "Semi-active control of automotive suspension systems with magnetorheological dampers", Int. J. Vehicle Design, 33(1-3), 50-75. https://doi.org/10.1504/IJVD.2003.003652
  12. Lord Corporation (2004), http://www.lord.com/Default.aspx?tabid=761.
  13. Robson, J. D. (1979), "Road surface description and vehicle response", Int. J. Vehicle Design, 1(1), 25-35.
  14. Sharp, R. S. and Hassan, S. A. (1986), "The relative performance capabilities of passive, active and semi-active car suspension systems", Proceedings of the Institution of Mechanical Engineers, Part D: J. Automobile Eng., 200, 219-228. https://doi.org/10.1243/PIME_PROC_1986_200_183_02
  15. Simon, D. and Ahmadian, M. (2001), "Vehicle evaluation of the performance of magnetorheological dampers for heavy truck suspensions", J. Vib. Acoustics, 123, 365-375. https://doi.org/10.1115/1.1376721
  16. Sims, N. D., Stanway, R. and Johnson, A. R. (1999a), "Vibration control using smart fluids: A state of the art review", The Shock and Vib. Digest, 31(3), 195-203. https://doi.org/10.1177/058310249903100302
  17. Sims, N. D., Peel, D. J., Stanway, R., Johnson, A. R. and Bullough, W. A. (1999b), "The electrorheological long stroke damper: A new modelling technique with experimental validation", J. Sound Vib., 207-227.
  18. Sims, N. D., Peel, D. J., Stanway, R., Bullough, W. A. and Johnson, A. R. (1999c), "Controllable viscous damping: An experimental study of an electrorheological long stroke damper under proportional feedback control", Smart Materials and Structures, 8, 601-605. https://doi.org/10.1088/0964-1726/8/5/311
  19. Sims, N. D., Stanway, R., Peel, D. J., Bullough, W. A. and Johnson, A. R. (2000), "Smart fluid damping: Shaping the force/velocity response through feedback control", Journal of Intelligent Material Systems and Structures, 11, 945-949. https://doi.org/10.1106/M9TP-A5DR-FULX-119B
  20. Sims, N. D., Stanway, R. and Johnson, A. R. (2001), "Experimental testing and control of an ER long-stroke vibration damper", Smart Structures and Materials: Smart Systems for Bridges, Structures and Highways, Proceedings of SPIE, 4330, 218-227.
  21. Sims, N. D. and Stanway, R. (2003), "Semi-active vehicle suspension using smart fluid dampers: A modelling and control study", Int. J. Vehicle Design, 33(1-3), 76-102. https://doi.org/10.1504/IJVD.2003.003568
  22. Sims, N. D. and Wereley, N. M. (2003), "Modelling of Smart fluid dampers", Smart Structures and Materials: Passive damping and isolation, SPIE, 5052, 163-175.
  23. Sims, N. D., Holmes, N. J. and Stanway, R. (2004), "A unified modelling and model updating procedure for electrorheological and magnetorheological dampers", Smart Mater. and Struct., 13, 100-121. https://doi.org/10.1088/0964-1726/13/1/012
  24. Welch, P. D. (1967), "The use of fast fourier transform for the estimation of power spectra: A method based on time averaging over short, modified periodograms", IEEE Trans. Audio Electroacoust, AU-15, 70-73.
  25. xPC Target (2002), The Math Works, Inc., 3 Apple Hill Drive, Natick, MA.
  26. Xu, Z. D., Shen, Y. P. and Guo, Y. Q. (2003), "Semi-active control of structures incorporated with magnetorheological dampers using neural networks", Smart Mater. and Struct., 12(1), 80-87. https://doi.org/10.1088/0964-1726/12/1/309
  27. Yi, F., Dyke, S. J., Caicedo, J. M. and Carlson, J. D. (2001), "Experimental verification of multiinput seismic control strategies for smart dampers", J. Eng. Mech., 127(11), 1152-1164. https://doi.org/10.1061/(ASCE)0733-9399(2001)127:11(1152)
  28. Yoshida, O. and Dyke, S. J. (2004), "Seismic control of a nonlinear benchmark building using smart dampers", J. Eng. Mech., 130(4), 386-392. https://doi.org/10.1061/(ASCE)0733-9399(2004)130:4(386)

Cited by

  1. Hardware-in-the-loop simulation of magnetorheological dampers for vehicle suspension systems vol.221, pp.2, 2007, https://doi.org/10.1243/09596518JSCE304
  2. Temperature Sensitive Controller Performance of MR Dampers vol.20, pp.3, 2009, https://doi.org/10.1177/1045389X08093824
  3. A magnetorheological fluid embedded pneumatic vibration isolator allowing independently adjustable stiffness and damping vol.20, pp.8, 2011, https://doi.org/10.1088/0964-1726/20/8/085025
  4. Functionally upgraded passive devices for seismic response reduction vol.4, pp.6, 2008, https://doi.org/10.12989/sss.2008.4.6.741
  5. Vibration isolation using nonlinear damping implemented by a feedback-controlled MR damper vol.22, pp.10, 2013, https://doi.org/10.1088/0964-1726/22/10/105010
  6. Experiment of an ABS-type control strategy for semi-active friction isolation systems vol.8, pp.5, 2005, https://doi.org/10.12989/sss.2011.8.5.501
  7. Improving the seismic performance of reinforced concrete frames using an innovative metallic-shear damper vol.28, pp.3, 2021, https://doi.org/10.12989/cac.2021.28.3.275