A Study of the Printability Coefficients on the Newspaper ( II ) - Limiting printed density ($D_{\infty}$) and printed density smoothness constant m value-

신문용지의 인쇄적성 계수에 관한 연구 ( 제 2 보 ) -최대 잉크 색 농도 ($D_{\infty}$), 색 농도 평활성 계수 ${\ulcorner}m{\lrcorner}$ 값 -

  • Ha, Young-Baeck (Division of Image & Information, College of Engineering, Pukyong National University) ;
  • Kim, Chang-Keun (Changgang Institute of Paper Science and Technology, Kangwon National University) ;
  • Oh, Sung-Sang (Graphic Arts Media, Shin Gu College) ;
  • Lee, Yong-Kyu (Dept. of Paper Science and Engineering, College of Forest Science, Kangwon National University) ;
  • Youn, Jong-Tae (Division of Image & Information, College of Engineering, Pukyong National University)
  • 하영백 (부경대학교 공과대학 화상정보공학부 인쇄공학과) ;
  • 김창근 (강원대학교 창강 제지 기술연구소) ;
  • 오성상 (신구대학 그래픽아츠 미디어과) ;
  • 이용규 (강원대학교 산림과학대학 제지공학과) ;
  • 윤종태 (부경대학교 공과대학 화상정보공학부 인쇄공학과)
  • Published : 2006.06.30

Abstract

Uneven ink transfer of a print can be traced to several causes such as an incomplete contact between the paper surface and ink film, a coarse pattern of a continuous ink film after transfer, uneven absorption, etc. Uneven ink transfer was studied in this points by the Tollenaar. Uneven distributions of printed density are reflected in low ${\ulcorner}m{\lrcorner}$ values of the print. Tollenaar's smoothness coefficient ${\ulcorner}m{\lrcorner}$ value was important factor that deciding printed quality which was easily obtain by densitometry. Limiting print density $D_{\infty}$ that obtained Tollenaar's formulation working as a influence factor at the printed quality. In this study, we obtained limiting print density $D_{\infty}$ and smoothness coefficient ${\ulcorner}m{\lrcorner}$ value of domestic newspapers and foreign newspapers. And we analyzed about properties of the newspaper. The result of this study, smoothness coefficient ${\ulcorner}m{\lrcorner}$ value and limiting print density $D_{\infty}$ showed the good results in the low porosity and low roughness newspaper. Datum which obtained by this study was used as printability factor for the quality control and improvement of domestic newspaper and wished to apply as a basic data for the domestic newspaper quality.

Keywords

References

  1. Carlsson. G. E, 'The Choice of Parameters for Describing Newsprint printability', Paper in the Printing Process, Pergamon Press. Stockholm, pp.105-135 (1965)
  2. Larsson, L. O. and Trollsas, P. O., 'Physical interaction between newsprint and Conventional Inks in Letterpress Printing', Paper in The Printing Processes, Pergamon Press, pp.57-76 (1967)
  3. Simo, K., ' On the printability of Newsprint', Paper in The Printing Processes, Pergamon Press, pp.151-200 (1967)
  4. Loic. C., 'Correlations between some Printability Characteristics of a paper and the Optical density of Printed Solids', Recent Developments in Graphic Arts Research, Pergamon Press, pp.225-253 (1971)
  5. Poujade, J. L., Boixareu, R. and Groult, M., 'New Developments in Newsprint Printability Evaluation', Recent Developments in Graphic Arts Research, Pergamon Press, pp.211-224 (1971)
  6. Hansen. A, -Quality Control in Newspaper Printing-, Advances in Printing Science and Technology, 16, pp.169-179, Norway (1981)
  7. Pauler, N. 'A model for interaction between ink and paper', Advances in Printing Science and Technology, Vol.19, pp. 116-136, Stockholm (1987)
  8. Tollenaar, D. and P. A. H. Ernst, 'Uneven ink transfer on smooth surfaces', Recent Developments in Graphic Arts Research, pp. 139-150, Pergamon Press (1971)
  9. Youn, J. T., Introduction to Printability, pp.223-240, Busan (2004)
  10. Walter W. Roehr, 'The Effect of Certain Fillers on the Printing Properties of Newsprint',Paper in the Printing Process, Pergamon Press, Washington, pp.77-91 (1965)
  11. K. Lovasz, 'Penntration of Ink into Paper', Paper in The Printing Processes, Pergamon Press, pp.25-32 (1967)