ASSESSMENT OF A NEW DESIGN FOR A REACTOR CAVITY COOLING SYSTEM IN A VERY HIGH TEMPERATURE GAS-COOLED REACTOR

  • PARK GOON-CHERL (Department of Nuclear Engineering Seoul National University) ;
  • CHO YUN-JE (Department of Nuclear Engineering Seoul National University) ;
  • CHO HYOUNGKYU (Department of Thermal-Hydraulic Safety Research Korea Atomc Energy Research Institute(KAERI))
  • 발행 : 2006.02.01

초록

Presently, the VHTGR (Very High Temperature Gas-cooled Reactor) is considered the most attractive candidate for a GEN-IV reactor to produce hydrogen, which will be a key resource for future energy production. A new concept for a reactor cavity cooling system (RCCS), a critical safety feature in the VHTGR, is proposed in the present study. The proposed RCCS consists of passive water pool and active air cooling systems. These are employed to overcome the poor cooling capability of the air-cooled RCCS and the complex cavity structures of the water-cooled RCCS. In order to estimate the licensibility of the proposed design, its performance and integrity were tested experimentally with a reduced-scale mock-up facility, as well as with a separate-effect test facility (SET) for the 1/4 water pool of the RCCS-SNU to examine the heat transfer and pressure drop and code capability. This paper presents the test results for SET and validation of MARS-GCR, a system code for the safety analysis of a HTGR. In addition, CFX5.7, a computational fluid dynamics code, was also used for the code-to-code benchmark of MARS-GCR. From the present experimental and numerical studies, the efficacy of MARS-GCR in application to determining the optimal design of complicated systems such as a RCCS and evaluation of their feasibility has been validated.

키워드

참고문헌

  1. M. Ogawa and T. Nishihara, 'Present Status of Energy in Japan and HTTR Project,' Nuclear Engineering and Design, Vol. 233, Issues 1-3, pp. 5-10 (2004) https://doi.org/10.1016/j.nucengdes.2004.07.018
  2. IAEA, 'Heat Transport and Afterheat Removal for Gas Cooled Reactors under Accident Conditions,' IAEA- TECDOC-1163, Vienna (2000)
  3. S. Saito et al., 'Design and Safety Consideration in the High-Temperature Engineering Test Reactor (HTTR),' IAEA-TC-389, Dimitrovgrad (1989)
  4. Wu et al., 'The Design Features of the HTR-10,' Nuclear Engineering and Design, Vol. 218, pp. 25-32 (2002) https://doi.org/10.1016/S0029-5493(02)00182-6
  5. IAEA, 'Current Status and Future Development of Modular High Temperature Gas Cooled Reactor Technology,' IAEA-TECDOC-1198 (2001)
  6. D.A. Dilling et al., 'Passive Decay and Residual Heat Removal in the MHTGR,' IAEA-TECDOC-757, Juelich (1982)
  7. W. J. Lee et al., 'Development of MARS-GCR for Gas-Cooled Reactor Analysis - Incorporation of Gas Properties,' Proceeding of NURETH-10, Seoul, Korea, October (2003)
  8. S. W. Lee et al., 'Preliminary Sensitivity Study on Gas-Cooled Reactor for NHDD System Using MARS-GCR,' Proceeding of Korea Nuclear Society Autumn Meeting, Busan, Korea, October (2005)
  9. PBMR Ltd., 'Reactor Safety Analysis Report of the South-African Pebble-Bed Modular Reactor (PBMR),' Rev. E, Centurion, South-Africa (2000)
  10. S. Kakac, R.K. Shah and W. Aung, Handbook of Singlephase Convective Heat Transfer, A Wiley-Interscience publication (1987)
  11. W. B. Hooper, 'The Two-K Method Predicts Head Losses in Pipe Fittings,' Chemical Engineering, pp. 96-100 (1981)
  12. Frank P. Incropera, David P. DeWitt, Introduction to Heat Transfer, John Wiley & Sons, Third Edition (1996)
  13. Y. Mori and W. Nakayama, 'Study on Forced Convective Heat Transfer in Curved Pipes,' International Journal of Heat and Mass Transfer, Vol. 10, pp. 37-59 (1967) https://doi.org/10.1016/0017-9310(67)90182-2
  14. S. R. Tailby and P.W. Staddon, 'The Influence of $90^{\circ}$ and $180^{\circ}$ Pipe Bends on Heat Transfer from an Internally Flowing Gas Stream,' Heat Transfer, Vol.2 paper No. FC 4.5 (1970)
  15. M. Moshfeghian and K.J. Bell, 'Local Heat Transfer Measurements in and Downstream from a U-bend,' ASME paper No. 79-HT-82 (1979)
  16. G. W. Hogg, 'The Effect of Secondary Flow on Point Heat Transfer Coefficients for Turbulent Flow inside Curved Tubes,' Ph.D. Thesis, Univ. of Idaho (1968)
  17. J. Pruvost, J. Legrand and P. Legentilhomme, 'Numerical Investigation of Bend and Torus Flows, Part I: Effect of Swirl Motion on Flow Structure in U-bend,' Chemical Engineering Science, Vol. 59, pp. 3345 -3357 (2004) https://doi.org/10.1016/j.ces.2004.03.040
  18. S. W. Churchill and H. H. S. Chu, 'Correlating Equations for Laminar and Turbulent Free Convection from a Vertical Plate,' International Journal of Heat and Mass Transfer, Vol. 18, pp. 1323-1329 (1975) https://doi.org/10.1016/0017-9310(75)90243-4
  19. Zukauskas. A.A., Heat Transfer from Tubes in Cross Flow, Adv. Heat Transfer Academic, 8, pp.93-106 (1972)