Abstract
Stereophotogrammetry is a method to extract information of an interested area by constructing a stereo-image from two or more photos. In this study, the stereophotogrammetry was adopted to obtain the joint orientation and trace length from a sampling window and its measurements were compared with the result by a clinocompass and measuring tape to evaluate the applicability of the stereophotogrammetry to rock joint survey. A commercial stereophotogrammetry program, ShapeMetriX 3D, was used for this purpose. Firstly, the accuracy of the measuring method using ShpaeMetrix 3D was evaluated by a model test. Secondly, joint orientations on a rock slope and tunnel were obtained by using ShapeMetriX 3D and compared with the measurement by a clinocompass. Finally. the effect of base-depth ratio in photographing was evaluated by comparing images with various base-depth ratios, and the usefulness of closed-up photographing on a rock exposure to increase the measurement accuracy was tested. The dip and dip direction of each model plane obtained by ShapeMetriX 3D showed an error ranged between $-5^{\circ}\;and\; 5^{\circ}$ on the basis of the results by the measuring tape. Base-depth ratio proved not to influence the analysis result by ShapeMetriX 3D if all the images were taken without any hidden area. The close-up photographing turned out useful to obtain the detailed images and therefore precise result when ShapeMetriX 3D was adopted.
입체사진측량기법이란 대상면에 대하여 두 장 이상의 스테레오 영상을 취득하고 이 영상을 해석함으로써 대상면에 대한 정보론 추출하는 방법이다. 본 연구에서는 기존의 수작업에 의한 암반절리조사 방법에 대한 대안으로서, 입체사진측량기법을 암반절리조사에 적용하여 절리 정보론 추출하였고 그 결과를 비교, 분석함으로써 암반절리조사에의 적용성을 평가하였다. 검증은 실내 모형 시험을 통한 검증과 실제 암반에 대한 검증을 통하여 수행되었다. 현장 적용시 기선거리비가 해석 결과에 미치는 영향을 평가하기 위한 촬영 및 분석을 수행하였고, 해석 자료의 정확도를 향상시키기 위하여 절리 대상면을 분할 확대 촬영하였다. ShapeMetriX 3D프로그램을 이용한 실내 모형 시험 결과, 3차원 공간 좌표의 실측치를 이용한 결과와 비교하여 경사각 및 경사방향에 대하여 모두 ${\pm}5^{\circ}$ 이내의 편차를 보임을 확인하였다. 또한 영상 취득시 폐색 구간이 발생하지 않도록 촬영한다면, 기선거리비가 해석 결과에 미치는 영향이 크지 않음을 알 수 있었다. 따라서 분할 확대 촬영을 통한 취득 자료의 분석은 효율적인 방법으로 판단된다.