Electrohydrodynamic Pumping Characteristics of the Needle-Centered Nozzle Electrode

침심 노즐전극의 전기유체역학적 펌핑 특성

  • 정회원 (경북대 대학원 전기공학과) ;
  • 문재덕 (경북대 전자전기컴퓨터학부)
  • Published : 2008.10.01

Abstract

A cooling system for microelectronics is becoming more important as its surface heat density is projected to reach that of the sun surface. The existing technologies using natural and forced convection are limited to solve the problems. Recently, an electrohydrodynamic driven flow is studied as one of the means to cope with this problems. A new method, utilizing a needle-centered nozzle electrode, has been proposed and investigated. The I-V characteristics of the nozzle electrode for deionized water and silicone oil were significantly different from that of without liquid, which might be due to the liquid drop covered on the nozzle tip by the EHD force acting near the needle tip. Results showed that the liquid pumping rate and flow efficiency of the nozzle electrode were very high, especially for the silicone oil. Theoretical analysis also showed the effectiveness of the needle electrode centered in the ceramic nozzle, which, however, can be a means as a liquid pump.

Keywords

References

  1. F. Pollak, "New Micro-architecture Challenges in the Coming Generation of CMOS Process Technologies," Micro 32, 1999
  2. PC Power and Cooling, Inc., "Rotary fan efficiency for Intel processor fan," January 2002
  3. F. Yang, N.E. Jewell-Larsen, D.L. Brown, K. Pendergrass, D.A. Parker, I.A. Krichtafovitch, A.V. Mamishev, "Corona driven air propulsion for cooling of electronics," XIIIth International Symposium on High Voltage Engineering, pp. 1-4, 2003
  4. R. Mestiri, R. Hadaji, S.B. Nasrallah, "The electrical discharge as a source of a mechanical energy," Desalination, Vol. 220, No. 1/3, pp. 468-475, 2008 https://doi.org/10.1016/j.desal.2007.01.048
  5. M. Rickard, D. Dunn-Rankin, F. Weinberg, F. Carleton, "Maximizing ion-driven gas flows," Journal of Electrostatics, Vol. 64, No. 6, pp. 368-376, 2006 https://doi.org/10.1016/j.elstat.2005.09.005
  6. E. Moreau, G. Touchard, "Enhancing the mechanical efficiency of electric wind in corona discharge," Journal of Electrostatics, Vol. 66, No. 1-2, pp. 39-44, 2008 https://doi.org/10.1016/j.elstat.2007.08.006
  7. H. Tsubone, B. Komeili, S. Minami, G.D. Harvel, K. Urashima, C.Y. Ching, J.S. Chang, "Flow characteristics of dc wire-non-parallel plate electrohydrodynamic gas pump", Journal of Electrostatics, Vol. 66, No. 1-2, pp. 115-121, 2008 https://doi.org/10.1016/j.elstat.2007.09.002
  8. B. Komeili, J.S. Chang, G.D.Harvel, C.Y. Ching, "Electrohydrodynamically Enhanced Capillary Evaporator," International Symposium on New Plasma and Electrical Discharge Applications and on Dielectric Materials, pp. 111-116, 2007
  9. J.L. Li, "EHD spraying induced by the pulsed voltage superimposed to a bias voltage," Journal of Electrostatics, Vol. 65, No. 12, pp. 750-757, 2007 https://doi.org/10.1016/j.elstat.2007.06.005
  10. A. Jaworek, A. Krupa, "Studies of the corona discharge in ehd spraying," Journal of Electrostatics, Vol. 40-41, pp. 173-178, 1997 https://doi.org/10.1016/S0304-3886(97)00033-8
  11. J.-P. Borra, P. Ehouarn, D. Boulaud, "Electrohydrodynamic atomisation of water stabilised by glow discharge-operating range and droplet properties," Journal of Aerosol Science, Vol. 35, No. 11, pp, 1313-1332, 2004 https://doi.org/10.1016/j.jaerosci.2004.05.011
  12. J.S. Eow, M. Ghadiri, "Motion, deformation and break-up of aqueous drops in oil under high electric field strengths," Chemical Engineering and Processing, Vol. 42, No. 4, pp. 259-272, 2003 https://doi.org/10.1016/S0255-2701(02)00036-3
  13. J.K. Walsh, A.W. Weimer, C.M. Hrenya, "Thermophoretic deposition of aerosol particles in laminar tube flow with mixed convection," Journal of Aerosol Science, Vol. 37, No. 6, pp. 715-734, 2007 https://doi.org/10.1016/j.jaerosci.2005.05.017
  14. A. Castellanos, (ed), Electrohydrodynamics, CISM Cources and Lectures No 380, Springer, 1998