DOI QR코드

DOI QR Code

Estimation of viscous and Coulomb damping from free-vibration data by a least-squares curve-fitting analysis

  • Slemp, Wesley C.H. (Virginia Polytechnic Institute and State University) ;
  • Hallauer, William L. Jr. (Virginia Polytechnic Institute and State University) ;
  • Kapania, Rakesh K. (Virginia Polytechnic Institute and State University)
  • 투고 : 2007.01.31
  • 심사 : 2007.05.02
  • 발행 : 2008.05.25

초록

The modeling and parameter estimation of a damped one-degree-of-freedom mass-spring system is examined. This paper presents a method for estimating the system parameters (damping coefficients and natural frequency) from measured free-vibration motion of a system that is modeled to include both subcritical viscous damping and kinetic Coulomb friction. The method applies a commercially available least-squares curve-fitting software function to fit the known solution of the equations of motion to the measured response. The method was tested through numerical simulation, and it was applied to experimental data collected from a laboratory mass-spring apparatus. The mass of this apparatus translates on linear bearings, which are the primary source of light inherent damping. Results indicate that the curve-fitting method is effective and accurate for both perfect and noisy measurements from a lightly damped mass-spring system.

키워드

참고문헌

  1. Coleman, T. and Li, Y. (1996), "An interior, trust region approach for nonlinear minimization subject to bounds", SIAM, J. Optimization, 6(2), 418-445. https://doi.org/10.1137/0806023
  2. Den Hartog, J. P. (1931), "Forced vibrations with combined Coulomb and viscous friction", National Applied Mechanics Meeting, June 15-16, Transactions ASME, 107-115.
  3. Jacobsen, L. and Ayre, R. (1958), Engineering Vibrations, McGraw-Hill, New York, 214-217.
  4. Liang, J.-W. and Feeny, B. (2004), "Identifying Coulomb and viscous friction in forced dual-damped oscillators", ASME, J. Vib. Acoustics, 126(1), 118-125. https://doi.org/10.1115/1.1640356
  5. Liang, J.-W. and Feeny, B.F. (1998), "Identifying Coulomb and viscous friction from free-vibration decrements", Nonlinear Dyn., 16(4), 337-347. https://doi.org/10.1023/A:1008213814102
  6. Meirovitch, L. (2001), Fundamentals of Vibrations, McGraw-Hill, New York, 94-101,103.
  7. Parks, T. (1999), Manual For Model 210/210a Rectilinear Plant Control System, Educational Control Products, Bell Canyon, CA. www.ecpsystems.com.

피인용 문헌

  1. CURVE FITTING FREE-VIBRATION TIME RESPONSE FOR ESTIMATION OF STRUCTURAL DYNAMIC PARAMETERS vol.34, pp.1, 2010, https://doi.org/10.1111/j.1747-1567.2008.00449.x
  2. Rotating a pendulum with an electromechanical excitation vol.70, 2015, https://doi.org/10.1016/j.ijnonlinmec.2014.08.008