DOI QR코드

DOI QR Code

A Method of Improving Isolation Between Tx and Rx Paths in TDD Systems

TDD 시스템에서 송수신 격리도 향상 방법


Abstract

A switch or circulator is used for distinguishing between the paths of transmitter and receiver in TDD systems. If the isolation between Tx and Rx paths is low in TDD systems, the output signal of the ransmitter acts as an interferer to the receiver even if the transceiver operates on the receiver mode. In this paper we propose a method to get high isolation characteristics between transmitting and receiving paths in TDD systems. We implement the module with a proposed improving method to verify the effect of the isolation improvement and the experimental results are presented. The isolation improvement of above 44.8 dB over the frequency bandwidth of 30 MHz is obtained from the implemented isolation improvement module.

TDD 시스템에서는 스위치나 써큘레이터를 이용해서 송수신 경로를 구분한다. 송수신 경로의 격리도가 낮은 경우 송신신호는 수신기에 간섭원으로 작용하며, 수신기의 성능을 악화시킨다. 본 논문에서는 TDD 시스템에서 송신 경로와 수신 경로 사이에 높은 격리도를 갖는 방법을 제안한다. 또한 논문에서 제안한 격리도 향상 방법의 타당성을 검증하기 위해서 제안한 격리도 향상 모듈을 제작하였고, 제작된 격리도 향상 모듈의 특성을 시험하였다. 특성 시험 결과 제작된 격리도 향상 모듈은 30MHz 대역폭에서 44.8dB 이상의 격리도 향상이 있음을 확인하였다.

Keywords

References

  1. WiMax Forum, www.wimaxforum.org
  2. Sanggee Kang, Huimin Lee and Seongyong Hong, "Method of reducing the effects of a delay mismatch variation in a linearization loop," IEE proceeding Antennas, Microwaves & Propagation, vol. 151, no. 5, pp. 455-459, Oct. 2004 https://doi.org/10.1049/ip-map:20040832
  3. Sanggee Kang, Myungsun Song, Huimin Yi and Seongyong Hong, "Adaptive control method for a feedforward amplifier," VTC2004 spring, May 2004