DOI QR코드

DOI QR Code

EFFECTS OF GEOMETRIC PARAMETERS ON NUCLEATE POOL BOILING OF SATURATED WATER IN VERTICAL ANNULI

  • Kang, Myeong-Gie (Department of Mechanical Engineering Education, Andong National University)
  • 발행 : 2009.04.30

초록

Nucleate pool boiling of water in vertical annuli at atmospheric pressure has been studied experimentally and two empirical correlations have been suggested to obtain effects of geometric parameters on heat transfer. Data of the present and the previous tests range over a tube length of 0.50-0.57 m, a diameter of 16.5-34.0 mm, and an annular gap size of 3.7-44.3 mm. Through the analysis, tube bottom confinement (open or closed) has been investigated, as well. The developed correlations predict experimental data within a ${\pm}25%$ error bound. It has been identified that effects of the diameter and the length of heated tubes as well as the annular gap size should be counted into the analyses to estimate heat transfer coefficients accurately.

키워드

참고문헌

  1. M. H. Chun and M. G. Kang, “Effects of Heat Exchanger Tube Parameters on Nucleate Pool Boiling Heat Transfer,” ASME J. Heat Transfer, 120, 468 (1998) https://doi.org/10.1115/1.2824272
  2. M. M. Corletti and L. E. Hochreiter, “Advanced Light Water Reactor Passive Residual Heat Removal Heat Exchanger Test,” Proc. The 1st JSME/ASME Joint Int. Conf. on Nuclear Engineering, Tokyo, Japan, 1991
  3. M. G. Kang, “Pool Boiling Heat Transfer in Vertical Annular Crevices,” Int. J. Heat Mass Transfer, 45, 3245 (2002) https://doi.org/10.1016/S0017-9310(02)00040-6
  4. K. E. Gungor and H. S. Winterton, “A General Correlation for Flow Boiling in Tubes and Annuli,” Int. J. Heat Mass Transfer, 29, 351 (1986) https://doi.org/10.1016/0017-9310(86)90205-X
  5. Z. Liu and R. H. S. Winterton, “A General Correlation for Saturated and Subcooled Flow Boiling in Tubes and Annuli, Based on a Nucleate Pool Boiling Equation,” Int. J. Heat Mass Transfer, 34, 2759 (1991) https://doi.org/10.1016/0017-9310(91)90234-6
  6. G. Sun and G. F. Hewitt, “Experimental Studies on Heat Transfer in Annular Flow,” Proc. The 2nd European Thermal-Sciences and 14th UIT National Heat Transfer Conf., 1996
  7. S. C. Yao and Y. Chang, “Pool Boiling Heat Transfer in a Confined Space,” Int. J. Heat Mass Transfer, 26, 841 (1983) https://doi.org/10.1016/S0017-9310(83)80108-2
  8. Y. H. Hung and S. C. Yao, "Pool Boiling Heat Transfer in Narrow Horizontal Annular Crevices," ASME J. Heat Transfer, 107, 656 (1985) https://doi.org/10.1115/1.3247474
  9. J. Bonjour and M. Lallemand, “Flow Patterns During Boiling in a Narrow Space between Two Vertical Surfaces,” Int. J. Multiphase Flow, 24, 947 (1998) https://doi.org/10.1016/S0301-9322(98)00017-2
  10. Y. Fujita, H. Ohta, S. Uchida, and K. Nishikawa, “Nucleate Boiling Heat Transfer and Critical Heat Flux in Narrow Space between Rectangular Spaces,” Int. J. Heat Mass Transfer, 31, 229 (1988) https://doi.org/10.1016/0017-9310(88)90004-X
  11. J. C. Passos, F. R. Hirata, L. F. B. Possamai, M. Balsamo, and M. Misale, “Confined Boiling of FC72 and FC87 on a Downward Facing Heating Copper Disk,” Int. J. Heat Fluid Flow, 25, 313 (2004) https://doi.org/10.1016/j.ijheatfluidflow.2003.11.016
  12. M. G. Kang, “Pool Boiling Heat Transfer on a Vertical Tube with a Partial Annulus of Closed Bottoms,” Int. J. Heat Mass Transfer, 50, 423 (2007) https://doi.org/10.1016/j.ijheatmasstransfer.2006.07.028
  13. M. G. Kang and Y. H. Han, “Effects of Annular Crevices on Pool Boiling Heat Transfer,” Nuclear Engineering and Design, 213, 259 (2002) https://doi.org/10.1016/S0029-5493(01)00515-5
  14. M. G. Kang, “Experimental Investigation of Tube Length Effect on Nucleate Pool Boiling Heat Transfer,” Annals of Nuclear Energy, 25, 295 (1998) https://doi.org/10.1016/S0306-4549(97)00056-X
  15. K. Cornwell and S. D. Houston, “Nucleate Pool Boiling on Horizontal Tubes: a Convection-Based Correlation,” Int. J. Heat Mass Transfer, 37, 303 (1994) https://doi.org/10.1016/0017-9310(94)90031-0
  16. M. G. Kang, “Pool Boiling Heat Transfer in a Vertical Annulus with Controlled Inflow Area at Its Bottom,” Int. J. Heat Mass Transfer, 49, 3752 (2006) https://doi.org/10.1016/j.ijheatmasstransfer.2006.03.030
  17. M. G. Kang, “Effects of Water Subcooling on Heat Transfer in Vertical Annuli,” Int. J. Heat Mass Transfer, 49, 4372 (2006) https://doi.org/10.1016/j.ijheatmasstransfer.2006.04.031
  18. M. G. Kang, “Effects of the Location of Side Inflow Holes on Pool Boiling Heat Transfer in a Vertical Annulus,” Int. J. Heat Mass Transfer, 51, 1707 (2008) https://doi.org/10.1016/j.ijheatmasstransfer.2007.07.024
  19. P. B. Whalley, Boiling, Condensation, and Gas-liquid Flow, Oxford University Press (1987)
  20. F. P. Incropera and D. P. DeWitt, Introduction to Heat Transfer, 2nd ed., Wiley (1990)
  21. J. G. Collier, Convective Boiling and Condensation, 2nd ed., McGraw-Hill (1981)

피인용 문헌

  1. An experimental investigation of pool boiling characteristics of alumina-water nanofluid over micro-/nanostructured surfaces pp.1521-0537, 2019, https://doi.org/10.1080/01457632.2018.1496980