한국가시화정보학회지 (Journal of the Korean Society of Visualization)

  • 제8권4호
  • /
  • Pages.13-18
  • /
  • 2010
  • /
  • 1598-8430(pISSN)
  • /
  • 2093-808X(eISSN)
한국가시화정보학회 (The Korean Society of Visualization)
권호 표지
DOI QR코드

DOI QR Code

마이크로 채널 내 유도-전하 전기삼투에 의한 혼합

Mixing in a Microchannel by using Induced-charge Electro-osmosis

  • 투고 : 2010.09.27
  • 심사 : 2010.10.27
  • 발행 : 2010.12.31
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

This paper presents an experimental study on the performance of a micro-mixer using AC electro-osmotic flow. The microchannel is made of PDMS for the side and top walls and glass patterned with ITO for the bottom wall. We first investigated the effect of the applied potential as well as the frequency on the slip velocity. We have found that the slip velocity is roughly proportional to the applied voltage in line with the Helmholtz-Smoluchowski equation and there is an optimum frequency at which the slip velocity becomes maximized. To find the optimum parameters for mixing device we tested our device for various design parameters. It turned out that the best mixing effect is obtained approximately when the electrode angle is $30^{\circ}$, electrode width $200\;{\mu}m$, and the frequency of power supply 700 Hz.

키워드

참고문헌

  1. Cha, J., Kim, J., Ryu, S.-K., Park, J., Jeong, Y., Park,S., Park, S., Kim, H.C. and Chun, K., 2006, “A highlyefficient 3D micromixer using soft PDMS bonding,” J.Micromech. Microeng., Vol. 16, pp. 1778-1782 https://doi.org/10.1088/0960-1317/16/9/004
  2. Suh, Y.K., Heo, S.G., Heo, Y.G., Heo, H.S. and Kang,S., 2007, “Numerical and experimental study onachannel mixer with a periodic array of cross baffles,”J. Mech. Sci. Technol., Vol. 21, pp. 549-555 https://doi.org/10.1007/BF02916317
  3. Le, T.N., Suh, Y.K. and Kang, S., 2010, “A numericalstudy on the flow and mixing in a microchannel usingmagnetic particles,” J. Mech. Sci. Technol., Vol. 24,pp. 441-450. https://doi.org/10.1007/s12206-009-1107-8
  4. Tabeling, P., 2005, Introduction to Microfluidics.Oxford University Press.
  5. Lyklema, J., 1995, Fundamentals of Interface andColloidal Science-Vol. II. Academic Press.
  6. Hunter, R.J., 2001, Foundations of Colloidal Science.Oxford University Press.
  7. Plecis, A. and Chen, Y., 2007, “Fabrication of microfluidicdevices based on glass-PDMS-glass technology,”Microelectronic Engineering, Vol. 84, pp. 1265-1269. https://doi.org/10.1016/j.mee.2007.01.276
  8. Suh, Y.K. and Kang S., 2008, “Asymptotic analysisof ion transport in a nonlinear regime around polarizedelectrodes under ac,” Phys. Rev. E, Vol. 77(3),031504. https://doi.org/10.1103/PhysRevE.77.031504
  9. Suh, Y.K., 2008, “AC-Electro-osmotic flows fundmentalmechanism and kinematic aspects,” TheKorean Society of Visualization, Vol. 6(1), pp. 3-16. https://doi.org/10.5407/JKSV.2008.6.1.003
  10. Suh, Y.K. and Kang, S., 2010, “A review on mixingin microfluidics,” Micromachines, Vol. 1(3), pp. 82-111. https://doi.org/10.3390/mi1030082