Journal of the Korea Concrete Institute (콘크리트학회논문집)

Korea Concrete Institute (한국콘크리트학회)
권호 표지
DOI QR코드

DOI QR Code

Longitudinal Reinforcement Ratio for Performance-based Design of Reinforced Concrete Columns

철근콘크리트 기둥의 성능기반설계를 위한 주철근비

  • Received : 2009.07.30
  • Accepted : 2009.11.19
  • Published : 2010.04.30
Download PDF
⟨ Previous Next ⟩

Abstract

The longitudinal reinforcement ratio for the performance-based design of columns was studied. Unlike the existing design codes using uniform minimum reinforcement ratio and effective stiffness for all columns, the longitudinal reinforcement ratio of columns was defined as the function of various design parameters. To evaluate the minimum reinforcement ratio, two conditions were considered: 1) prevention of passive yielding of compression re-bars due to the creep and shrinkage of concrete under sustained service loads; and 2) ultimate flexural strength greater than the cracking moment capacity to maintain the ductility of columns for earthquake design. In addition, the effective flexural stiffness of columns for structural analysis was determined according to the longitudinal reinforcement ratio. The design method addressing the three criteria was proposed. The proposed method was applied to a design example.

본 연구에서는 성능기반설계를 위한 기둥의 주철근비에 대하여 연구하였다. 일률적인 현행 설계기준과 달리, 다양한 기둥의 설계변수를 고려하여 기둥의 주철근을 정의하였다. 기둥의 최소철근비는 다음의 2 가지 사항을 고려하여 평가하였다; 1) 사용상태에서 콘크리트의 장기변형에 의한 철근의 조기항복 방지; 2) 내진설계시 기둥의 연성능력을 확보하기 위해 균열모멘트 이상의 극한휨강도 확보. 배근상태와 하중조건에 따른 기둥의 유효강성도 강도설계시 추가적으로 고려하였으며, 3 가지 사항을 고려한 주철근비 결정방법을 제안하였다. 제안된 방법은 설계예제에 적용되었다.

Keywords

References

  1. 한국콘크리트학회, 콘크리트구조설계기준 해설, 기문당, 2008, pp. 39-45, 128, 246.
  2. ACI Committee 318, Building Code Requirements for Structural Concrete (ACI 318M-08) and Commentary, American Concrete Institute, Farmington Hills, Mich., 2007, pp. 77, 138, 290.
  3. Richart, F. E., Bertin, R. L., and Lyse, I., “Reinforced Concrete Column Investigation-Tentative Final Report of Committee 105 and Minority Recommendations for Design Formula of Reinforced Concrete Columns,” ACI Journal Proceedings, Vol. 29, No. 6, 1933, pp. 275-284.
  4. MacGregor, J. G. and Hage, S. E., “Stability Analysis and Design of Concrete Frames,” Proceedings, ASCE, Vol. 103, No. ST10, 1977, pp. 1953-1970.
  5. Mirza, S. A., “Flexural Stiffness of Rectangular RC Columns,” ACI Structural Journal, Vol. 87, No. 4, 1990, pp. 425-435.
  6. Paulay, T. and Priestley, M. J. N., Seismic Design of Reinforced Concrete and Masonry Buildings, John Wiley & Sons Inc., New York. 1992, pp. 162-164.
  7. Mehanny, S. S. F., Kuramoto, H., and Deierlein, G. G., “Stiffness Modeling of RC Beam-Columns for Frame Analysis,” ACI Structural Journal, Vol. 98, No. 2, 2001, pp. 215-225.
  8. Khuntia, M. and Ghosh, S. K., “Flexural Stiffness of Reinforced Concrete Columns and Beams: Analytical Approach,” ACI Structural Journal, Vol. 101, No. 3, 2004, pp. 351-363.
  9. Khuntia, M. and Ghosh, S. K., “Flexural Stiffness of Reinforced Concrete Columns and Beams: Experimental Verification,” ACI Structural Journal, Vol. 101, No. 3, 2004, pp. 364-374.
  10. Elwood, K. J. and Eberhard, M. O., “Effectie Stiffness of Reinforced Concrete Columns,” PEER Research Digest, No. 2006-1, 2006, pp. 1-5.
  11. Elwood, K. J. and Eberhard, M. O., “Effectie Stiffness of Reinforced Concrete Columns,” ACI Structural Journal, Vol. 106, No. 4, 2009, pp. 476-484.
  12. 이재훈, 배성용, “철근콘크리트 원형교각의 설계지진력 해석시의 항복유효강성,” 대한토목학회논문집, 21권, 5-A호, 2001, pp. 719-728.
  13. 배성용, 이재훈, “설계지진력 해석시의 철근콘크리트 사각단면교각의 항복유효강성,” 한국콘크리트학회 가을 학술대회 논문집, 13권, 2호, 2001, pp. 941-946.
  14. Davis, R E. and Davis, H. E., “Flow of Concrete Under the Action of Sustained Loads,” Journal of the American Concrete Institute, Proceedings, Vol. 27, No. 3, 1931, 837 pp.
  15. Richart, F. E. and Staehle, G. C., “Second Progress Report on Column Tests at the University of Illinois,” Journal of the ACI, Proceedings, Vol. 27, No. 3, 1931, 761 pp.
  16. Slater, W. A. and Lyse, I., “Second Progress Report on Column Tests Made at Lehigh University,” Journal of the ACI, Proceedings, Vol. 27, No. 3, 1931, 791 pp.
  17. Richart, F. E. and Staehle, G. C., “Fourth Progress Report on Column Tests at the University of Illinois,” Journal of the ACI, Proceedings, Vol. 28, No. 1, 1932, 279 pp.
  18. Lyse, I. and Kreidler, C. L., “Fourth Progress Report on Column Tests Made at Lehigh University,” Journal of the ACI, Proceedings, Vol. 28, No. 1, 1932, 317 pp.
  19. Lyse, I., “Fifth Progress Report on Column Tests Made at Lehigh University,” Journal of the ACI, Proceedings, Vol. 29, 1933, 433 pp.
  20. Logeman, R. T., Wheeler, Walter H., Mensch, L. J., and Stasio, J. Di, “Discussion of Report of Committee 105: ‘Reinforced Concrete Column Investigation’- Tentative Final Report of Committee 105 and Minority Recommendations for Design Formulas of Reinforced Concrete Columns,” Journal of the ACI, Proceedings, Vol. 30, 1933, 78 pp.
  21. Richart, F. E., “Discussion of Report of Committee 105: ‘Reinforced Concrete Column Investigation’- Closure by Chairman, Committee 105,” Journal of the ACI, Proceedings, Vol. 30, 1933, 153 pp.
  22. Ziehl, P. H., Cloyd, J. E., and Kreger, M. E., Evaluation of Minimum Longitudinal Reinforcement Requirements for Reinforced Concrete Columns, Research Report 1473-S, Center for Transportation Research, University of Texas at Austin, Tex., 1998, 128 pp.
  23. NZS 3101-New Zealand Standard, Concrete Structure Standard: Part2-Commentary on the Design of Concrete Structures, New Zealand, 1995, pp. 25, 110.
  24. BS EN 1992-1-1, Eurocode 2: Design of Concrete Structures-Part 1-1: General Rules and Rules for Buildings, British Standards Institution, 2004, 162 pp.
  25. Lin, C. H. and Furlong, R. W., “Longitudinal Steel Limits for Concrete Columns,” ACI Structural Journal, Vol. 92, No. 3, 1995, pp. 282-287.
  26. ACI Committee 209, Prediction of Creep, Shrinkage and Temperature Effects in Concrete Structures (ACI 209R-92), American Concrete Institute, Farmington Hills, Mich., 1992, 47 pp.
  27. Comite Euro-International Du Beton, CEB-FIP Model Code 1990, Thomas Telford Services Ltd., 1993, pp.33-65.
  28. Pfeifer, D. W., Magura, D. D., Russell, H. G., and Corley, W. G., “Time Dependent Deformations in a 70 Story Structure,” ACI Special Publication, Vol. 27 (SP27-07), 1971, pp. 159-185.
  29. Russel, H. G. and Larson, S. C., “Thirteen Years of Deformations in Water Tower Place,” ACI Structural Journal, Title No. 86-S21, 1989, pp. 182-191.
  30. 한국콘크리트학회, “콘크리트 표준시방서 개정(안),” 한국콘크리트학회, 2009, 360 pp.
  31. ASCE, “Prestandard and Commentary for the Seismic Rehabilitation of Buildings,” FEMA 356, Federal Emergency Management Agency, Washington, DC, 2000, 6-12 pp.
  32. 대한토목학회, 서울대학교 교량설계핵심기술연구단 [공]편저, “도로교설계기준 해설 : 공통.강교.콘크리트교.하부구조·내진설계,” 기문당, 2008, pp. 990-991.
  33. Berry, M. P., Parrish, M., and Eberhard, M. O., “PEER Structural Performance Database User’s Manual,” Pacific Earthquake Engineering Research Center, University of California-Berkeley, Berkeley, CA, 2004, 38 pp. (www.ce.washington.edu/~peera1)
  34. MIDAS Information Technology, MIDAS/Gen Analysis Manual, 2005, 305 pp.