직접분사식 디젤기관의 착화지연기간에 대한 고찰

Some Considerations of the Ignition Delay Period in D.I Diesel Engine

  • 방중철 (금오공과대학교 기계공학부)
  • Bang, Joong-Cheol (School of Mechanical Engineering, Kumoh National Institute of Technology)
  • 투고 : 2009.07.13
  • 심사 : 2009.10.12
  • 발행 : 2010.03.01

초록

The four combustion stages in a diesel engine have close correlation among them. Especially, the ignition delay period has significant effect on the following combustion stage. And the period is also one of inevitable combustion processes in the diesel engine. For example, the diesel knocking is a well-known phenomenon due to the long ignition delay period. The interval of the ignition delay period is affected by the mixture formation process in the cylinder. However, in the case of the D.I. diesel engine, the available duration to make the mixture formation of air-fuel is very short. In addition, the means of the mixture formation mainly depends on the injection characteristics and properties of the fuel. It is difficult to make complete mixture. Therefore, an early stage of combustion is violent, which leads to the weakness of noise and vibration. In this study, using the visible engine, we measured the ignition delay period by photo sensor which detect occurrence of flame and presented the factors of the injection characteristics such as kinds of injection system, the injection pressure and the injection timing. The relation between the ignition delay period and cylinder pressure diagram which was concurrently obtained was also estimated.

키워드

참고문헌

  1. T. C. Yu and O. A. Uyehara, "Physical and Chemical Ignition Delay in an Operating Diesel Engine Using the Hot-Motored Technique," Transactions of SAE, Vol.64, No.4, pp.712- 720, 1975.
  2. J. K. Yoon and J. H. Lim, "A Study on the Characteristics of Ignition and Combustion in a Diesel Spray Using Multi-Component Mixed Fuels," Journal of Energy Engineering, Vol.16, No.3, pp.120-127, 2007.
  3. Y. R. Kim, J. M. Lim and K. D. Min, "Ignition Delay Characteristics of DME and Diesel Sprays," Fall Conference Proceedings, KSAE, pp.352-358, 2004.
  4. H. S. Ohn, Y. R. Kim and K. D. Min, "Ignition Delay Measurement of Diesel Sprays in a Constant Volume Vessel," Spring Conference Proceedings, KSAE, pp.387-392, 2004.
  5. H. U. Kim, S. S. Pae and K. D. Min, "Characteristics of the Ignition Delay for Hydrocarbon Fuels by Reduced Chemical Kinetics Modeling," Transactions of KSAE, Vol.9, No.4, pp.44-49, 2003.
  6. J. M. Lim, Y. R. Kim, H. S. Ohn and K. D. Min, "Prediction of Ignition Delay for HSDI Diesel Engine," Fall Conference Proceedings, KSME, pp. 1704-1709, 2004.
  7. Y. W. Yu, S. K. Kim and Y. M. Kim, "Numerical Modeling for Auto-Ignition and Combustion Processes of Fuel Sprays in High- Pressure Environment," Fall Conference Proceedings, KSAE, pp.308-313, 2000.
  8. H. S. Kim and N. W. Sung, "The Effect of Ambient Gas Pressure on Fuel Spray Evaporation and Ignition," Spring Conference Proceedings, KSAE, pp.319-325, 2002.
  9. T. J. Wang and S. W. Baek, "Study on Vaporization and Combustion of Spray in High Pressure Environment," Transactions of KSME, Vol.27, No.9, pp.1273-1281. 2003.
  10. I. S. Choi and J. C. Bang, "The Flame Characteristics by Combustion Chamber Shape in 2 Stroke D.I. Diesel Engine," Transactions of KSAE, Vol.11, No.1, pp.55-63, 2003.