Journal of the Korean Society for Precision Engineering (한국정밀공학회지)

Korean Society for Precision Engineering (한국정밀공학회)
권호 표지

Effect of Micro Surface Structure on Printed Electronics

미세표면구조가 전자인쇄에 미치는 영향

  • Received : 2010.07.16
  • Accepted : 2010.08.12
  • Published : 2010.09.01
Download PDF
⟨ Previous Next ⟩

Abstract

The effect of micro surface structure on printing for printed electronics has been studied experimentally. The photolithography MEMS fabricationwass used to make a SU-8 molder which has micro structures on the surface, and the PDMS micro structure was fabricated by the PDMS molding method. In the aspect of printed electronics, we used silver paste conductive ink. We measured the surface energy variation on pillar microstructure. The microstructure was used to real printing experiment by a screen printing. We printed 1cm micro lines which have $30{\sim}250{\mu}m$ width, and checked the conductivity to sort out opened line pattern. Printability was defined by success probability of printed patterns and we found that the present microstructures improve the printability significantly.

Keywords

References

  1. Wenzel, R. N., "Resistance of solid surfaces to wetting by water," Ind. Eng. Chem., Vol. 28, No. 8, pp. 988-994, 1936. https://doi.org/10.1021/ie50320a024
  2. Cassie, A. and Baxter, S., "Wettability of Porous Surfaces," Trans. Faraday Soc., Vol. 40, pp. 546 -551, 1944. https://doi.org/10.1039/tf9444000546
  3. Nosonovsky, M. and Bhushan, B., "Roughnessinduced superhydrophobicity: a way to design nonadhesive surfaces," J. Phys.: Condens. Matter, Vol. 20, No. 22, Paper No. 225009, 2008. https://doi.org/10.1088/0953-8984/20/22/225009
  4. Bhushan, B. and Jung, Y. C., "Wetting, adhesion and friction of superhydrophobic and hydrophilic leaves and fabricated micro/nanopatterned surfaces," J. Phys.: Condens. Matter, Vol. 20, No. 22, Paper No. 225010, 2008. https://doi.org/10.1088/0953-8984/20/22/225010
  5. Extrand, C. W., Moon, S. I., Hall, P. and Schmidt, D., "Superwetting of Structured Surfaces," Langmuir, Vol. 23, No. 17, pp. 8882-8890, 2007. https://doi.org/10.1021/la700816n
  6. Huang, W.-X., Lee, S.-H., Sung, H. J., Lee, T.-M. and Kim, D.-S., "Simulation of Liquid Transfer between Separating Walls for Modeling Micro-gravure-offset Printing," International Journal of Heat and Fluid Flow, Vol. 29, No. 5, pp. 1436-1446, 2008. https://doi.org/10.1016/j.ijheatfluidflow.2008.07.002
  7. Kang, H. W., Sung, H. J., Lee, T.-M., Kim, D.-S. and Kim, C. J., "Liquid Transfer between Two Separating Plates for Micro-Gravure-Offset Printing," Journal of Micromechanics and Microengineering, Vol. 19, No. 1, Paper No. 015025, 2009. https://doi.org/10.1088/0960-1317/19/1/015025