자유곡면의 밀링 자기연마 복합가공에 관한 연구

Compound Machining of Milling and Magnetic Abrasive Polishing for Free Form Surface

  • 투고 : 2010.02.03
  • 심사 : 2010.05.26
  • 발행 : 2010.08.15

초록

Automated magnetic abrasive polishing which can be applied after machining of the mold on a machine tool without unloading is very effective for finishing a complicated injection mold surface. This study aims to realize one step polishing of free form surface with the same machine tool. For this purpose, magnetic flux density according to the change of curvature radii was simulated for selecting polishing conditions and experimental verification was performed with a complicated mold of aluminum alloy. As a result, it was seen by the simulation that the magnetic flux density at a gradual curvature of the mold was higher than at a steep curvature and the higher magnetic flux density produced the better surface roughness in the experimentation. The deviation for the surface roughness of the mold decreased on the whole and the uniform mold surface was obtained after the automated magnetic abrasive polishing.

키워드

참고문헌

  1. Choi, Y. C., Masahir, A., and Takeo, N., 1996, "A Study on Improving the Etlicient of Magnetic Abrasive Polishing for Die & Mold Surfaces," Journal of the Korean Society of Precision Engineering, Vol. 13, No.6, pp. 102-107.
  2. Kim, S. O., You, M. H., and Kwak, J. S., 2008, "Performance Evaluation of Magnetic Abrasive Polishing by Design of Experiments," Journal of the Korean Society of Machine Tool Engineers, Vol. 17, No.4, pp. 35-41.
  3. Lee, H. C., 2007, "A Study on Optics Polishing Technology by Adaptive Tool and Eccentric Motion Mechanism," Journal of the Korean Society of Machine Tool Engineers, Vol. 16, No.6, pp. 133-139.
  4. Park, W. G., Roh, T. W., and Choi, H., 2004, "The Magnetic Finishing Characteristics of Non- ferromagnetic Pipe Inside Polished," Journal of the Korean Society of Precision Engineering, Vol. 13, No.6, pp. 74-80.
  5. Cho, C. R, Yang, S. C., and Jung, Y. G., 2006, "A Study on the Improvement of Performance for High Speed Croting Tool Using Magnetic Fluid Polishing Technique," Journal of the Korean Society of Manufacturing Process Engineers, Vol. 15, No. 1, pp. 32-38.
  6. Park, W. G., Roh, T. W., and Cho, H., 2005, "The Effect of Vibratory Magnetic Pole by Magnetic Abrasive Finishing," Journal of the Korean Society of Manufacturing Process Engineers, Vol. 4, No. 1, pp. 7-12.
  7. Kim, J. D. and Noh, I. H., 2007, "Magnetic Polishing of Three Dimensional Die and Mold Surfaces," International Journal of Advanced Manufacturing Technology, Vol. 33, No.2-1, pp. 18-23. https://doi.org/10.1007/s00170-007-1018-8
  8. Singha, D. K., Jaina, V. K., and Komandurib, R., 2005, "Analysis of Surface Texture Generated by a Flexible Magnetic Abrasive Brush," Wear, Vol. 259, No. 7-12, pp. 1254-1261. https://doi.org/10.1016/j.wear.2005.02.030