A Study on the Evaporator Shape for the Heat Transfer Performance of Fuel Cell Reformer

연료전지 개질기용 증발기 열교환 성능을 위한 증발기 형상에 관한 연구

  • Received : 2010.09.13
  • Accepted : 2010.11.17
  • Published : 2011.01.01

Abstract

Steam reformer was organized with steam reforming process and CO removing process. The steam reforming process needed high temperature, 600~900 $^{\circ}C$, for catalytic-reaction which was extract of hydrogen from steam and hydrocarbon. The effects of the evaporator configuration on its heat transfer characteristics were investigated both experimentally and numerically to pursue the miniaturization. In this study, three configurations were considered where the different structures were tested; empty, embossing and mesh filled. For the comparison of heat transfer performance of shape evaporator disk, numerical analysis using SC-Tetra code and experiment were carried out. In case of reformer system design, it should be considered heat transfer rate, differential pressure and fluid flow direction.

Keywords

References

  1. Lee, J. S. and Kim, N. Y., "Characterization of SCR System for NOx Reduction of Dielsel Engine(II)," J. of KSPE, Vol. 25, No. 11, pp. 83-89, 2008.
  2. Lee, H. R., Gil, J. H., Kim, S. H., Ha, J. W., Jang, J. H. and Kundu, A., "Characterization of Micro Reformer for RHFC Applications," Proc. of KSPE Spring Conference, pp. 545-546, 2006.
  3. Bae, B. H., Sohn, J. L. and Ro, S. T., "Thermodynamic Performance Analysis of the Solid Oxide Fuel Cell System Including Reformer," Proc. of KSME Fall Annual Meeting, pp. 2412-2416, 2002.
  4. Lim, S. K., Bae, J. M. and Nam, S. W., "Study on Basic Characteristics of Natural Gas Autothermal Reformer for Fuel Cell Applications," Trans. of KSME(B), Vol. 30, No. 9, pp. 850-857, 2006.
  5. Park, J. G., Lee, S. K., Bae, J. M. and Kim, M. J., "Numerical Study on the Performance and the Heat Flux of a Coaxial Cylindrical Steam Reformer for Hydrogen Production," Trans. of KSME(B), Vol. 33, No. 9, pp. 709-717, 2009.
  6. Park, D. S., Seong, E. J., Han, J. Y. and Hwang, S. S., "Accuracy Estimation in Fabrication of Fluid Passage Channel for Fuel Processor," Proc. of KSME Spring Annual Meeting, pp. 574-580, 2006.