Cyclic Seismic Testing of Cruciform Concrete-Filled U-Shape Steel Beam-to-H Column Composite Connections

콘크리트채움 U형합성보-H형강기둥 십자형 합성접합부의 내진성능

  • Received : 2011.03.30
  • Accepted : 2011.06.07
  • Published : 2011.08.27

Abstract

In this research, the seismic connection details for two concrete-filled U-shape steel beam-to-H columns were proposed and cyclically tested under a full-scale cruciform configuration. The key connecting components included the U-shape steel section (450 and 550 mm deep for specimens A and B, respectively), a concrete floor slab with a ribbed deck (165 mm deep for both specimens), welded couplers and rebars for negative moment transfer, and shear studs for full composite action and strengthening plates. Considering the unique constructional nature of the proposed connection, the critical limit states, such as the weld fracture, anchorage failure of the welded coupler, local buckling, concrete crushing, and rebar buckling, were carefully addressed in the specimen design. The test results showed that the connection details and design methods proposed in this study can well control the critical limit states mentioned above. Especially, the proposed connection according to the strengthening strategy successfully pushed the plastic hinge to the tip of the strengthened zone, as intended in the design, and was very effective in protecting the more vulnerable beam-to-column welded joint. The maximum story drift capacities of 6.0 and 6.8% radians were achieved in specimens A and B, respectively, thus far exceeding the minimumlimit of 4% radians required of special moment frames. Low-cycle fatigue fracture across the beam bottom flange at a 6% drift level was the final failure mode of specimen A. Specimen B failed through the fracture of the top splice plate of the bolted splice at a very high drift ratio of 8.0% radian.

본 연구에서는 콘크리트채움 U형 합성보와 H형강 기둥 십자형 합성접합부의 내진상세를 제시하고, 2개의 실물대 실험체를 설계/제작하여 강구조내진기준의 표준실험절차에 따라 내진성능을 평가하였다. 주요 실험체 구성요소는 춤 450mm(실험체 A) 및 550mm(실험체 B) U형 강재보, 두께 165mm의 골데크플레이트 위에 타설된 콘크리트 바닥슬래브, U형보의 완전합성작용을 하기 위한 전단스터드, 부모멘트 전달을 위한 4개의 주철근 및 H형강 기둥에 정착을 위한 용접커플러 그리고 접합부 보강을 위한 보강판으로 구성된다. 순수 강재 보-기둥 접합부와 상이한 U형 합성접합부의 독특한 특성을 고려하여, 지진하중 하에서 내진성능에 결정적 영향을 미치는 보-기둥 접합부의 용접부 취성파단, 강판의 국부좌굴, 주철근의 휨좌굴, 콘크리트 압괴 등의 한계상태가 적절히 제어되도록 실험체를 설계하였다. 강구조내진기준의 지진하중 가력프로그램에 따른 실험결과, 설계에서 의도한 바와 같이 여러 한계상태가 적절히 제어되어 실험체 A 및 B는 각각 6% 및 6.8% 라디안에 이르는 매우 뛰어난 층간변형능력을 발휘하였다. 이는 특수모멘트골조에 요구되는 4% 라디안 수준을 충분히 상회하는 만족스런 층간변형능력이다. 특히 접합부 강화전략에 의해 제안된 합성접합부 상세는 설계에서 의도한 것과 같이 소성힌지를 보강단부로서 밀어냄으로서 취약할 수 있는 보-기둥 용접접합부를 효과적으로 보호하였다. 실험체 A의 최종 파괴모드는 6.0% 층간변위에서 발생한 보강단부에 인접한 냉간성형 코너부의 점진적 저사이클피로에 의한 하부플랜지의 파단에 의해 발생하였다. 한편, 실험체 B는 8.0%의 높은 수준의 층간변위에서 발생한 볼트이음부 파단에 의해 내력을 상실하였다.

Keywords

References

  1. 김성배, 함정태, 이창남, 김상섭(2006) SRC 기둥-TSC 보접합부의 거동에 관한 연구, 대한건축학회논문집, 대한건축학회, 제22권, 제6호, pp.55-62.
  2. 대한건축학회(2010) 건축구조기준 및 해설(KBC2009) 기문당.
  3. 박홍근, 이철호, 박창희, 황현종, 이창남, 김형섭, 김성배(2011) 콘크리트채움 U형 강재보-강재기둥합성 내진접합부에 대한 주기하중 실험, 한국강구조학회논문집, 한국강구조학회, 인쇄중.
  4. 황현종, 박홍근, 이철호, 박창희, 이창남, 김형섭, 김성배(2011) 콘크리트채움 U형 강재보 -콘크리트 기둥 접합부의 내진성능, 한국강구조학회논문집, 한국강구조학회, 제23권, 제1호, pp.83-97.
  5. American Concrete Institute (2008) Building Code Requirements for Structural Concrete and Commentary, ACI 318-08, Michigan.
  6. American Institute of Steel Construction (2005) Seismic Provisions for Structural Steel Buildings, AISC 341-05, Chicago.
  7. Ammerman, D.J. and Leon, R.T. (1990) Unbraced Frames with Semi-Rigid Connections, Engineering Journal, AISC, Vol. 27, No. 1, pp.12-21.
  8. Green, T.P., Leon, R.T., and Rassati, G.A. (2004) Bidirectional Tests on Paritally Restrained, Composite Beam-to-Column Connections, Journal of Structural Engineering, ASCE, Vol. 130, No. 2, pp.320-327. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:2(320)
  9. Leon, R.T. (1990) Semi-Rigid Composite Construction, Journal of Constructional Steel Research, Vol. 15, No. 2, pp.99-120. https://doi.org/10.1016/0143-974X(90)90044-H
  10. Leon, R.T. (1998) Composite Connections, Progress in Structural Engineering and Materials, Construction Research Communications, Vol. 1, No. 2, pp.159-169.
  11. Leon, R.T., Green, T.P., and Rassati, G.A. (2001) Cyclic Behavior of Three Dimensional Partially-Restrained Composite Connection, Proc the 2001 Structural Congress and Exposition, ASCE.