DOI QR코드

DOI QR Code

기어와 유연축을 갖는 구동계로 구동되는 OTM 안테나 시선의 안정화 제어

LOS(line-of-sight) Stabilization Control of OTM(on-the-move) Antenna Driven by Geared Flexible Transmission Mechanism

  • 강민식 (경원대학교 기계.자동차공학과) ;
  • 윤우현 (경원대학교 토목공학과) ;
  • 이종비 (경원대학교 대학원 기계공학과)
  • 투고 : 2011.07.03
  • 심사 : 2011.09.09
  • 발행 : 2011.10.20

초록

In this study, an OTM(on-the-move) antenna which is mounted on ground vehicles and is used for mobile communication between vehicle and satellite while moving was addressed. Since LOS(line-of-sight) of antenna should direct satellite consistently while vehicle moving to guarantee high satellite communication quality, active antenna LOS stabilization is a core technology for OTM antenna. Stabilization of a satellite tracking antenna which consists of 2-DOF gimbals, an elevation gimbal over an azimuth gimbal, was considered in this study. In consideration of driving mechanism which consists of gear train and flexible driving shafts, a two-mass-system dynamic model coupled with vehicle motion was presented. An internal PI-control loop + outer PI-control loop structure has been suggested in order to damp the torsional vibration and stabilize control system. The classical pole-placement method was applied to design control gains. In addition, a vehicle motion compensation control beside of the feedback control loop has been suggested to improve LOS stabilization performances. The feasibility of the proposed control design was verified along with some experimental results.

키워드

참고문헌

  1. Debruin, J., 2008, Control Systems for Mobile Satcom Antennas, IEEE Control Systems Magazine, pp. 86-101.
  2. Masten, M. K., 2008, Inertially Stabilized Platforms for Optical Imaging Systems, IEEE Control Systems Magazine, pp. 47-64.
  3. Hilkert, J. M., 2008, Inertially Stabilized Platform Technology, IEEE Control Systems Magazine, pp. 26-46.
  4. Kennedy, P. J. and Kenny R. L., 2003, Direct Versus Indirect Line of Sight(LOS) Stabilization, IEEE Trans. on Control Systems Technology, Vol. 11, No. 1, pp. 3-15. https://doi.org/10.1109/TCST.2002.806443
  5. Lin, C. L. and Hsiao, Y. H., 2001, Adaptive Feedforward Control for Disturbance Torque Rejection in Seeker Stabilization Loop, IEEE Trans. on Control Systems Technology, Vol. 9, No. 1, pp. 108-121. https://doi.org/10.1109/87.896752
  6. Lim, J. K., Choi, Y. J., Lyou, J., Seok, H. D., Kim, B. U. and Kang, M. S., 2005, Adaptive Disturbance Compensation Control for Heavy Load Target Aiming System to Improve Stabilization Performance, Transactions of the Korean Society for Noise and Vibration Engineering, Vol. 15, No. 11, pp. 1303-1310. https://doi.org/10.5050/KSNVN.2005.15.11.1303
  7. Seong, K. J., Kang, H. G., Yeo, B. Y. and Lee, H. P., 2006, The Stabilization Loop Design for a Two-axis Gimbal System Using LQG/LTR Controller, SICE-ICASE International Joint Conference, pp. 755-759.
  8. Kang, M. S. and Cho, Y. W., 2010, Stabilization Control of Line of Sight of OTM(on-the-move) Antenna, Transactions of the Korea Institute of Electrical Engineers, Vol. 59, No. 11, pp. 2073-2082.
  9. Nam, B. U., Kim, H. S., Lee H. J. and Kim, D. H., 2008, Optimal Speed Controller Design of the Two-inertia Stabilization System, World Academy of Science, Engineering and Technology 41, pp. 155-160.
  10. Szabat, K. and Kowalska, T. O., 2007, Vibration Suppression in a Two-mass Drive System Using PI Speed Controller and Additional Feedback-comparative Study, IEEE Trans. on Industrial Electronics, Vol. 54, No. 2, pp. 1193-1206. https://doi.org/10.1109/TIE.2007.892608
  11. Chih, S. and Cheng, S., 2009, Analysis and Suppression of Tortional Vibrations for the Permanent Magnet Synchronous Motor-load System, Proc. Of the 2009 IEEE International Conference on Systems, Man, and Cybernetics. pp. 3359-3364.
  12. Gang, G. and Furusho, J., 2000, Speed Control of Two-inertia System by PI/PID Control, IEEE. Trans. Industrial Electronics, Vol. 47, No. 3, pp. 603-609. https://doi.org/10.1109/41.847901
  13. Hace, A., Jezernik, K. and Sabanovic, A., 2007, SMC with Disturbance Observer for a Linear Belt Drive, IEEE Trans. on Industrial Electronics, Vol. 54, No. 6, pp. 3402-3412. https://doi.org/10.1109/TIE.2007.906130
  14. Hace, A., Jezernik, K. and Sabanovic, A., 2005, Improved Design of VSS Controller for a Linear Belt-driven Servomechanism, IEEE/ASME Trans. on Mechatronics, Vol. 10, No. 4, pp. 385-389. https://doi.org/10.1109/TMECH.2005.852448
  15. Hace, A., Jezernik, K. and Terbuc, M., 2001, VSS Motion Control for a Laser-cutting Machine, Control Engineering Practice, Vol. 9, No. 1, pp. 67-77. https://doi.org/10.1016/S0967-0661(00)00089-7