한국자동차공학회논문집 (Transactions of the Korean Society of Automotive Engineers)

  • 제21권4호
  • /
  • Pages.83-88
  • /
  • 2013
  • /
  • 1225-6382(pISSN)
  • /
  • 2234-0149(eISSN)
한국자동차공학회 (The Korean Society of Automotive Engineers)
권호 표지
DOI QR코드

DOI QR Code

디젤엔진의 부분 예혼합 연소 및 배기 특성에 대한 분사전략의 영향

Effects of Injection Strategies on the Partial Premixed Charge Combustion and Emission Characteristics in a Diesel Engine

  • Kim, Jaewoong (Department of Mechanical Engineering, Hanyang University) ;
  • Kim, Yungjin (Department of Mechanical Engineering, Hanyang University) ;
  • Park, Sangki (Department of Mechanical Engineering, Hanyang University) ;
  • Lee, Kihyung (Department of Mechanical Engineering, Hanyang University)
  • 투고 : 2012.08.03
  • 심사 : 2013.01.14
  • 발행 : 2013.07.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

Recently, PCCI (premixed charge compression ignition) combustion is studied to reduce both NOx and PM because of homogeneous mixture formation and lower combustion temperature. It has also merit of increasing thermal efficiency owing to better air-fuel mixure. However, it is well known that PCCI combustion has a weakness in fuel economy because PCCI combustion tends to start before TDC. Therefore, it is necessary to find an optimal conditions for PCCI combustion which maintains reduction of NOx, PM and increase of thermal efficiency. In this study, pPCCI combustion was realized by adding early injection strategy to a conventional diesel engine. In addition, the characteristics of pPCCI combustion was analized by comparing conventional diesel injection strategy. The results show that NOx and PM per power in pPCCI combution were reduced compared to a conventional diesel combustion.

키워드

참고문헌

  1. J. Y. Heo, J. P. Cha, S. H. Yoon and C. S. Lee, "Effect of Multiple Injection on Combustion and Emission Characteristics in a Singlecylinder Direct Injection Diesel Engine," KSAE Spring Conference Proceedings, pp.37-42, 2010.
  2. G. D. Neely and S. Sasaki, "Experimental Investigation of PCCI-DI Combustion on Emissions in a Light-duty Diesel Engine," SAE 2004-01-0121, 2004.
  3. D. E. Foster, "Compression-igniter Homogeneous Charge Combustion," SAE 830264, 1983.
  4. S. Lee and W. Park, "The Effect of Split Injection Strategy and Piston Bowl Geometry for Partially Homogeneous Charge Combustion Ignition Engine," KSAE09-B0015, 2009.
  5. P. Carlucci and A. Ficarella, "Effects on Combustion and Emissions of Early and Pilot Fuel Injections in Diesel Engines," Int. J. Engine Res., Vol.6, No.1, pp.43-60, 2005. https://doi.org/10.1243/146808705X7301
  6. S. Mendez, "Using Multiple Injection Strategies in Diesel Combustion : Potential to Improve Emissions, Noise and Fuel Economy Trade-off in Low CR Engines," SAE 2008-01-1329, 2008.
  7. B. D. Park, S. I. Kwon, J. G. Oh and S. J. Kim, "Behavior of 2-stage Injection on Diesel Spray," Journal of ILASS-Korea, Vol.5, No.4, pp.33-39, 2000.
  8. J. Benajes, R. Novella and S. Arthozoul, "Particle Size Distribution Measurements from Early to Late Injection Timing Low Temperature Combustion in a Heavy Duty Diesel Engine," SAE 2010-01-1121, 2010.
  9. C. Park and S. Kook, "Effect of Multiple Injection in a HSDI Diesel Engine Equipped with Common Rail Injection System," SAE 2004-01-0127, 2004.
  10. J. Chung, J. Kang, S. Lee, W. Kang and B. S. Kim, "A Study on the Effect of Compression Ratio and EGR on the Partial Premixed Diesel Compressed Ignition Combustion Engine Applied with the Split Injection Method," Transactions of KSAE, Vol.14, No.5, pp.32-38, 2006.