DOI QR코드

DOI QR Code

Effect of Difference in Mixing Methods of Zirconia on Mechanical Properties of ZTA

ZrO2의 혼합방법 차이가 ZTA의 기계적 물성에 미치는 영향

  • 손정호 (가야대학교 항만물류학부)
  • Received : 2013.10.21
  • Accepted : 2013.10.23
  • Published : 2013.11.27

Abstract

In this study, intermediate-mixed powders were prepared by loading zirconia powders initially in a ball-mill jar and loading alumina powders afterward; the initial-mixed powders were produced by loading zirconia and alumina powders together in the ball-mill jar. The effect of such differences in mixing method on the mechanical properties was investigated. In intermediate-mixed powders, the volume fraction of large particles slightly increased and, simultaneously, zirconia particles formed agglomerates that, due to early ball-mill loading of the zirconia powders only, were more dispersed than were the initial-mixed powders. For the intermediate-mixed powders, zirconia agglomerates were destroyed more quickly than were initial-mixed powders, so the number of dispersed zirconia particles rose and the inhibitory effect of densification due to the addition of a second phase was more obvious. In the microstructure of intermediate-mixed powders, zirconia grains were homogeneously dispersed and grain growth by coalescence was found to occur with increasing sintering temperature. For the initial-mixed powders, large zirconia grains formed by localized early-densification on the inside contacts of some zirconia agglomerates were observed in the early stages of sintering. The intermediate-mixed powders had slightly lower hardness values as a whole but higher fracture toughness compared to that of the initial-mixed powders.

Keywords

References

  1. R. C. Garvie, R. H. Hannik and R. T. Pascoe, Nature, 258, 703 (1975). https://doi.org/10.1038/258703a0
  2. D. B. Marshall, J. Am. Ceram. Soc., 69(3), 173 (1986). https://doi.org/10.1111/j.1151-2916.1986.tb07402.x
  3. R. H. J. Hannink, P. M. Kelly and B. C. Muddle, J. Am. Ceram. Soc., 83(3), 461 (2000).
  4. M. Szutkowska, J. Achiev. Mater. Manuf. Eng., 54(2), 202 (2012).
  5. F. F. Lange, J. Mater. Sci., 4(17), 247 (1982).
  6. R. C. Garvie, Adv. Ceram., 12, 55 (1984).
  7. G. Orange, G. Fantozzi, P. Homerin, F. Thevenot, A. Leriche and F. Cambier, Adv. Ceram., 24, 1075 (1988).
  8. A. H. De Aza, J. Chevalier, G. Fantozzi, M. Schehl and R. Torrecillas, Biomaterials, 23, 937 (2002). https://doi.org/10.1016/S0142-9612(01)00206-X
  9. C. W. Huang, M. T. Weng and W. C. J. Wei, J. Ceram. Process. Res., 9(3), 221 (2008).
  10. A. Alsebaie, A. G. Olabi, A. Rafferty and T. Prescott, The fourth Arabic congress in material science, 2, 390, Al. fath university, Libya, (2005).