DOI QR코드

DOI QR Code

Shear Resistance of CIP Anchors under Dynamic Loading: Reinforced Anchor

선설치앵커의 동적 전단하중에 대한 저항강도: 철근보강 앵커

  • Park, Yong Myung (Dept. of Civil Engineering, Pusan National University) ;
  • Kang, Moon Ki (Dept. of Civil Engineering, Pusan National University) ;
  • Roh, Jin Kyung (Dept. of Civil Engineering, Pusan National University) ;
  • Ju, Ho Jung (Dept. of Civil Engineering, Pusan National University) ;
  • Kang, Choong Hyun (School of Architectural and Civil Engineering, Kyungpook National University)
  • 박용명 (부산대학교, 토목공학과) ;
  • 강문기 (부산대학교, 토목공학과) ;
  • 노진경 (부산대학교, 토목공학과) ;
  • 주호중 (부산대학교, 토목공학과) ;
  • 강충현 (경북대학교, 건축토목공학부)
  • Received : 2013.09.13
  • Accepted : 2013.12.16
  • Published : 2014.02.27

Abstract

In this study, an experimental study was performed to evaluate the shear resistance of cast-in-place(CIP) anchors reinforced with hairpin and stirrup bars under static and dynamic loads. The reinforcement was developed using D6 bars, and the anchors were installed with 20mm diameter and 120mm edge distance. Three tests were conducted for each type of reinforced anchor under static and dynamic shear load with a pulsating frequency of 1 Hz, respectively. It was found that the strength of hairpin-reinforced anchor was affected by the concrete cover and the dynamic tests showed no capacity reduction of anchors compared with static tests. The stirrup-reinforced anchor showed little increase of resistance compared with unreinforced anchor and the resistance under dynamic loading showed nearly same strength by static loading.

본 연구에서는 헤어핀 보강 및 스트럽 보강 선설치앵커의 정적 및 동적 전단하중에 대한 저항강도 평가를 위한 실험을 수행하였다. 보강철근은 D6 이형철근을 사용하였으며 연단거리 120mm의 직경 20mm 앵커에 대해 정적 하중과 1Hz의 편진하중으로 각각 3개의 시험체에 대해 실험을 수행하였다. 헤어핀 보강 앵커는 헤어핀의 덮개가 강도에 직접 영향을 미치는 것으로 확인되었으며, 정적 대비 동적하중에서 강도의 저하는 없는 것으로 평가되었다. 스트럽 보강 앵커는 비보강 앵커에 비해 저항강도의 증가는 미소하였으며 동적하중에 의한 강도는 정적하중에 의한 강도와 거의 같은 값을 보였다.

Keywords

References

  1. 한국콘크리트학회(2012) 콘크리트구조기준해설, 부록 II 콘크리트용 앵커. Korean Concrete Institute (2012) Concrete Structure Design Code and Commentary, Appendix II Anchoring to Concrete (in Korean).
  2. ACI Committee 318 (2008) Building Code Requirements for Structural Concrete and Commentary(ACI 381-08); Appendix D Anchoring to Concrete, American Concrete Institute.
  3. ACI Committee 318 (2011) Building Code Requirements for Structural Concrete and Commentary (ACI 318-11); Appendix D Anchoring to Concrete, American Concrete Institute.
  4. 박용명, 강문기, 김동현, 이종한, 강충현(2014) 선설치앵커의 동적 전단하중에 대한 저항강도: 비보강 앵커, 한국강구조학회 논문집. Park, Y.M., Kang, M.K., Kim, D.H., Lee, J.H., and Kang, C.H. (2014) Concrete Breakout Capacity of CIP Anchors under Dynamic Shear Loading: Unreinforced Anchor, Journal of Korean Society of Steel Construction, KSSC. https://doi.org/10.7781/kjoss.2014.26.1.011
  5. Eligehausen, R., Mallee, R., and Silva, J.F. (2006) Anchorage in Concrete Construction, Ernst & Sohn, Germany.
  6. Klingner, R.E., Mendonca, J.A. and Malik, J.B.(1982) Effect of Reinforcing Details on the Shear Resistance of Anchor Bolts Under Reversed Cyclic Loading, ACI Journal, Title No.79-1, pp.3-12.
  7. Petersen, D., Lin, Z., and Zhao, J. (2013) Behavior and Design of Cast-in-Place Anchors under Simulated Seismic Loading, Draft Final Report (Vol. I) Cyclic Behavior of Single Headed Anchors, Dept. of Civil Eng., University of Wisconsin, Milwaukee.
  8. Petersen, D., and Zhao, J. (2013) Design of Anchor Reinforcement for Seismic Shear Loads, ACI Journal, Title No.110-S06, pp.53-62.
  9. Gross, J.H., Klingner, R.E., and Graves III, H.L. (2001) Dynamic anchor behavior of single and double near-edge anchors loaded in shear, connections between steel and concrete, Proc. Int. Conference organized by University of Stuttgart, Co-sponsored by ACI, fib, IABSE, edited by R. Eligehausen, RILEM Publications S.A.R.L., pp.498-508.

Cited by

  1. Breakout shear strength of cast-in-place anchors using shaking table tests vol.170, pp.12, 2017, https://doi.org/10.1680/jstbu.16.00241
  2. Dynamic shear strength of unreinforced and Hairpin-reinforced cast-in-place anchors using shaking table tests vol.58, pp.1, 2016, https://doi.org/10.12989/sem.2016.58.1.039
  3. Dynamic Shear Strength of Stirrup-reinforced Cast-in Anchors by Seismic Qualification Tests vol.30, pp.2, 2018, https://doi.org/10.7781/kjoss.2018.30.2.067
  4. A Study on the Pull-out Strength of Bond Type Anchors vol.30, pp.2, 2018, https://doi.org/10.7781/kjoss.2018.30.2.105
  5. 헤어핀 보강 선설치앵커의 정적 및 지진모의실험에 의한 전단 저항강도 평가 vol.27, pp.3, 2015, https://doi.org/10.7781/kjoss.2015.27.3.333