Journal of Korean Society of Steel Construction (한국강구조학회 논문집)

Korean Society of Steel Construction (한국강구조학회)
권호 표지
DOI QR코드

DOI QR Code

Eccentric Axial Load Test for Concrete-Filled Tubular Columns Encased with Precast Concrete

프리캐스트 콘크리트에 의해 피복된 콘크리트충전 강관기둥의 편심압축실험

  • Received : 2013.06.26
  • Accepted : 2014.01.02
  • Published : 2014.02.27
Download PDF
⟨ Previous Next ⟩

Abstract

In this paper, concrete-filled steel tubular columns encased with precast reinforced concrete were studied. Four eccentrically loaded columns and a concentrically loaded column were tested to investigate the axial load-carrying capacity. The test parameters were the use of fiber reinforcement for cover concrete, eccentricity, column length, and lateral reinforcement. The maximum axial loads of the specimens agreed with the nominal strengths predicted by KBC 2009. However, in some specimens, the load carrying capacity quickly decreased after the peak strength due to spalling of the cover concrete.

본 연구에서는 콘크리트충전 각형강관에 구조용 피복콘크리트를 적용한 합성기둥에 대하여 연구하였다. 1/3~1/2 축소모델의 편심 압축실험체 4개와 중심압축실험체 1개를 제작하여 압축실험을 수행하였다. 실험 변수는 피복콘크리트의 강섬유 첨가여부, 편심거리, 기둥 길이, 그리고 횡보강 상세이다. 일부 실험체에서 최대강도 도달 후 피복콘크리트의 탈락으로 인한 강도저하가 발생하였으나 모든 실험체는 현행 설계기준(KBC 2009)에 의한 휨 압축 강도 및 공칭 압축강도를 초과하는 하중재하능력을 보였다.

Keywords

References

  1. Japanese Society of Steel Construction (2010) Design Guidebook for Connections of Hybrid Structures, Technical Report, No.90 (in Japanese).
  2. Matsui, C., Tsuda, K., and Mori, T. (1998) Limiting Width (Diameter)-Thickness Ratio of Tubes of Composite Steel Tube and Concrete Columns with Encased Type Section, J. Struct. Constr. Eng., AIJ, No.503, pp.157-163 (in Japanese).
  3. Yamashita, K., Fujimoto, Y., Lim, S., and Rokugou, K. (2005) Bending Failure Behavior and Crack Properties of Steel Tubes Covered with Multiple-Crack-Type Concrete, Proceedings of the Japan Concrete Institute, Vol.27, No.1, pp.301-306 (in Japanese).
  4. Miyauchi, Y., Fukuhara, T., Hiroshige, T., and Muto, K. (2010) Seismic Behavior of Reinforced Concrete Covered CFT Structural Elements: Part1. Performance of Columns, Summaries of Technical Papers of Annual Meetings(Structures III), AIJ, pp.1359-1360 (in Japanese).
  5. Igarashi, T., Inoue, I., Tsuzioka, S., Eom, C.H., and Nukatani, H. (1988) Mechanical Properties of Composite Column Connected Steel Column and Precast Concrete Board with Headed Stud, Research Report of Kinki region, AIJ, Vol.28, pp.137-140 (in Japanese).
  6. 김철환, 김성근(1996) SPC합성기둥의 역학특성에 관한 실험적 연구, 대한건축학과논문집, 대한건축학회, 제12권, 제3호, pp.143-151. Kim, C.H., and Kim, S.E. (1996) Structural Characteristics of a New Composite Column Composed of Steel Square Tube and Precast Concrete Panels, Journal of Architectural Institute of Korea, AIK, Vol.12, No.3, pp.143-151 (in Korean).
  7. Architectural Institute of Japan (2001) Standard for Structural Calculation of Steel Reinforced Concrete Structures, 5th ed. (in Japanese).
  8. 김창수 박홍근 최인락 정경수 김진호(2010) 800MPa 강재 및 100MPa 콘크리트를 적용한 매입형 합성기둥의 구조성능, 한국강구조학회논문집, 한국강구조학회, 제22권, 제5호 pp.497-509. Kim, C.S., Park, H.G., Choi, I.R., Chung, K.S., and Kim, J.H. (2010) Structural Performance of Concreteencased Steel Columns using 800MPa Steel and 100MPa Concrete, Journal of Korean Society of Steel Construction, KSSC, Vol.22, No.5, pp.497-509 (in Korean).
  9. Park, R. (1988) State-of-the-Art Report on Ductility Evaluation from Laboratory and Analytical Testing, Proceedings of 9th World Conference on Earthquake Engineering, Tokyo-Kyoto, Japan, Vol.8, pp.605-616.
  10. ACI 318 (2008) Building Code Requirements for Structural Concrete and Commentary, American Concrete Institute, USA.
  11. ANSI/AISC 360 (2010) Specification for Structural Steel Buildings, American Institute of Steel Construction, USA.
  12. Eurocode 4 (2004) Design of Composite Steel and Concrete Structures-Part 1-1: General Rules and Rules for Buildings, CEN, Belgium.
  13. 대한건축학회(2009) 건축구조설계기준 및 해설(KBC 2009), 기문당. AIK (2009) Korea Building Code and Commentary - Structural, Architectural Institute of Korea (in Korean).
  14. 김창수 박홍근 이호준 최인락(2013) 800MPa 강재 및 100MPa 콘크리트를 적용한 ㄱ형 강재 매입형 합성기둥의 편심압축실험, 한국강구조학회논문집, 한국강구조학회, 제25권, 제2호, pp.209-222. Kim, C.S., Park, H.G., Choi, I.R., Chung, K.S., and Kim, J.H. (2010) Eccentric Axial Loading Test for Concrete-Encased L-section Columns using 800MPa Steel and 100MPa Concrete, Journal of Korean Society of Steel Construction, KSSC, Vol.25, No.2, pp.209-222 (in Korean). https://doi.org/10.7781/kjoss.2013.25.2.209

Cited by

  1. 콘크리트피복 원형충전강관 기둥-강재보 접합부에 대한 반복하중실험 vol.29, pp.6, 2014, https://doi.org/10.7781/kjoss.2017.29.6.411
  2. Axial Compression Behavior of Concrete-Encased Steel Angle Columns Using High-Strength Steel vol.31, pp.6, 2014, https://doi.org/10.7781/kjoss.2019.31.6.381