DOI QR코드

DOI QR Code

Analysis of LRFD Resistance Factor for Shallow Foundation on Weathered Soil Ground

풍화토지반 얕은기초에 대한 LRFD 저항계수 분석

  • Kim, Donggun (Department of Civil Engineering, Kangwon National University) ;
  • Kim, Huntae (Department of Civil Engineering, Kangwon National University) ;
  • Suh, Jeeweon (Seongwoogeotec) ;
  • Yoo, Namjae (Department of Civil Engineering, Kangwon National University)
  • Received : 2014.11.25
  • Accepted : 2015.05.11
  • Published : 2015.06.01

Abstract

Recently the necessity of developing the Load and Resistance Factor Design (LRFD) for shallow foundation has been raised to implement to the domestic design codes related to geotechnical engineering since the limit state design is requested as international technical standard for the foundation of structures. In this study, applicability of LRFD for shallow foundation on weathered soils was investigated and resistance factor for this case was proposed. The quantitative analyses on the uncertainty and resistance bias for shallow foundation on weathered soil ground were performed by collecting the statistical data about domestic case studies for design and construction of shallow foundation. Reliability analyses for shallow foundation were first performed using FDA (First-order Design value Approach) method. Resistance factors were calibrated using the load factors obtained from the specifications of shallow foundations on weathered soil ground. The influence of the load factors developed in this study on the resistance factors were discussed by comparing with the resistance factor obtained from using AASHTO load factors.

최근 구조물 기초 분야에 대한 한계상태설계법이 국제적인 기술표준으로 요구됨에 따라 연구기반이 미약한 얕은기초에 대한 하중저항계수설계법 개발의 필요성이 대두되었다. 본 연구에서는 얕은기초 설계 시 풍화토 지반에 위치한 얕은기초에 대한 하중저항계수설계법의 적용 방안에 대하여 연구를 수행하고 그에 따른 저항계수를 제안하였다. 얕은기초 국내 설계 및 시공자료를 수집하여 확률통계학적 기법에 의한 분석을 수행함으로써 풍화토지반 얕은기초의 불확실성과 저항편향계수를 정량적으로 분석하고, 신뢰성 해석 LEVEL II를 이용하여 목표신뢰도 지수를 평가하였으며, 산정된 신뢰도지수를 기존 문헌 값과 비교 분석하여 풍화토 지반 얕은기초에 대한 목표신뢰도 지수를 선정하였다. 국내 풍화토지반 얕은기초에 대한 하중계수를 적용하여 저항계수를 보정하였으며, AASHTO의 하중계수를 적용한 저항계수와 비교 분석하였다.

Keywords

References

  1. AASHTO (2010), AASHTO LRFD bridge design specifications, fifth edition, American Association of State Highway and Transportation Officials, Washington, D.C., pp. 3-1-3-159; 10-1-10-81.
  2. Becker, D. E. (1996), Eighteenth canadian geotechnical colloquium : limit state design for foundations, part II. Development for the national building code of Canada, Canadian Geotechnical Journal, Vol. 33, No. 6, pp. 984-1007. https://doi.org/10.1139/t96-125
  3. De Beer, E. E. (1967), Proefondervindelijke bijdrage tot de studie van het gransdragvermogen van zand onder funderingen op staal; Bepaling von der vormfactor sb, Annales des Travaux Plublics de Belgique, 68, No. 6, pp. 481-506; 69, No. 1, pp. 41-88; No. 4, pp. 321-360; No. 5, pp. 395-442; No. 6, pp. 495-522.
  4. FHWA (2001), Load and resistance factor design (LRFD) of highway bridge substructures, Federal Highway Administration, Report No. FHWA HI-98-032, Washington D.C., pp. 84.
  5. Hansen, J. B. (1970), A revised and extended formula for bearing capacity, Danish Geotechnical Institute Bulletin 28, Copenhagen, pp. 22.
  6. Meyerhof, G. G. (1955), Influence of roughness of base and ground water condition on the ultimate bearing capacity of foundations, Geotechnique, pp. 5:227. https://doi.org/10.1680/geot.1955.5.3.227
  7. MOLIT (2011), Reliability design standards of quay-gravity and pier, pp. 72-86 (in Korean).
  8. NAVFAC (Naval Facilities Engineering Command Design Manual) DM-7.2 (1982), Foundations and earth structures: design manual 7.2, Naval Facilities Engineering Command, pp. 244.
  9. Paikowsky, S. G., Canniff, M. C., Lesny, K., Kisse, A., Amatya, S. and Muganga, R. (2010), NCHRP report 651: LRFD design and construction of shallow foundations for highway bridge structures, Transportation Research Board of the National Academies, Washington D.C., pp. 82-127.
  10. Phoon, K. K. and Kulhawy, F. H. (1996), Practical reliability based design approach for foundation engineering, Research Record 1546, Transportation Research Board, Washington, pp. 94-99.
  11. Terzaghi, K. (1943), Theoretical soil mechanics, Wiley, New York, pp. 55-108.
  12. Vesic, A. (1963), Bearing capacity of deep foundations in sand, Highway Research Record 39: Stresses in Soils and Layered Systems, National Academy of Sciences, National Research Council, Washington D.C., pp. 112-153.
  13. Vesic, A. (1973), Analysis of ultimate loads of shallow foundations, Journal of soil Mechanics and Foundation Division, ASCE, 99(SMI), pp. 45-73.
  14. Vesic, A. (1975), Bearing capacity of shallow foundations, Foundation Engineering Handbook (eds. H.F. Winterkorn and H.Y. Fang), Van Nostrand Reinhold, New York, pp. 121-147.
  15. Wu, T., Tang, W., Sangrey, D. and Baecher, G. (1989), Reliability of offshore foundations-state of the art, Journal of Geotechnical Engineering, Vol. 115, No. 2, pp. 157-178. https://doi.org/10.1061/(ASCE)0733-9410(1989)115:2(157)
  16. Zhang, L., Tang, W. and Ng, C. (2001), Reliability of axially loaded driven pile groups, Journal of Geotechnical and Geoenvironmental Engineering, Vol. 127, No. 12, pp. 1051-1060. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:12(1051)