Journal of the Korean Society of Manufacturing Process Engineers (한국기계가공학회지)

The Korean Society of Manufacturing Process Engineers (한국기계가공학회)
권호 표지
DOI QR코드

DOI QR Code

Retardation Analysis of Plastic Optic Lens according to Injection Speed Variation

사출속도 변화에 따른 플라스틱 광학렌즈의 위상차 해석

  • Park, Soo-Hyun (Dept. of Mechanical Engineering, Gyeongnam National Univ. of Sci. and Tech.) ;
  • Kim, Tae-Kyu (Dept. of Mechanical Engineering, Gyeongnam National Univ. of Sci. and Tech.) ;
  • Kwak, Tae-Soo (Dept. of Mechanical Engineering, Gyeongnam National Univ. of Sci. and Tech.)
  • Received : 2015.01.14
  • Accepted : 2015.03.12
  • Published : 2015.04.30
Download PDF
⟨ Previous Next ⟩

Abstract

This study focuses on simulation technology in the injection molding process for plastic optic lenses. The CAE program 3D TIMON was used to predict retardation, flow patterns and warpage deformation. The results were compared to the results of optic lenses as measured using the WPA-100 retardation measurement device with injection molding CAE for retardation predictions. According to the analysis and measured results, the distributions of retardation between the CAE results and the measurement results were similar. It was also confirmed that varying the injection speed had an effect on the injection pressure, warpage deformation and retardation distribution. As the injection speed increases, the injection pressure also increases and warpage deformation decreases. However, as the injection speed increases, the retardation distribution deteriorates.

Keywords

References

  1. Kwak, T. S., Ohmori, H., "Verification for transcription of spherical radius and prediction of birefringence in injection molding optical lens", J. of KSPE, Vol. 22, No. 6, pp. 55-60, 2005
  2. Lee, J. S., "A Study of the Injection Molding Analysis of the Camera Phone Lens According to Gate Size", Autumn Proceedings of KSMPE, pp. 171-171, 2013
  3. Lee, S. W., Joh, H. H., Hong, J. S., Lyu, M. Y., "Birefringent Analysis of Plastic Lens Injection Molding for Mobile Phone Camera", Transactions of Materials Processing, Vol. 20, No. 1, pp. 54-59, 2011 https://doi.org/10.5228/KSTP.2011.20.1.54
  4. Kim, H. J., Kim, J. H., Kim, Y. G., Son, J. Y., Moon, D. H., "A Simulation Study on the Development of Injection Mold for the Parts of Phone Camera Lens Module", Vol. 22, No. 4, pp. 83-92, 2013
  5. Kwak, T. S., Ohmori, H., Bae, W. B., "A study on searching method of molding condition to control the thickness reduction of optical lens in plastic injection molding process", J. of the KSPE, Vol. 21, No. 2, 2004
  6. Park, K., Ahn, J. H., Yim, C. H., "Residual Stress Estimation and Deformation Analysis for Injection Molded Plastic Parts using Three-Dimensional Solid Elements", J. of KSME, Vol. 27, No. 4, pp. 507-514, 2003

Cited by

  1. Reduction of Birefringence and Weld-Line using Over-Flow in Injection Compression Molding for Optic Lens vol.17, pp.1, 2018, https://doi.org/10.14775/ksmpe.2018.17.1.095