DOI QR코드

DOI QR Code

Shear Resistance of Sandy Soils Depending on Particle Shape

모래 입자의 형상과 내부마찰각의 상관관계에 관한 연구

  • Suh, Hyoung Suk (School of Civil and Environmental Engrg., Yonsei Univ.) ;
  • Jo, Yumin (School of Civil and Environmental Engrg., Yonsei Univ.) ;
  • Yun, Tae Sup (School of Civil and Environmental Engrg., Yonsei Univ.) ;
  • Kim, Kwang Yeom (Korea Institute of Civil Engineering and Building Technology)
  • 서형석 (연세대학교 토목환경공학과) ;
  • 조유민 (연세대학교 토목환경공학과) ;
  • 윤태섭 (연세대학교 토목환경공학과) ;
  • 김광염 (한국건설기술연구원 Geo-인프라연구실)
  • Received : 2016.04.15
  • Accepted : 2016.05.25
  • Published : 2016.06.30

Abstract

This study presents the correlations between quantified particle shape parameters and internal friction angles for nine sand specimens including six natural sands and three crushed sands. Specimens are subjected to 3D X-ray computed tomographic imaging and their particles are segmented through the aid of image processing techniques. Shapes of segmented particles are then quantified through two shape parameters such as sphericity and elongation. The direct shear apparatus enables us to measure peak and critical state friction angles of sand specimens of distinct relative densities. The gathered data show that decreasing sphericity and increasing elongation cause increases in peak and critical state friction angle with similar gradients.

본 연구에서는 영상처리 기법을 이용해 총 9개의 모래 시료의 형상을 정량화하여 전단강도와의 상관관계를 분석하였다. 분석 시료는 6개의 자연모래 시료와 3개의 부순모래 시료이며 이를 고해상도 3차원 X-ray CT 촬영하여 그로부터 개별 입자 영상을 분리하고 구형도(Sphericity) 및 이완도(Elongation)와 같은 형상 계수를 통해 모래 시편의 형상을 정량화 하였다. 또한 시료의 상대밀도를 다르게 조성하여 직접전단시험을 수행해 첨두내부마찰각(Peak friction angle)과 극한내부마찰각(Critical state friction angle)을 획득하였다. 시료의 구형도가 감소하고 이완도가 증가할수록, 첨두내부마찰각과 극한내부마찰각은 유사한 기울기를 보이며 증가함을 확인하였으며 두 내부마찰각 사이 절댓값 차이는 입자 형상보다는 상대밀도 차이로부터 기인함을 확인하였다.

Keywords

References

  1. Aloufi, M. and Santamarina, J. C. (1995), "Low and High-strain Macrobehavior of Grain Masses - the Effect of Particle Eccentricity", Transcation of the ASAE, Vol.38, No.3, pp.877-887. https://doi.org/10.13031/2013.27904
  2. ASTM D 3080 (1998), "Standard Test Method for Direct Shear Test of Soils under Consolidated Drained Conditions",
  3. ASTM D 421 (2007), "Standard Practice for Dry Preparation of Soil Samples for Particle-size Analysis and Determination of Soil Constant", Annual book of ASTM standards, ASTM.
  4. ASTM D 4253 (2002), "Standard Test Method for Maximum Index Density and Unit Weight for Soils Using a Vibratory Table", Annual book of ASTM standards, ASTM.
  5. ASTM D 4254 (2002), "Standard Test Method for Minimum Index Density and Unit Weight for Soils and Calculation of Relative Density", Annual book of ASTM standards, ASTM.
  6. ASTM D 854 (2014), "Standard Test Methods for Specific Gravity of Soils by Water Pycnometer", Annual book of ASTM standards, ASTM.
  7. Barrett, P. J. (1980), "The Shape of Rock Particles, a Critical Review", Sedimentology, Vol.27, No.3, pp.291-303. https://doi.org/10.1111/j.1365-3091.1980.tb01179.x
  8. Blott, S. J. and Pye, K. (2008), "Particle Shape: A Review and New Methods of Characterization and Classification, Sedimentology, Vol.55, No.1, pp.31-63. https://doi.org/10.1111/j.1365-3091.2007.00892.x
  9. Bolton, M. D. (1986), "The Strength and Dilatancy of Sands", Geotechnique, Vol.36, No.1, pp.65-78. https://doi.org/10.1680/geot.1986.36.1.65
  10. Bolton, M. D. (1987), "The Strength and Dilatancy of Sands. Discussion", Geotechnique, Vol.37, No.2, pp.219-226. https://doi.org/10.1680/geot.1987.37.2.219
  11. Cavarretta, I., Coop, M., and O'Sullivan, C. (2010), "The Influence of Particle Characteristics on the behaviour of Coarse Grained Soils", Geotechnique, Vol.60, No.3, pp.413-423. https://doi.org/10.1680/geot.2010.60.6.413
  12. Cho, G. C., Dodds, J., and Santamarina, J. C. (2006), "Particle Shape Effects on Packing Density, Stiffness and Strength: Natural and Crushed Sands", Journal of Geotechnical and Geoenvironmental Engineering, Vol.132, No.5, pp.591-602. https://doi.org/10.1061/(ASCE)1090-0241(2006)132:5(591)
  13. Cubrinovski, M. and Ishihara, K. (2002), "Maximum and Minimum Void Ratio Characteristics of Sands", Soils and Foundations, Vol.42, No.6, pp.65-78. https://doi.org/10.3208/sandf.42.6_65
  14. Dyskin, A. V., Estrin, Y., Kanel-Belov, A. J., and Pasternak, E. (2001), "Toughening by Fragmentation - How Topology Helps", Advanced Engineering Materials, Vol.3, No.11, pp.885-888. https://doi.org/10.1002/1527-2648(200111)3:11<885::AID-ADEM885>3.0.CO;2-P
  15. Feda, J. (2002), "Notes on the Effect of Grain Crushing on the Granular Soil behaviour", Engineering Geology, Vol.63, No.1, pp.93-98. https://doi.org/10.1016/S0013-7952(01)00072-2
  16. Folk, R. L. (1955), "Student Operator Error in Determination of Roundness, Sphericity, and Grain Size", Journal of Sedimentary Research, Vol.25, No.4, pp.297-301.
  17. Fonseca, J., O'Sullivan, C., Coop, M. R., and Lee, P. D. (2012), "Non-invasive Characterization of Particle Morphology of Natural Sands", Soils and Foundations, Vol.52, No.4, pp.712-722. https://doi.org/10.1016/j.sandf.2012.07.011
  18. Fredlund, M. D., Fredlund D. G., and Wilson, G. W. (2000), "An Equation to Represent Grain-size Distribution", Canadian Geotechnical Journal, Vol.37, No.4, pp.817-827. https://doi.org/10.1139/t00-015
  19. Guimaraes, M. (2002), "Crushed Stone Fines and Ion Removal from Clay Slurries - Fundamental Studies", PhD thesis, Georgia Institute of Technology.
  20. Jia, X. and Williams, R. A. (2001), "A Packing Algorithm for Particles of Arbitrary Shapes", Powder technology, Vol.120, No.3, pp.175-186. https://doi.org/10.1016/S0032-5910(01)00268-6
  21. Kim, K. Y., Suh, H. S., Yun, T. S., Moon, S. W., and Seo, Y. S. (2016), "Effect of Particle Shape on the Shear Strength of Fault Gouge", Geosciences Journal, pp.1-9.
  22. Krumbein, W. C. (1941), "Measurement and Geological Significance of Shape and Roundness of Sedimentary Particles", Journal of Sedimentary Research, Vol.11, No.2, pp.64-72.
  23. Krumbein, W. C. and Sloss, L. L. (1963), "Stratigraphy and sedimentation", W. H. Freeman and Company, San Francisco.
  24. Liao, L., Meneghini, R., Nowell, H. K., and Liu, G. (2013), "Scattering Computations of Snow Aggregates from Simple Geometrical Particle Models", IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing, Vol.6, No.3, pp.1409-1417. https://doi.org/10.1109/JSTARS.2013.2255262
  25. Matsushima, T., Katagiri, J., Uesugi, K., Tsuchiyama, A., and Nakano, T. (2009), "3D Shape Characterization and Image-based DEM Simulation of the Lunar Soil Simulant FJS-1", Journal of Aerospace Engineering, Vol.22, No.1, pp.15-23. https://doi.org/10.1061/(ASCE)0893-1321(2009)22:1(15)
  26. Miura, K., Maeda, K., Furukawa, M., and Toki, S. (1998), "Mechanical Characteristics of Sands with Different Primary Properties", Soils and foundations, Vol.38, No.4, pp.159-172. https://doi.org/10.3208/sandf.38.4_159
  27. Mora, P. and Place, D. (1998), "Numerical Simulation of Earthquake Faults with Gouge: Toward a Comprehensive Explanation for the Heat Flow Paradox", Journal of Geophysical Research: Solid Earth, Vol.103, No.B9, 21067-21089. https://doi.org/10.1029/98JB01490
  28. Pons, M. N., Vivier, H., and Dodds, J. (1997), "Particle Shape Characterization Using Morphological Descriptors", Particle & particle systems characterization, Vol.14, No.6, pp.272-277. https://doi.org/10.1002/ppsc.19970140603
  29. Roussilloln, T., Piegay, H., Sivignon, I., Tougne, L., and Lavigne, F. (2009), "Automatic Computation of Pebble Roundness Using Digital Imagery and Discrete Geometry", Computers & Geosciences, Vol.35, No.10, pp.1992-2000. https://doi.org/10.1016/j.cageo.2009.01.013
  30. Santamarina, J. C. and Cho, G. C. (2004), "Soil behaviour: The Role of Particle Shape", Proc., Advances in geotechnical engineering: The skempton conference, Thomas Telford, pp.604-617.
  31. Shin, H. and Santamarina, J. C. (2012), "Role of Particle Angularity on the Mechanical behavior of Granular Mixtures", Journal of Geotechnical and Geoenvironmental Engineering, Vol.139, No.2, pp.353-355.
  32. Simoni, A. and Houlsby, G. T. (2006), "The Direct Shear Strength and Dilatancy of Sand-gravel Mixtures", Geotechnical & Geological Engineering, Vol.24, No.3, pp.523-549. https://doi.org/10.1007/s10706-004-5832-6
  33. Suh, H. S., Han, E. S. H., Yun, T. S., and Kim, K. Y. (2014), "Evaluation of Shape Parameters for Rock Fragments by x-ray Computed Tomography and Image Processing", International Symposium-8th Asian Rock Mechanics Symposium, International Society for Rock Mechanics.
  34. Yasin, S. and Safiullah, M. (2013), "Effect of Particle Characteristics on the Strength and Volume Change behaviour of Sand", Journal of Civil Engineering, Vol.31, No.2, pp.127-148.
  35. Yun, T. S. and Santamarina, J. C. (2008), "Fundamental Study of Thermal Conduction in Dry Soils", Granular matter, Vol.10, No.3, pp.197-207. https://doi.org/10.1007/s10035-007-0051-5
  36. Wadell, H. (1932), "Volume, Shape, and Roundness of Rock Particles", The Journal of Geology, Vol.40, No.5, pp.443-451. https://doi.org/10.1086/623964
  37. Wadell, H. (1933), "Sphericity and Roundness of Rock Particles", The Journal of Geology, Vol.41, No.3, pp.310-331. https://doi.org/10.1086/624040
  38. Zunic, J. and Rosin, P. L. (2004), "A New Convexity Measure for Polygons", IEEE Transactions on Pattern Analysis and Machine Intelligence, Vol.26, No.7, pp.923-934. https://doi.org/10.1109/TPAMI.2004.19