Environmental Engineering Research

  • 제21권3호
  • /
  • Pages.233-240
  • /
  • 2016
  • /
  • 1226-1025(pISSN)
  • /
  • 2005-968X(eISSN)
대한환경공학회 (Korean Society of Environmental Engineers)
권호 표지
DOI QR코드

DOI QR Code

Study of different flexible aeration tube diffusers: Characterization and oxygen transfer performance

  • Hongprasith, Narapong (Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University) ;
  • Dolkittikul, Natchanok (Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University) ;
  • Apiboonsuwan, Kamolnapach (Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University) ;
  • Pungrasmi, Wiboonluk (Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University) ;
  • Painmanakul, Pisut (Department of Environmental Engineering, Faculty of Engineering, Chulalongkorn University)
  • 투고 : 2015.07.24
  • 심사 : 2016.04.08
  • 발행 : 2016.09.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

The research aims to study the different flexible rubber tube diffusers used in urban wastewater treatment processes and aquaculture systems. The experiment was conducted in small-scale aeration tank with different physical properties of the tubes that were used as aerators. The volumetric mass transfer coefficient ($k_La$), oxygen transfer efficiency (OTE) and aeration efficiency (AE) were measured and determined to compare the diffusers. Moreover, the bubble hydrodynamic parameters were analyzed in terms of bubble diameter ($d_B$) and rising velocity ($U_B$) by a high speed camera (2,000 frames/s). Then the interfacial area (a) and liquid-side mass transfer coefficient ($k_L$) can be calculated. The physical properties (tube wall thickness, tensile strength, orifice size, hardness and elongation) have been proven to be the key factor that controls the performance (kLa and OTE). The effects of hardness and elongation on bubble formation, orifice size and a-area were clearly proved. It is not necessary to generate too much fine bubbles to increase the a-area: this relates to high power consumption and the decrease of the kL. Finally, the wall thickness, elongation and hardness associated of the flexible tube diffuser (tube No. 12) were concluded, to be the suitable properties for practically producing, in this research.

키워드

참고문헌

  1. Low SL, Ong SL, Ng HY. Characterization of membrane fouling in submerged ceramic membrane photobioreactors fed with effluent from membrane bioreactors. Chem. Eng. J. 2016;290: 91-102. https://doi.org/10.1016/j.cej.2016.01.005
  2. Loubiere K, Hebrard G. Bubble formation from a flexible hole submerged in an inviscid liquid. Chem. Eng. Sci. 2003;58:135-148. https://doi.org/10.1016/S0009-2509(02)00468-2
  3. Hebrard G, Bastoul D, Roustan M. Influence of the gas spargers on the hydrodynamic behaviour of bubble columns. Trans. IchemE. 1996;74(A):406-414.
  4. Painmanakul P, Loubiere K, Hebrard G, Buffiere P. Study of different membrane spargers used in waste water treatment: characterisation and performance. Chem. Eng. Process. 2004;43: 1347-1359. https://doi.org/10.1016/j.cep.2003.09.009
  5. Rubber Research Institute of Thailand. Rubber Trends & Statistics. Department of Agriculture. Retrieved from http://www.rubberthai.com/statistic/stat_index.htm; 2016, March 14.
  6. Garrido-Baserba M, Asvapathanagul P, McCarthy GW, et al. Linking biofilm growth to fouling and aeration performance of fine-pore diffuser in activated sludge. Water Res. 2016;90: 317-328. https://doi.org/10.1016/j.watres.2015.12.011
  7. Hasanen A, Orivuori P, Aittamaa J. Measurements of local bubble size distributions from various flexible membrane diffusers. Chem. Eng. Process. 2006;45:291-302. https://doi.org/10.1016/j.cep.2005.09.003
  8. Painmanakul P, Loubiere K, Hebrard G, et al. Effects of surfactants on liquid-side mass transfer coefficients. Chem. Eng. Sci. 2005;60:6480-6491. https://doi.org/10.1016/j.ces.2005.04.053
  9. Grace JR, Wairegi T. Properties and Characteristics of drops and bubbles. Encyclopedia of Fluid Mechanics. Cheremisinoff. Chap 3, gulf Publishing Corporation, Huston; 1986. TX: 43-57.
  10. Calderbank PH, Moo-Young MB. The continuous phase heat and mass-transfer properties of dispersions. Chem. Eng. Sci. 1961;16:39-54. https://doi.org/10.1016/0009-2509(61)87005-X
  11. Treybal RE. Mass Transfer Operations. New York. McGraw-Hill; 1980.
  12. Moustiri S, Hebrard G, Thakre SS, Roustan M. A unified correlation for predicting liquid axial dispersion coefficient in bubble columns. Chem. Eng. Sci. 2001;56:1041-1047. https://doi.org/10.1016/S0009-2509(00)00320-1
  13. Painmanakul P, Wachirasak J, Jamnongwong M, Hebrard G. Theoretical Prediction of Volumetric Mass Transfer Coefficient (kLa) for Designing an Aeration Tank. Eng. J-Canada. 2009;13: 13-28.

피인용 문헌

  1. Development of modified airlift reactor (MALR) for improving oxygen transfer: optimize design and operation condition using ‘design of experiment’ methodology pp.1479-487X, 2020, https://doi.org/10.1080/09593330.2019.1579869