Fig. 1. Shelter installation of generator set
Fig. 2. Block diagram of generator set
Fig. 3. Flux-line of generator set
Fig. 4. Voltage curve of generator set(Full load)
Fig. 5. Current curve of generator set(Full load)
Fig. 6. Torque curve of generator set(Full load)
Fig. 7. Diagram of generator performance test
Fig. 8. Result of generator power factor measurement
Fig. 9. Measuring wave at generator out putperformance test
Fig. 10. Temperature profile of high & low temperature storage test
Fig. 11. Arrangement of high & low temperature operation test
Fig. 12. Temperature profile of high & low temperature operation test
Fig. 13. Arrangement of generator RE102 test
Fig. 14. Results of generator RE102 test
Table 1. Dimensions of generator set
Table 2. Result of generator performance analysis
Table 3. Result of generator performance test
Table 4. Result of generator efficiency test
Table 5. Results of generator voltage/frequency regulation test
Table 6. Result of generator transient response test
Table 7. Condition of generator environmental test
Table 8. EMC characteristic requirements
Table 9. Test results of electric field radiated susceptibility
Table 10. Specification of conducted susceptibility test
참고문헌
- J. Y. Lee, S. R. Moon, D. H. Koo, D. J. Bang, H. Polinder, "Electric Motor Design for A Portable Hand-operated Generator System," Proceedings of the KIEE 2010 Summer Annual Conference, pp. 872-873, 2010.
- "A Study on the Standardization Policy for the Military Batteries and Generators," DTaQ, 2010.
- Y. J. Jo, D. H. Lee, "A Design and Voltage Control of a High Efficiency Generator with PM Exciter," The Transaction of Korean Institute of Electrical Engineers, Vol. 65, No. 11, pp. 1827-1834, 2016. https://doi.org/10.5370/KIEE.2016.65.11.1827
- M. S. Jeong, C. J. Moon, Y. H. Chang, H. G. Kim, S. D. Kim, "A Study on Electrical Output of High Capacity of Permanent Magnet Synchronous Generator with High Quality," Proceedings of the KOSMEE 2013 Autumn Annual Conference, pp. 358-361, 2013.
- S. Hauang, J. Luo, "A General Approach to Sizing and Power Density Equations for Comparison of Electrical Machines," IEEE Trans. on Industry Applications, Vol. 34, No. 1, pp. 92-97, 1988.
- H. W. Jong, M. H. Kim, N. H. Kim, D. H. Kim, H. J. Song, "An Operating Characteristics of Surface Permanent Mount Synchronous Generator for 5-Phase 5 kW," Proceedings of the KIIEE 2012 Autumn Annual Conference, pp. 192-195, 2012.
- T. F. Chan, L. L. Lai, L. T. Yan, "Performance of a Three-phase AC Generator with inset NdFeB Permanent-magnet Rotor," IEEE Trans. on Energy Conversion, Vol. 19, No. 1, pp. 88-94, 2004. https://doi.org/10.1109/TEC.2003.821861
- I. H. Jee, S. J. Kang, "Design Analysis and Economic Analysis of High Efficiency 100 kW Generator for Hydro System," The Transactions of the Korean Institute of Electrical Engineers, Vol. 65. No. 3, 2016.
- M. K. Kim, Y. H. Kang, W. G. Park, "Study on the Thermal-fluid Analysis of Cryogenic Chamber for Cold Climate Test of Large Wind Turbine Parts," Journal of Computational Fluides Engineering, Vol. 20, No. 3, 2015.
- R. You, J. Chai, X. Sun, D. Bi, X. Wu, "Experimental Study on Frequency Support of Variable Speed Wind Turbine Based on Electromagnetic Coupler," Journal of Power Electronics, Vol. 18, No. 1, pp. 195-203, 2018. https://doi.org/10.6113/JPE.2018.18.1.195
- K. K. Park, H. C. Chin, K. T. Kim, H. T. Kim, J. Bong Kim, "Design of Wind Turbines for Reducing Interference to Radar Signals," The Journal of Korean Institute of Electromagnetic Engineering and Science, Vol. 23, No. 4, pp. 533-540. 2012. https://doi.org/10.5515/KJKIEES.2012.23.4.533
- S. K. Pang, J. H. Kim, "A Design Optimization on Coupling Joint between Exhaust Chimney of Electricity Generator and Electromagnetic Pulse Shield," The Journal of Korean Society for Energy, Vol. 24, No. 4, pp. 159-165, 2015.
- H. G. Kim, J. S. Kong, K. J. Kwon, J. H. Oh, T. Minoru, C. J. Moon, "A Study of 60 kW Permanent Magnet Synchronous Genrator for Wind Turbine," Proceedings of the KIEE 2014 Summer Annual Conference, pp. 743-744, 2014.
- Ansys Maxwell, 2000, Ansys, Inc.
- MIL-STD-810G, Department of Defense Test Method Standard : Environmental Engineering Considerations and Laboratory Tests, U.S. Department of Defense, Oct. 31, 2008.
- MIL-STD-461F, "Requirements for the Control of Electromagnetic Interference Characteristics of Subsystems and Equipment," U.S. Department of Defense, Dec. 10, 2007.